<dl id="fk805"><dfn id="fk805"><li id="fk805"></li></dfn></dl>
    • <em id="fk805"><th id="fk805"></th></em>
      <nobr id="fk805"><menu id="fk805"></menu></nobr>
      • 參數資料
        型號: LK2320-9ERD4
        元件分類: 電源模塊
        英文描述: 2-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
        封裝: HEAT SINK, METAL, CASE K02, MODULE
        文件頁數: 13/27頁
        文件大?。?/td> 640K
        代理商: LK2320-9ERD4
        Rugged Environment
        DC-DC Converters >100 W
        K-Family
        Edition 2/96 - Melcher AG
        8 - 21
        MELCHER
        The Power Partners.
        8.1
        Fig. 22
        Paralleling of single output units using option T with the
        sense lines connected at the load
        1 Leads should have equal length and cross sections and should
        run in the same cable loom.
        2 Diodes recommended in redundant operation only
        3 DC common point
        Load
        1
        2
        3
        Module
        S+
        Vo+
        Vo–
        S–
        Vi+/N
        Vi–/P
        T
        Module
        Vi+/N
        Vi–/P
        S+
        Vo+
        Vo–
        S–
        T
        1
        max. 5 units in parallel connection
        Option D Undervoltage monitor
        The input and/or output undervoltage monitoring circuit op-
        erates independently of the built-in input undervoltage lock-
        out circuit. A logic "low" (JFET output) or "high" signal (NPN
        output) is generated at pin 20 as soon as one of the moni-
        tored voltages drops below the preselected threshold level
        Ut. The return for this signal is Vo1–. The D output recovers
        when the monitored voltage(s) exceed(s)
        Ut + Uh. The
        Load
        max. 5 units in parallel connection
        +–
        Power bus
        Module
        Vo2+
        Vo1+
        Vo2–
        Vo1–
        Vi+/N
        Vi–/P
        T
        Module
        Vi+/N
        Vi–/P
        Vo2+
        Vo1+
        Vo2–
        Vo1–
        T
        Fig. 23
        Paralleling of double output units using option T
        threshold levels
        Uti and Uto are either adjustable by a
        potentiometer, accessible through a hole in the front cover,
        or factory adjusted to a fixed value specified by the cus-
        tomer.
        Option D exists in various versions D0...DD as shown in the
        following table.
        Table 15: Undervoltage monitor functions
        Output type
        Monitoring
        Minimum adjustment range
        Typical hysteresis
        Uh [% of Ut]
        JFET
        NPN
        U i
        Uo1
        of threshold level
        U t
        for
        U t min...U t max
        Uti
        Uto
        Uhi
        Uho
        D1
        D5
        no
        yes
        -
        3.5...40 V 1
        -
        2.5...0.6
        D2
        D6
        yes
        no
        Ui min...Ui max 1
        -
        3.4...0.4
        -
        D3
        D7
        yes
        Ui min...Ui max 1
        (0.95...0.985
        Uo1) 2
        3.4...0.4
        "0"
        D4
        D8
        no
        yes
        -
        (0.95...0.985
        Uo1) 2
        -
        "0"
        D0
        D9
        no
        yes
        -
        3.5...40 V 3
        -
        2.5...0.6
        yes
        no
        Ui min...Ui max 3 4
        -
        3.4...0.4
        -
        yes
        Ui min...Ui max 3 4
        3.5...40 V 3
        3.4...0.4
        2.5...0.6
        yes
        Ui min...Ui max 3 4
        (0.95...0.985
        Uo1) 2
        3.4...0.4
        "0"
        -
        DD
        yes
        Ui min...Ui max 1
        3.5...40 V 1
        3.4...0.4
        2.5...0.6
        1 Threshold level adjustable by potentiometer
        2 Fixed value tracking if Uo1 is adjusted via R-input, option P or sense lines.
        3 The threshold level permanently adjusted according to customer specification
        ±2 % at 25°C. Any value within the specified range is
        basically possible but causes a special type designation in addition to the standard option designations (D0/D9 respectively)!
        4 Adjusted at Io nom
        相關PDF資料
        PDF描述
        LK2320-9RD1B1 2-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
        LK2540-7PD3T 2-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
        LK2540-9EPD8T 2-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
        LK2540-9ERD6TB1 2-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
        LK2660-7PD9T 2-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
        相關代理商/技術參數
        參數描述
        LK23-LFR 制造商:FRONTIER 制造商全稱:Frontier Electronics. 功能描述:2A SURFACE MOUNT SCHOTTKY BARRIER RECTIFIERS
        LK245 制造商:TI 制造商全稱:Texas Instruments 功能描述:3.3-V ABT OCTAL BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
        LK24-LFR 制造商:FRONTIER 制造商全稱:Frontier Electronics. 功能描述:2A SURFACE MOUNT SCHOTTKY BARRIER RECTIFIERS
        LK2540-7P 制造商:Power-One 功能描述:- Bulk
        LK2540-7R 功能描述:線性和開關式電源 Euro-Cassette 150W (2x 15V) RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓(通道 1):20 V 輸出電流(通道 1):40 A 商用/醫用: 輸出電壓(通道 2): 輸出電流(通道 2): 安裝風格:Rack 長度: 寬度: 高度: