- 您現在的位置：買賣IC網 > PDF目錄358758 > LC700 (Electronic Theatre Controls, Inc.) Patient Care Unit Standard Laminate or Optional Terreon?? Lavatory Top PDF資料下載
參數資料
| 型號： | LC700 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Patient Care Unit Standard Laminate or Optional Terreon?? Lavatory Top |
| 中文描述： | 病人護理單位標準板或擇Terreon？？衛生間頂部 |
| 文件頁數： | 4/10頁 |
| 文件大?。?/td> | 196K |
| 代理商： | LC700 |
Patient Care Unit with Standard Laminate or Optional Terreon Top
LC700, LC750
Installation Instructions
4
8/16/04
Bradley Corporation
215-1171 Rev. D; EN 04-1037
Installation Instructions
continued . . .
Step 2: Install the anchors
NOTE FOR OPTIONAL FOOT
VALVE: It is recommended that
floor anchors be used to secure the
foot valve to the floor (anchors and
appropriate hardware supplied by
installer).
1. Select the location where the
patient care unit is to be
installed. Using the supplied
template, lay out the hole
pattern for the water closet
and cabinet anchor locations
(see Figure 4).
NOTE FOR OPTIONAL FOOT
VALVE: Use the foot valve as a
template and lay out the anchor
locations on the floor. Drill
appropriate holes for two anchors.
2. Using a 5/8" concrete drill bit, drill four 2-1/8"
deep holes into the water closet support
anchoring locations using the template (see
Figure 4). Holes must be clean and free of
debris.
3. Using a 3/8" concrete drill bit, drill four 1-1/8"
deep holes into the cabinet anchoring locations
using the template (see Figure 4). Holes must be
clean and free of debris.
NOTE: If the floor concrete is lightweight or less
than 4" thick, Bradley recommends through-bolting
to steel angles under the floor (hardware supplied by
installer) (see Figure 7 on page 5).
NOTE FOR OPTIONAL FOOT VALVE: Install
appropriate anchors into the floor for foot valve
anchoring.
4. Remove the template. Drive the four 2-1/8"
anchors provided into the drilled holes for the
water closet using a hammer and the setting tool
supplied. The anchor should be driven in flush
with the floor (see Figure 5).
5. Drive the four 1/8" anchors provided into the
drilled holes for the cabinet using a hammer and
the setting tool. Make sure the anchors are
driven in flush with the floor (see Figure 6).
Figure 4
Figure 5
Figure 6
相關PDF資料 |
PDF描述 |
|---|---|
| LC7020AK | Controller for PLL Frequency Synthesizer |
| LC7020AT | Controller for PLL Frequency Synthesizer |
| LC7020BK | Controller for PLL Frequency Synthesizer |
| LC7020BT | Controller for PLL Frequency Synthesizer |
| LC7040N | ID LOGIC interface with PLL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC700Z | 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:GREEN OVAL LAMP LED |
| LC701 | 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:BLUE OVAL LAMP LED |
| LC7010 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Consumer IC |
| LC70200C-W1 | 制造商:ON Semiconductor 功能描述:DIGITAL ECM ICS - Bulk |
| LC70200NC-W1 | 制造商:ON Semiconductor 功能描述:DIGITAL ECM ICS - Bulk |
發布緊急采購，3分鐘左右您將得到回復。