- 您現在的位置：買賣IC網 > PDF目錄358756 > LC573010A (Sanyo Electric Co.,Ltd.) 4-bit Single Chip Microcontroller(4位單片微控制器) PDF資料下載
參數資料
| 型號： | LC573010A |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | 4-bit Single Chip Microcontroller(4位單片微控制器) |
| 中文描述： | 4位單片微控制器（4位單片微控制器） |
| 文件頁數： | 2/12頁 |
| 文件大?。?/td> | 154K |
| 代理商： | LC573010A |
Port
– Input port (S port, M port) :
– Input/Output port
P0 port, P1 port
P2 port
2-port (8 pins)
3-port (10 pins)
2-port (8 pins)
1-port (2 pins)
[Key scan input port]
:
[Key scan output port]
[Key scan expansion port]
[LED direct drivable port]
Infrared remote control carrier generation circuit
– Software-controllable remote control carrier output ON/OFF.
– Software-controllable carrier frequency and duty ratio.
<38 kHz-1/3 duty, 38 kHz-1/2 duty, 57 kHz-1/2 duty>
(When fixed carrier signal is output, it is specified by mask option)
– 1 kHz to 200 kHz infrared remote control transmission carrier frequency.
(When carrier output is selected by timer at mask option, and when 455 kHz CR oscillator is used)
– Infrared carrier output-dedicated terminal built-in (CA terminal).
– 108 ms HALT-mode cancel signal output.
Timer
– 16-bit software-controllable timer
Timer input clock : Ceramic (CR) oscillation frequency (455 kHz)
– 108 ms HALT release request signal generation timer (Free running timer)
– Watchdog timer (changed over between USED/UNUSED by mask option)
Sub-routine stack level
– 2 levels
Oscillation circuit
– Ceramic (CR) oscillation circuit : 455 kHz (for System clock generation), feedback resistor built-in.
Standby function
– HALT mode
HALT mode used to reduce current drain.
HALT mode suspends program execution.
Following shows how to release the HALT mode.
(A) System reset
(B) HALT mode release request signal
– HOLD mode
HOLD mode stops ceramic resonator (CR). The HOLD mode can be released in two ways.
(A) System reset
(B) Apply H level input to S port pin or M port pin. (However, it is necessary to set S port or M port HOLD mode
release permission flag beforehand.)
Form of shipment
– MFP-24S (1.0 mm pitch)
Note : When dipping in solder to mount the MFP package on board, contact SANYO for instructions.
No. 5899-2/12
LC573010A, 573015A
相關PDF資料 |
PDF描述 |
|---|---|
| LC573102A | 4-bit Single Chip Microcontroller |
| LC573202A | 4-Bit Microcontroller with 2K-Byte ROM, 64 】 4Bits RAM and LCD Driver |
| LC5732N | 4-Bit Microcomputer with LCD Driver |
| LC5732 | 4-Bit Microcomputer with LCD Driver |
| LC5733 | SINGLE-CHIP 4-BIT MICROCOMPUTER WITH LCD DRIVERS FOR LOW-VOLTAGE,LOW-POWER USE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC573010A/573015A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4-Bit Single Chip Microcontroller |
| LC573015A | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:4-bit Single Chip Microcontroller |
| LC573102A | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:4-bit Single Chip Microcontroller |
| LC573104A | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:4-bit Single Chip Microcontroller |
| LC5732 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:4-Bit Microcomputer with LCD Driver |
發布緊急采購，3分鐘左右您將得到回復。