
2-5 Reset pin (Pin 11)
When the reset pin is open, peak hold of D8 to D12 occurs. When the reset pin is connected to GND, reset occurs.
Connecting the reset pin to GND causes no peak hold.
2-6 C1, R1
The oscillation cycle of oscillator depends on the product of C1 and R1. The oscillation cycle at C1 = 2.2 μF, R1 =
1 M
is approximately 2 seconds. However, if an electrolytic capacitor is used for C1, the actual capacitance differs
from the marked value.
2-7 Reduction in number of parts
R3, R4, VR1 are substituted by one VR.
Unit (resistance:
, capacitance: F)
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment,
nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or
indirectly cause injury, death or property loss.
Anyone purchasing any products described or contained herein for an above-mentioned use shall:
1
Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors
and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and
expenses associated with such use:
2
Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO
ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume
production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use
or any infringements of intellectual property rights or other rights of third parties.
This catalog provides information as of May, 1996. Specifications and information herein are subject to change without notice.
LB1412
No.1218-5/5