- 您現在的位置：買賣IC網 > PDF目錄358725 > LA1136N (Sanyo Electric Co.,Ltd.) AM Tuners for Car Radios and Home Stereos(應用于車載電臺和家庭立體聲的AM調諧器) PDF資料下載
參數資料
| 型號： | LA1136N |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | AM Tuners for Car Radios and Home Stereos(應用于車載電臺和家庭立體聲的AM調諧器) |
| 中文描述： | 上午車用收音機調諧器和家庭影院（應用于車載電臺和家庭立體聲的上午調諧器） |
| 文件頁數： | 22/28頁 |
| 文件大?。?/td> | 573K |
| 代理商： | LA1136N |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁
17. Preventing Incorrect RF AGC time-constant switching, Seek Operation
These tuners incorporate various circuits that serve to prevent incorrect stops during seek operation. A summary of the RF
amplifiers is provided below.
(1) Incorrect stops during RF AGC, and other problems
1
The RF AGC response time can cause incorrect seek and stop operation when moving from a weak-signal station to a
strong-signal station. When seek operation starts from a strong station, the tuner can overshoot an adjacent weak station if
the AGC time constant is too high.
2
If the wideband AGC ON level is too high, the varactor diodes can generate cross-modulation distortion causing incorrect
seek operation.
3
Input FETs with high I
DSS
, required for correct seek and stop operation, are difficult to drive.
(2) Countermeasures
Countermeasure for problem
1
:
When the input signal goes from a strong to a weak station, the detector generates a pulse as shown in the figure below. The
AGC capacitor C1 is charged rapidly for the duration of this pulse. It also reduces the AGC time constant during charging to
one-third of its normal value.
Countermeasure for problem
2
:
The wideband AGC ON level should be raised as far as practicable within cross-modulation disrtortion and sensitivity
constraints. If a pin-diode is used, the sensitivity is not suppressed even if the AGC ON level is increased considerably.
However, if the varactor diodes in the RF input circuit are exposed to strong interference signals of any frequency, the
resulting non-lincarity can cause seek and stop operation errors.
Previous devices used the same S-meter linearity for both seek and stop operations, where the linearity was extended to
100 dBμ by the IF AGC and RF AGC. When the wideband RF AGC operated, the S-meter signal was amplified causing
incorrect stop operation. For example, modulation sidebands could stop the tuner one station too early.
The S-meter linearity has now been restricted to approximately 60 dBμ minimum during the seek and stop operations for
LA1136N and LA1137N. When the RF AGC operates during seek operation, the S-meter signal amplifier is disabled. This
reduces the potential for tuning error when using the stop detector method (such as LM7001, etc.).
Countermeasure for problem
3
:
For LA1137N, a transistor and base current supply circuit (200 μA maximum) have been incorporated into a cascade AGC
configuration to simplify the use of high I
DSS
FETs. An external resistor is required.
Note that V
AGC–0
= 6.1 V for no input signal. Also, V
CC
should be chosen carefully since it affects both the dynamic range
and the sensitivity.
Ccircuit
C
D
Charging
circuit
Resistor added
Large I
DSS
LA1136N, 1136NM, 1137N, 1137NM
No. 3507-22/28
相關PDF資料 |
PDF描述 |
|---|---|
| LA1140 | FM IF System for Car Radio |
| LA1143 | FM IF System for Car Radios |
| LA1145 | FM IF System (Quadrature Detector) for Car Radio |
| LA1145M | FM IF System (Quadrature Detector) for Car Radio |
| LA1150N | FM IF Amplifier for Car Radio |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LA1136NM | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:AM Tuners for Car Radios and Home Stereos |
| LA1137 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:AM Tuners for Car Radios and Home Stereos |
| LA1137M | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| LA1137N | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:AM Tuners for Car Radios and Home Stereos |
| LA1137NM | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:AM Tuners for Car Radios and Home Stereos |
發布緊急采購，3分鐘左右您將得到回復。