參數資料
型號: L93PI
廠商: 意法半導體
英文描述: Quad Low Side Driver(四路低邊驅動器)
中文描述: 四低側驅動器(四路低邊驅動器)
文件頁數: 5/8頁
文件大?。?/td> 90K
代理商: L93PI
CIRCUIT DESCRIPTION
The L93PI is a quad low side driver for lines,
lamps or inductive loads in automotive and indus-
trial applications.
All INputs are TTL or CMOS compatible. This al-
lows the device to be driven directly by a micro-
controller. For the noise immunity, all inputs have
a Schmitt-trigger with a hysteresis of typ. 100mV.
Each input stage has an input voltage protection
from -24V to 10V. The device can be activated
with a ’high’ signal on ENable input. ENable ’low’
switches the device into the sleep mode. In this
mode the quiescent current is less than 10
μ
A. A
high signal on PRoGramming input changes the
signal transfer polarity from noninverting into the
inverting mode. Normally this pin is connected to
V
S
or GND. These pins (PRG and EN) are inter-
nally fixed at low status by open input condition.
Independent of the PRoGramming input, the
OUTput switches off, if the signal INput pin is not
connected.
Each output driver has a current limitation of min
0.4A and a seperate thermal shut-down. The ther-
mal shut-down deactivates that output which ex-
ceeds Temperature switch off level. About 20K
below this temperature threshold the output will
be activated again. This means, that each output
is able to sink continuously 285mA without acti-
vating thermal shut-down at 85°C ambient tem-
perature (SO20). The slew rate of the output is
limited to max. 14V/
μ
s to reduce the electromag-
netic interference, but not for the enable transfer
characteristic (see fig. 1). An integrated active fly-
back voltage limitation clamps the output voltage
during the flyback phase of inductive loads to typ.
50V. The power DMOS switches ON, if the device
is enabled and the OUTput swings below ground.
This protection avoids the activation of parasitics
inside the power DMOS.
The DIAGnostic is an open drain output. The logic
status depends on the PRoGramming pin. If the
PRG pin is ’low’ the DIAG output becomes low, if
the device works correctly.
At thermal shut-down of one channel, discon-
nected ground or supply voltage the DIAGnostic
output becomes high. If the PRG pin is ’high’ this
output is switched off at normal function and
switched on at overtemperature.
DIAGNOSTIC TABLE
Pins
EN
PRG
IN
OUT
DIAG
Normal function
H
H
H
H
L
H
L
L
H
H
X
L
L
H
L
H
X
X
L (on)
H (off)
H (off)
L (on)
H (off)
H (off) *
L (on)
L (on)
H(off)
H(off)
H(off)
H (off)
Overtemperature, dis-
connected ground or
supply voltage
Overtemperature
H
H
X
H (off) *
L (on)
X = not relevant * selective for each channel at overtemperature
L93PI
5/8
相關PDF資料
PDF描述
L9407F CAR ALTERNATOR VOLTAGE REGULATOR
L9444 ONE CHIP CAR ALTERNATOR REGULATOR
L9444VB ONE CHIP CAR ALTERNATOR REGULATOR
L9448VB One Chip Car Alternator Regulator(單片汽車交流發電機穩壓器)
L9480VB One Chip Car Alternator Regulator(單片汽車交流發電機穩壓器)
相關代理商/技術參數
參數描述
L-93WEGC 功能描述:標準LED-通孔 RED/GREEN WTR CLR 3-LEAD RoHS:否 制造商:Vishay Semiconductors 照明顏色:Red 光強度:0.7 mcd 波長/色溫:615 nm 顯示角:45 deg 透鏡顏色/類型:Clear, Non-Diffused 正向電流:70 mA 正向電壓:1.83 V to 3.03 V LED 大小:2 mm 系列: 封裝:Tube
L93WEGW 制造商:Kingbright Corporation 功能描述:LED Bi-Color Green/Red 565nm/625nm 3-Pin T-1
L-93WEGW 功能描述:標準LED-通孔 USE 604-WP93WEGW 3-LEAD RoHS:否 制造商:Vishay Semiconductors 照明顏色:Red 光強度:0.7 mcd 波長/色溫:615 nm 顯示角:45 deg 透鏡顏色/類型:Clear, Non-Diffused 正向電流:70 mA 正向電壓:1.83 V to 3.03 V LED 大小:2 mm 系列: 封裝:Tube
L-93WEGW 制造商:Kingbright Corporation 功能描述:LED 3MM HE-RED/GRN
L-93WEGW-TNR2.54 制造商:Kingbright Corporation 功能描述: