參數資料
型號: L9216A
英文描述: CAP CER 270PF 3.15KVDC R3 RAD
中文描述: 短環振鈴用戶接口與地面開始
文件頁數: 11/48頁
文件大?。?/td> 1062K
代理商: L9216A
Preliminary Data Sheet
September 2001
Short-Loop Ringing SLIC with Ground Start
L9216A/G
Agere Systems Inc.
11
State Definitions
Forward Active
I
Pin PT is positive with respect to PR.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 3.14 dBm into 900
.
Reverse Active
I
Pin PR is positive with respect to PT.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 3.14 dBm into 900
.
Scan
I
Except for loop closure, all circuits (including ring trip
and common-mode detector) are powered down.
I
On-hook transmission is disabled.
I
Pin PT is positive with respect to PR, and V
BAT1
is
applied to tip/ring.
I
The tip to ring on-hook differential voltage will be typ-
icallybetween –44 V and –51 V with a –70 V primary
battery.
On-Hook Transmission
Forward Battery
I
Pin PT is positive with respect to PR.
I
V
BAT1
is applied to tip/ring drive amplifiers.
I
Supervision circuits, loop closure, and common-
mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is allowed.
I
The tip-to-ring on-hook differential voltage will be typ-
ically between –41 V and –49 V with a –70 V primary
battery.
On-Hook Transmission
Reverse Battery
I
Pin PR is positive with respect to PT.
I
V
BAT1
is applied to tip/ring drive amplifiers.
I
Supervision circuits, loop closure, and common-
mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is allowed.
I
The tip-to-ring on-hook differential voltage will be typ-
ically between –41 V and –49 V with a –70 V primary
battery.
Disconnect
I
The tip/ring amplifiers and all supervision are turned
off.
I
The SLIC goes into a high-impedance state.
I
NSTAT is forced high (on-hook).
I
Device will power up in this state.
Ring
I
Power ring signal is applied to tip and ring.
I
Input waveform at RING
IN
is amplified.
I
Ring trip supervision and common-mode current
supervision are active; loop closure is inactive.
I
Overhead voltage is reduced to typically 4 V.
I
Current is limited by saturation current of the amplifi-
ers themselves, typically 100 mA at 125 °C.
Ground Start
I
Tip drive amplifer is turned off.
I
Device presents a high impedance (>100 k
) to pin
PT.
I
Device presents a clamped (<56.5 V) current-limited
battery (V
BAT1
) to PR.
I
Output pin RGDET indicates current flowing in the
ring lead.
Thermal Shutdown
I
Not controlled via truth table inputs.
I
NSTAT is forced low (off-hook) during this state.
I
This mode is caused by excessive heating of the
device, such as may be encountered in an extended
power cross situation.
相關PDF資料
PDF描述
L9217A CAP CER 2700PF 3.15KVDC R3 RAD
L9218A CAP CER 330PF 3.15KVDC R3 RAD
L9219A CAP CER 390PF 3.15KVDC R3 RAD
L9310 Line Interface and Line Access Circuit Full-Feature SLIC,Ringing Relay,and Test Access Device
L9311 Line Interface and Line Access Circuit Full-Feature SLIC with High Longitudinal Balance, Ringing Relay,and GR-909 Test Access
相關代理商/技術參數
參數描述
L9217A 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface with Reverse Battery and PPM
L9218A 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface
L9219A 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface with Reverse Battery and Dual Current Limit
L9222 功能描述:功率驅動器IC Quad Inv Tran Switch RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
L9222_04 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:QUAD INVERTING TRANSISTOR SWITCH