- 您現在的位置：買賣IC網 > PDF目錄384587 > L9215G (Lineage Power) Short-Loop Sine Wave Ringing SLIC(短環路正弦波振鈴用戶接口（SLIC）) PDF資料下載
參數資料
| 型號： | L9215G |
| 廠商： | Lineage Power |
| 英文描述： | Short-Loop Sine Wave Ringing SLIC(短環路正弦波振鈴用戶接口（SLIC）) |
| 中文描述： | 短回路正弦波振鈴用戶接口（短環路正弦波振鈴用戶接口電路（SLIC）） |
| 文件頁數： | 11/46頁 |
| 文件大?。?/td> | 1165K |
| 代理商： | L9215G |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
Advance Data Sheet
October 2000
Short-Loop Sine Wave Ringing SLIC
L9215A/G
Lucent Technologies Inc.
11
State Definitions
Forward Active
I
Pin PT is positive with respect to PR.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure, and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
PPM input is off.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 0 dBm into 600
and may be
increased via OVH.
Reverse Active
I
Pin PR is positive with respect to PT.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure, and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
PPM input is off.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 0 dBm into 600
and may be
increased via OVH.
Forward Active with PPM
I
Pin PT is positive with respect to PR.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
PPM input is on.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 0 dBm into 600
and may be
increased via OVH to accommodate higher-voltage
meter pulse signals.
Reverse Active with PPM
I
Pin PR is positive with respect to PT.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure, and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
PPM input is on.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 0 dBm into 600
and may be
increased via OVH to accommodate higher-voltage
meter pulse signals.
Scan
I
Except for loop closure, all circuits (including ring trip
and common-mode detector) are powered down.
I
On-hook transmission is disabled.
I
Pin PT is positive with respect to PR and V
BAT1
is
applied to tip/ring.
I
The tip to ring on-hook differential voltage will be
between –44 V and –51 V with a –70 V primary bat-
tery.
On-Hook Transmission
—
Forward Battery
I
Pin PT is positive with respect to PR.
I
V
BAT1
is applied to tip/ring drive amplifiers.
I
Supervision circuits, loop closure, and common-
mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is allowed.
I
The tip to ring on-hook differential voltage will be
between –41 V and –49 V with a –70 V primary bat-
tery.
I
PPM is off.
相關PDF資料 |
PDF描述 |
|---|---|
| L9215A | Short-Loop Sine Wave Ringing SLIC(短環路正弦波振鈴用戶接口（SLIC）) |
| L9216A | Short-Loop Ringing SLIC with Ground Start(接地起動的短環路振鈴用戶接口) |
| L9216G | Short-Loop Ringing SLIC with Ground Start(接地起動的短環路振鈴用戶接口) |
| L9219A | Low-Cost Line Interface with Reverse Battery and Dual Current Limit(帶反相電池和雙電流限制的低價格線接口) |
| L9219G | Low-Cost Line Interface with Reverse Battery and Dual Current Limit(帶反相電池和雙電流限制的低價格線接口) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L9216A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Ringing SLIC with Ground Start |
| L9217A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface with Reverse Battery and PPM |
| L9218A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface |
| L9219A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface with Reverse Battery and Dual Current Limit |
| L9222 | 功能描述:功率驅動器IC Quad Inv Tran Switch RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。