- 您現在的位置：買賣IC網 > PDF目錄43901 > L6995D (STMICROELECTRONICS) SWITCHING CONTROLLER, 270 kHz SWITCHING FREQ-MAX, PDSO20 PDF資料下載
參數資料
| 型號： | L6995D |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 270 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封裝： | MO-153-AC, TSSOP-20 |
| 文件頁數： | 25/25頁 |
| 文件大小： | 674K |
| 代理商： | L6995D |
9/25
L6995
ductor value is, the smaller the threshold is. On the other hand, the bigger the inductor value is, the slower the
transient response is. In PFM mode the frequency changes, with the output current changing, more than in
PWM mode; in fact if the output current increase, the output voltage decreases more quickly; so the successive
turn-on arrives before, increasing the switching frequency. The PFM waveforms may appear more noisy and
asynchronous than normal operation, but this is normal behaviour mainly due to the very low load. If the PFM
is not compatible with the application it can be disabled connecting to VCC the NOSKIP pin.
1.4 Softstart
If the supply voltages are already applied, the SHDN pin gives the start-up. The system starts with the high side
MOSFET off and the low side MOSFET on. After the SHDN pin is turned on the SS pin voltage begins to in-
crease and the system starts to switch. The softstart is realized by gradually increasing the current limit thresh-
old to avoid output overvoltage. The active soft start range for the VSS voltage (where the output current limit
increase linearly) starts from 0.6V to 1.5V. In this range an internal current source (5
A Typ) charges the ca-
pacitor on the SS pin; the reference current (for the current limit comparator) forced through ILIM pin is propor-
tional to SS pin voltage and it saturates at 5
A (Typ.) when SS voltage is close to 1.5V and the maximum current
limit is active. Undervoltage protection is disabled until SS pin voltage reaches 1.5V; instead the overvoltage is
always present (see figure 5).
Once the SS pin voltage reaches the 1.5V value, the voltage on SS pin doesn't impact the system operation
anymore. If the SHDN pin is turned on before the supplies, the correct start-up sequence is the following: first
turn-on the power section and after the logic section (VCC pin).
Figure 5. Soft -Start Diagram
Because the system implements the soft start controlling the inductor current, the soft start capacitor selection
is function of the output capacitance, the current limit and the soft start active range (
VSS).
In order to select the softstart capacitor it must be imposed that the output voltage reaches the final value before
the soft start voltage reaches the under voltage value (1.5V). In other words the output voltage charging time
has to be lower than the uvp time.
The UVP time is given by:
Eq 7
In order to calculate the output volatge chargin time it should be calculated, before, the output volatrge function
versus time. This function can be calculated from the inductor current function; the inductor current function can
Time
0.6V
Maximum current limit
Soft-start active range
5
A
4.1V
1.5V
Ilim current
Vss
T
uvp CSS
()
V
uvp
Iss
------------ C
SS
=
相關PDF資料 |
PDF描述 |
|---|---|
| L6995STR | SWITCHING CONTROLLER, PDSO20 |
| L6997D | SWITCHING CONTROLLER, PDSO20 |
| L6997DTR | SWITCHING CONTROLLER, PDSO20 |
| L7200 | DISK DRIVE MOTOR CONTROLLER, 2.6 A, PQFP64 |
| L7250 | VOICE COIL MOTOR CONTROLLER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6995DTR | 功能描述:DC/DC 開關控制器 1.5 to 28V Step-Down RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L6995STR | 功能描述:DC/DC 開關控制器 1.5 to 28V Step-Down RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L6996 | 功能描述:DC/DC 開關控制器 Step-Down Contrllr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L6996-1 | 制造商:Johanson 功能描述:TUNING ROTOR |
| L6996-13 | 制造商:Johanson Manufacturing 功能描述:TUNING ELEMENT |
發布緊急采購，3分鐘左右您將得到回復。