- 您現在的位置：買賣IC網 > PDF目錄43901 > L6928D (STMICROELECTRONICS) 1.65 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | L6928D |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.65 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 3 MM, LEAD FREE, MSOP-8 |
| 文件頁數： | 15/16頁 |
| 文件大?。?/td> | 268K |
| 代理商： | L6928D |
Operation description
L6928
8/16
4.1
Modes of operation
Depending on the SYNC pin value the device can operate in low consumption or low noise
mode. If the SYNC pin is high (higher than 1.3V) the low consumption mode is selected
while the low noise mode is selected if the SYNC pin is low (lower than 0.5V).
4.1.1
Low consumption mode
In this mode of operation, at light load, the device operates discontinuously based on the
COMP pin voltage, in order to keep the efficiency very high also in these conditions. While
the device is not switching the load discharges the output capacitor and the output voltage
goes down. When the feedback voltage goes lower than the internal reference, the COMP
pin voltage increases and when an internal threshold is reached, the device starts to switch.
In these conditions the peak current limit is set approximately in the range of 200mA-
400mA, depending on the slope compensation (see related section).
Once the device starts to switch the output capacitor is recharged. The feedback pin
increases and, when it reaches a value slightly higher than the reference voltage, the output
of the error amplifier goes down until a clamp is activated. At this point, the device stops to
switch. In this phase, most of the internal circuitries are off, so reducing the device
consumption down to a typical value of 25
A.
4.1.2
Low noise mode
If for noise reasons, the very low frequencies of the low consumption mode are undesirable,
the low noise mode can be selected. In low noise mode, the efficiency is a little bit lower
compared with the low consumption mode in very light load conditions but for medium-high
load currents the efficiency values are very similar.
Basically, the device switches with its internal free running frequency of 1.4MHz. Obviously,
in very light load conditions, the device could skip some cycles in order to keep the output
voltage in regulation.
4.1.3
Synchronization
The device can also be synchronized with an external signal from 1MHz up to 2MHz.
In this case the low noise mode is automatically selected. The device will eventually skip
some cycles in very light load conditions.
The internal synchronization circuit is inhibited in shortcircuit and overvoltage conditions in
order to keep the protections effective (see relative sections).
相關PDF資料 |
PDF描述 |
|---|---|
| L6928TR | 1.65 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, PDSO8 |
| L6995D | SWITCHING CONTROLLER, 270 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6995STR | SWITCHING CONTROLLER, PDSO20 |
| L6997D | SWITCHING CONTROLLER, PDSO20 |
| L6997DTR | SWITCHING CONTROLLER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6928D013TR | 功能描述:直流/直流開關調節器 2.0 to 5.5V Step-Dwn RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| L6928Q1 | 功能描述:直流/直流開關調節器 Hi EFFICIENCY MONOLITHIC SYNC RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| L6928Q1TR | 功能描述:直流/直流開關調節器 HIGH EFFICIENCY MONO LITHIC SYNCHRONOUS RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| L6928TQ1TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:High efficiency monolithic synchronous step down regulator |
| L6928TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:High efficiency monolithic synchronous step down regulator |
發布緊急采購，3分鐘左右您將得到回復。