- 您現在的位置：買賣IC網 > PDF目錄384585 > L6599D (意法半導體) High-voltage resonant controller PDF資料下載
參數資料
| 型號： | L6599D |
| 廠商： | 意法半導體 |
| 英文描述： | High-voltage resonant controller |
| 中文描述： | 高壓諧振控制器 |
| 文件頁數： | 18/36頁 |
| 文件大?。?/td> | 591K |
| 代理商： | L6599D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
Application information
L6599
18/36
7.2
Operation at no load or very light load
When the resonant half-bridge is lightly loaded or unloaded at all, its switching frequency will
be at its maximum value. To keep the output voltage under control in these conditions and to
avoid losing soft-switching, there must be some significant residual current flowing through
the transformer's magnetizing inductance. This current, however, produces some
associated losses that prevent converter's no-load consumption from achieving very low
values.
To overcome this issue, the L6599 enables the designer to make the converter operate
intermittently (burst-mode operation), with a series of a few switching cycles spaced out by
long idle periods where both MOSFETs are in OFF-state, so that the average switching
frequency can be substantially reduced. As a result, the average value of the residual
magnetizing current and the associated losses will be considerably cut down, thus
facilitating the converter to comply with energy saving recommendations.
The device can be operated in burst-mode by using pin 5 (STBY): if the voltage applied to
this pin falls below 1.25V the IC will enter an idle state where both gate-drive outputs are
low, the oscillator is stopped, the soft-start capacitor C
SS
keeps its charge and only the 2V
reference at RF
min
pin stays alive to minimize IC's consumption and V
CC
capacitor's
discharge. The IC will resume normal operation as the voltage on the pin exceeds 1.25V by
50mV.
To implement burst-mode operation the voltage applied to the STBY pin needs to be related
to the feedback loop.
Figure 23
shows the simplest implementation, suitable with a narrow
input voltage range (e.g. when there is a PFC front-end).
Figure 23. Burst-mode implementation: narrow input voltage range.
Figure 24. Burst-mode implementation: wide input voltage range.
L6599
STBY
4
5
RFmin
R
Fmin
R
Fmax
R
Fmin
R
Fmax
L6599
L6599
STBY
4
5
RFmin
R
Fmin
R
Fmax
7
LINE
R
A
B+
R
B
R
C
RD
R
D
RC
R
A
+ R
B
>> R
C
相關PDF資料 |
PDF描述 |
|---|---|
| L6599N | High-voltage resonant controller |
| L6599TR | High-voltage resonant controller |
| L6701 | 3 Phase Controller for VR10, VR9 and K8 CPUs |
| L6701TR | 3 Phase Controller for VR10, VR9 and K8 CPUs |
| L6711 | 3 PHASE CONTROLLER WITH DYNAMIC VID AND SELECTABLE DACs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6599DTR | 功能描述:軟開關 PWM 控制器 Hi Vltg resonant Controller RoHS:否 制造商:Fairchild Semiconductor 輸出端數量: 輸出電流: 開關頻率: 工作電源電壓:30 V 電源電流: 最大工作溫度:+ 105 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| L6599N | 功能描述:軟開關 PWM 控制器 Hi Vltg resonant Controller RoHS:否 制造商:Fairchild Semiconductor 輸出端數量: 輸出電流: 開關頻率: 工作電源電壓:30 V 電源電流: 最大工作溫度:+ 105 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| L6599NR | 功能描述:電壓模式 PWM 控制器 HV resonant CNTRL RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| L6599TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:High-voltage resonant controller |
| L65B | 制造商:Electro-Mech 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。