- 您現在的位置：買賣IC網 > PDF目錄43898 > L4962/A (STMICROELECTRONICS) 3.3 A SWITCHING REGULATOR, 150 kHz SWITCHING FREQ-MAX, PDIP16 PDF資料下載
參數資料
| 型號： | L4962/A |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | 3.3 A SWITCHING REGULATOR, 150 kHz SWITCHING FREQ-MAX, PDIP16 |
| 封裝： | POWER, PLASTIC, DIP-16 |
| 文件頁數： | 12/16頁 |
| 文件大?。?/td> | 461K |
| 代理商： | L4962/A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁
CIRCUIT OPERATION (refer to the block diagram)
The L4962 is a monolithic stepdown switching regu-
lator providing output voltages from 5.1V to 40V and
delivering 1.5A.
The regulation loop consists of a sawtooth oscilla-
tor, error amplifier, comparator and the output
stage. An error signal is produced by comparing the
output voltage with a precise 5.1V on-chip refer-
ence (zener zap trimmed to
± 2%).
This error signal is then compared with the sawtooth
signal to generate the fixed frequency pulse width
modulated pulses which drive the output stage.
The gain and frequency stability of the loop can be
adjusted by an external RC network connected to
pin 11. Closing the loop directly gives an output
voltage of 5.1V. Higher voltages are obtained by
inserting a voltage divider.
Output overcurrents at switch on are prevented by
the soft start function. The error amplifier output is
initially clamped by the external capacitor Css and
allowed to rise, linearly, as this capacitor is charged
by a constant current source. Output overload pro-
tection is provided in the form of a current limiter.
The load current is sensed by an internal metal
resistor connected to a comparator. When the load
current exceeds a preset threshold this comparator
sets a flip flop which disables the output stage and
discharges the soft start capacitor. A second com-
parator resets the flip flop when the voltage across
the soft start capacitor has fallen to 0.4V.
The output stage is thus re-enabled and the output
voltage rises under control of the soft start network.
If the overload condition is still present the limiter
will trigger again when the threshold current is
reached. The average short circuit current is limited
to a safe value by the dead time introduced by the
soft start network. The thermal overload circuit dis-
ables circuit operation when the junction tempera-
ture reaches about 150
°C and has hysteresis to
prevent unstable conditions.
Figure 1. Soft start waveforms
Figure 2. Current limiter waveforms
5/16
L4962
相關PDF資料 |
PDF描述 |
|---|---|
| L4963D013TR | 6.5 A SWITCHING REGULATOR, 83 kHz SWITCHING FREQ-MAX, PDSO20 |
| L4963D | 6.5 A SWITCHING REGULATOR, 83 kHz SWITCHING FREQ-MAX, PDSO20 |
| L4964 | 4 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM15 |
| L4972AD | 3.5 A SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDSO20 |
| L4972AD013TR | 3.5 A SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L4962A | 制造商:STMicroelectronics 功能描述:IC SWITCHING REG 1.5A 4962 |
| L4962E | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1.5A POWER SWITCHING REGULATOR |
| L4962E/A | 功能描述:直流/直流開關調節器 5.0 to 40V Step-Down RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| L4962EH | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1.5A POWER SWITCHING REGULATOR |
| L4962EH/A | 功能描述:直流/直流開關調節器 5.0 to 40V Step-Down RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。