- 您現在的位置：買賣IC網 > PDF目錄373177 > KS16121 (SAMSUNG SEMICONDUCTOR CO. LTD.) DSP for Digital Answering Phone(用于數字應答電話的DSP) PDF資料下載
參數資料
| 型號： | KS16121 |
| 廠商： | SAMSUNG SEMICONDUCTOR CO. LTD. |
| 英文描述： | DSP for Digital Answering Phone(用于數字應答電話的DSP) |
| 中文描述： | DSP的數字應答電話（用于數字應答電話的數字信號處理器） |
| 文件頁數： | 25/30頁 |
| 文件大?。?/td> | 147K |
| 代理商： | KS16121 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁
Preliminary
DSP for Digital Answering phone with FLASH interface
KS16121
See TONE DETECTION mode for a description of the DTMF and call progress tone detection result. The
recording status is reported with the status bits, MF and VD, which indicate the memory full and voice
detected conditions, respectively.
The KS16121 continues the recording while it reads and responds to these commands. If needed, the host
can use these instructions repeatedly without interrupting a recording operation. When the memory becomes
full , the KS16121 remains in the RECORD mode even though the message is not stored any more.
The host may terminate a recording with an idle instruction. The message is saved in the memory before
the KS16121 returns to the IDLE mode. Alternatively, the host may issue an R1c instruction to terminate
recording and remove the tail portion of the recorded message. The 7-bit parameter, TAIL CUT, specifies
the length of tail to be removed in the unit of 80 msec.
PLAYBACK
The KS16121 enters the PLAYBACK mode with the P0 instruction, which also specifies the playback speed
( PBS ) and the index of message to be played-back ( MESSAGE ID ). The playback speed ranges from 0.5
( two times slower ) to 2 ( two times faster ) in the step of 0.25.
The actual playback starts after the P1 instruction is received. The OFFSET bits of the instruction specifies
the length of the message, from the beginning, to be skipped in the unit of seconds.
While the KS16121 plays a message, the host may issue one of the following instructions:
P2a
-- Monitor the DTMF, call progress tone detection result ( DTMF, CPT ) and recording status ( EM ).
P2b
-- Read the current position in the message from the beginning ( OFFSET ).
The playback continues with these instructions if the PA bit set to 0.
The host can pause the playback these instruction with PA = 1, in which case the KS16121 stops the
playback operation and resumes it when a new instruction ( P2a , P2b ) is entered with PA = 0.
The KS16121 stays in the PLAYBACK mode and continues to respond to the P2a and P2b instructions
even when it is in PAUSE ( PA = 1 ) or the end of message is reached ( EM = 1 ). It returns to the IDLE
mode with an idle instruction.
VOICE PROMPT
The host issues a voice prompt instruction ( V0 ) to play a phrase that is pre-stored in ROM / EPROM or Flash.
The instruction specifies the phrase number and the desired playback speed.
R1a
-- Monitoring the recording status ( MF,VD ) , the DTMF
and call progress tone detection result ( DTMF, CPT ).
R1b
-- Generate a tone, in addition to the tasks performed with R1a. See the TONE GENERATION mode
for definition of the input parameters. The tone generation stops with another R1b instruction with
TONE ID = 0.
相關PDF資料 |
PDF描述 |
|---|---|
| KS32C5000 | LSI of Ethernet(以太網的集成電路) |
| KS35A2 | |
| KV31S1 | |
| KV38S2 | |
| KS500 | R.F. AND SWITCHING TRANSISTORS N-P-N, HF. UND SCHALTTRANSISTOREN N-P-N |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KS16-14 | 制造商:MAJOR 功能描述: |
| KS-16287L1 | 制造商:WSTELC 功能描述: |
| KS-16287L2 | 制造商:WSTELC 功能描述: |
| KS16390 | 制造商: 功能描述: 制造商:Cornell Dubilier Electronics 功能描述: 制造商:undefined 功能描述: |
| KS16479 | 制造商:Olympic Controls Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。