- 您現在的位置：買賣IC網 > PDF目錄374255 > K4D263238D-QC40 (SAMSUNG SEMICONDUCTOR CO. LTD.) 1M x 32Bit x 4 Banks Double Data Rate Synchronous DRAM with Bi-directional Data Strobe and DLL PDF資料下載
參數資料
| 型號： | K4D263238D-QC40 |
| 廠商： | SAMSUNG SEMICONDUCTOR CO. LTD. |
| 英文描述： | 1M x 32Bit x 4 Banks Double Data Rate Synchronous DRAM with Bi-directional Data Strobe and DLL |
| 中文描述： | 100萬x 32Bit的× 4銀行雙數據速率同步DRAM的雙向數據選通和DLL |
| 文件頁數： | 9/18頁 |
| 文件大?。?/td> | 239K |
| 代理商： | K4D263238D-QC40 |
128M DDR SDRAM
K4D263238D
- 9 -
Rev. 1.3 (Jul. 2002)
The extended mode register stores the data for enabling or disabling DLL and selecting output driver strength. The
default value of the extended mode register is not defined, therefore the extend mode register must be written after power
up for enabling or disabling DLL. The extended mode register is written by asserting low on CS, RAS, CAS, WE and high
on BA0(The DDR SDRAM should be in all bank precharge with CKE already high prior to writing into the extended mode
register). The state of address pins A0, A2 ~ A5, A7 ~ A11 and BA1 in the same cycle as CS, RAS, CAS and WE going
low are written in the extended mode register. A1 and A6 are used for setting driver strength to weak or matched imped-
ance. Two clock cycles are required to complete the write operation in the extended mode register. The mode register
contents can be changed using the same command and clock cycle requirements during operation as long as all banks
are in the idle state. A0 is used for DLL enable or disable. “High” on BA0 is used for EMRS. All the other address pins
except A0,A1,A6 and BA0 must be set to low for proper EMRS operation. Refer to the table for specific codes.
A
0
0
1
DLL Enable
Enable
Disable
BA
0
0
1
A
n
~ A
0
MRS
EMRS
Figure 7. Extend Mode Register set
EXTENDED MODE REGISTER SET(EMRS)
Address Bus
Extended
Mode Register
BA
1
BA
0
A
11
A
10
A
9
A
8
A
7
A
6
A
5
A
4
A
3
A
2
A
1
A
0
RFU
1
RFU
D.I.C
RFU
D.I.C
DLL
* RFU(Reserved for future use)
should stay "0" during EMRS
cycle.
A
6
0
1
A
1
1
1
Output Driver Impedance Control
Weak
Matched
相關PDF資料 |
PDF描述 |
|---|---|
| K4D263238D-QC50 | 1M x 32Bit x 4 Banks Double Data Rate Synchronous DRAM with Bi-directional Data Strobe and DLL |
| K4D263238E | Aluminum Electrolytic Radial Lead Hi Temp 150 Deg Capacitor; Capacitance: 100uF; Voltage: 100V; Case Size: 12.5x25 mm; Packaging: Bulk |
| K4D263238E-GC25 | DIODE ZENER SINGLE 300mW 15.2Vz 10mA-Izt 0.02535 0.05uA-Ir 12 SOT-23 3K/REEL |
| K4D263238E-GC2A | DIODE ZENER TRIPLE ISOLATED 200mW 15.2Vz 10mA-Izt 0.02535 0.05uA-Ir 12 SOT-363 3K/REEL |
| K4D263238E-GC33 | DIODE ZENER SINGLE 300mW 16.1Vz 10mA-Izt 0.02547 0.05uA-Ir 12 SOT-23 3K/REEL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| K4D263238D-QC50 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:1M x 32Bit x 4 Banks Double Data Rate Synchronous DRAM with Bi-directional Data Strobe and DLL |
| K4D263238E | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:1M x 32Bit x 4 Banks Graphic Double Data Rate Synchronous DRAM with Bi-directional Data Strobe and DLL |
| K4D263238E-GC25 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:1M x 32Bit x 4 Banks Graphic Double Data Rate Synchronous DRAM with Bi-directional Data Strobe and DLL |
| K4D263238E-GC2A | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:1M x 32Bit x 4 Banks Graphic Double Data Rate Synchronous DRAM with Bi-directional Data Strobe and DLL |
| K4D263238E-GC33 | 制造商:SAMSG 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。