- 您現在的位置：買賣IC網 > PDF目錄384534 > ISL97801ARZ-TK (INTERSIL CORP) High Power LED Driver PDF資料下載
參數資料
| 型號： | ISL97801ARZ-TK |
| 廠商： | INTERSIL CORP |
| 元件分類： | 顯示驅動器 |
| 英文描述： | High Power LED Driver |
| 中文描述： | LED DISPLAY DRIVER, PQCC20 |
| 封裝： | 4 X 4 MM, ROHS COMPLIANT, PLASTIC, QFN-20 |
| 文件頁數： | 11/19頁 |
| 文件大?。?/td> | 707K |
| 代理商： | ISL97801ARZ-TK |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁
11
FN6428.1
April 2, 2007
Theory of Operation
General Description
The ISL97801 is a flexible, highly integrated high-power LED
driver consisting of a PWM switching controller and
integrated 36V NDMOS power FET. The device can drive up
to 8 series high-power LED's at currents up to 1A at 16V
input or 5 LEDs at current up to 350mA at 2.7V input. The
control loop can be configured as either as a boost or buck
regulator with the configuration of the buck/boostn pin,
providing an output voltage above or below the input supply
voltage, depending on the number of stacked LED's. The
controller operates from 2.7V to 16V depending on the
numbers of LEDs and current required and can be powered
by a single lithium ion battery, 5V or 12V regulated supplies
or automotive electrical systems. LED current is sensed
through a low value resistor in series with the LED. A
thermistor can be used to implement a thermal protection
scheme to limit the maximum LED temperature to a preset
desirable level.
Switching Regulator
The ISL97801 employs a current mode PWM control
scheme with a nominal switching frequency of 1MHz. This
provides fast transient response and enables the use of low
profile inductors and compact multilayer ceramic capacitors.
Settling time is optimized by the use of a simple control loop
without an error amplifier, relying instead on intrinsic gain
within the direct summing path. Due to the lower loop gain,
offset must be accounted for when setting up initial LED bias
current. Refer to the applications section of the datasheet for
further information. Figure 28 shows a block diagram of the
system.
Application Configurations
Operating Modes
The ISL97801 can operate as either a buck or boost
regulator. Hardwire BUCK/BOOSTN to GND for boost mode
or to VDC for buck mode. In buck mode the power NDMOS
drive circuit is "floated" (boot-strapped) allowing the NDMOS
gate to be driven above VIN to fully enhance the power
NDMOS. An internal Schottky diode between VDC (5V) and
VHI reduces external component count. Use a ceramic
capacitor of at least 50nF between VHI and SWS1/2 to
bootstrap VHI.
LED Load Connection
ISL97801 includes an auto-sensing FB level shift circuit that
enables the LED load to be connected to either GND or VIN.
An internal sense circuit monitors the FB pin voltage. When
the level exceeds VDC/2, the feedback reference voltage is
switched from GND to VIN. Refer to the application section
of the datasheet for typical application schematics.
Start-up
To maximize external PWM switching speed, the ISL97801
does not include an internal soft-start circuit. When VDC
exceeds the power on reset threshold, switching is delayed
for 1ms (T
DELAY
) allowing the output capacitor to charge
through the inductor. If soft-start control is required, a
suitable application circuit is shown in Figure 30.
Light Level Control
Two light control schemes are provided:
1. An external PWM signal via the EN/PWM pin, providing
low frequency PWM dimming.
2. Bias current level adjustment via the LEVEL input or fixed
internal bias.
PWM Dimming
LED color temperature varies with bias current. In
backlighting applications PWM dimming offers better control
of color temperature because current through the LED's is
kept constant. A 5V gate driver (ENL) synchronized to
EN/PWM can be used to control an external N-Ch FET and
disconnect the LED stack during the PWM off period. The
switch prevents discharge of the output capacitor by the LED
load, maintaining a constant bias independent of PWM duty
cycle. Operation at 1kHz PWM rate is shown in Figure 31
and Figure 32. The load disconnect switch improves PWM
dynamic range, linearity and color temperature control. To
R
0
LEVEL
EL7801
GND
VIN
FB
+
-
Voltage
Feedback
VDC /2
FIGURE 29. FB REFERENCE AUTO SWITCH
FIGURE 30. EXTERNAL SOFT-START CIRCUIT
COUT
20μF
R1
100
VIN
FB
SWS1SWS2
SWD1
SWD2
VBAT FAULT
ISL97801
VBAT
VOUT
C1
4.7nF
R2
2k
L1
10μH
RSENSE
0.5
ISL97801
相關PDF資料 |
PDF描述 |
|---|---|
| ISL9R1560P2 | 8A, 600V Stealth Diode(8A，600V Stealth二極管) |
| ISL9R860P2 | 8A, 600V Stealth Diode(8A，600V Stealth二極管) |
| ISO808 | Isolated 12-Bit Sampling Analog-To-Digital Converter(隔離的12位采樣A\D轉換器) |
| ISP321-1 | HIGH DENSITY MOUNTING PHOTOTRANSISTOR OPTICALLY COUPLED ISOLATORS |
| ISP321-1-88XSM | HIGH DENSITY MOUNTING PHOTOTRANSISTOR OPTICALLY COUPLED ISOLATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL97801BOOSTEVALZ | 功能描述:EVAL BOARD FOR ISL97801 RoHS:是 類別:編程器，開發系統 >> 評估板 - LED 驅動器 系列:* 標準包裝:1 系列:PowerWise® 電流 - 輸出 / 通道:20mA 輸出及類型:1，非隔離 輸出電壓:17V 特點:可調光 輸入電壓:2.7 ~ 5.5 V 已供物品:板 已用 IC / 零件:LM3508 相關產品:LM3508TLX-ND - IC LED DRVR WHT BCKLGT 9USMDLM3508TLDKR-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLCT-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLTR-ND - IC LED DRVR WHT BCKLGT 9MICROSMD |
| ISL97900CRZ | 功能描述:LED照明驅動器 High Current RGB Driver/Controller, 28L 4x5 QFN, Commercial RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| ISL97900CRZ-T | 功能描述:LED照明驅動器 High Current RGB Driver/Controller, 28L 4x5 QFN, Commercial RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| ISL97900CRZ-T7A | 功能描述:LED照明驅動器 High Current RGB Driver/Controller, 28L 4x5 QFN,Commercial T RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| ISL97900CRZ-TK | 功能描述:LED照明驅動器 High Current RGB Driver/Controller, 28L 4x5 QFN, Commercial RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
發布緊急采購，3分鐘左右您將得到回復。