- 您現在的位置：買賣IC網 > PDF目錄383164 > ISL6729IU (INTERSIL CORP) Low-Cost Single-Ended Current-Mode PWM for Microcontroller Based Power Converters PDF資料下載
參數資料
| 型號： | ISL6729IU |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Low-Cost Single-Ended Current-Mode PWM for Microcontroller Based Power Converters |
| 中文描述： | 1 A SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | PLASTIC, MO-187AA, MSOP-8 |
| 文件頁數： | 5/8頁 |
| 文件大?。?/td> | 265K |
| 代理商： | ISL6729IU |
5
Pin Descriptions
CLK -
This is the oscillator timing control pin. The
operational frequency and maximum duty cycle are set by
applying a 5V amplitude clock signal to CLK. The logic high
duration defines the maximum ON time for the output. A
maximum clock rate up to 2.0MHz is possible.
COMP -
COMP is the input to the PWM comparator and is
typically controlled through an external error amplifier.
CS -
This is the current sense input to the PWM comparator.
The range of the input signal is nominally 0 to 1.0V and has
an internal offset of 100mV.
GND -
GND is the power and small signal reference ground
for all functions.
OUT -
This is the drive output to the power switching device.
It is a high current output capable of driving the gate of a
power MOSFET with peak currents of
1.0A
. This GATE
output is actively held low when V
DD
is below the UVLO
threshold.
V
DD
-
V
DD
is the 5V power connection for the IC. The IC will
operate from 4.75V to 5.25V. However, the accuracy of the
voltage clamp on the COMP signal, which determines the
over current threshold, is dependent on the accuracy of
VDD. A tight tolerance on VDD will result in a tight over
current threshold.
The total supply current will depend on the load applied to
OUT. Total I
DD
current is the sum of the operating current
and the average output current. Knowing the operating
frequency, f, and the MOSFET gate charge, Qg, the average
output current can be calculated from:
To optimize noise immunity, bypass V
DD
to GND with a
ceramic capacitor as close to the V
DD
and GND pins as
possible.
Ground Plane Requirements
Careful layout is essential for satisfactory operation of the
device. A good ground plane must be employed. A unique
section of the ground plane must be designated for high di/dt
currents associated with the output stage. V
DD
should be
bypassed directly to GND with good high frequency
capacitors.
Applications Information
Microcontrollers are becoming more popular for monitoring
and supervisory functions in power converters due to their
flexibility, capability, and declining prices. Many applications
would like to take advantage of this flexibility and use them
to perform the control loop function as well. There are many
examples of voltage mode control using digital signal
processing techniques. However, microcontrollers available
today do not have the execution speed required for peak
current mode control at the operational frequencies of
modern switch-mode power supplies. As such, they are
unable to detect the peak current and terminate the
switching cycle within the few nanosecond window required.
The ISL6729 provides the analog circuitry required to
perform peak current control, but delegates the oscillator
function to the microcontroller. This arrangement allows the
microcontroller to control soft-start, maximum duty cycle,
and operational frequency of the power converter, as well as
performing the traditional overhead functions such as fault
monitoring and system interface.
Application of the ISL6729 is similar to the ISL684x family of
PWM converters except that the input bias voltage has been
changed to 5V and the oscillator, reference, and error
amplifier functions have been removed. An external digital
clock signal, such as the PWM output of a microcontroller,
must be supplied to control the frequency and maximum
duty cycle. The frequency of the applied clock signal and the
frequency of operation of the PWM are identical. The duty
cycle of the clock is the maximum duty cycle of the PWM.
Soft-start may be accomplished by incrementing the duty
cycle of the applied clock signal from zero to the maximum
desired value in a time frame appropriate for the application.
PWM
Maximum Duty Cycle
-
99
-
%
Minimum Duty Cycle
-
-
0
%
NOTES:
3. Specifications at -40°C are guaranteed by design, not production tested.
4. This is the V
DD
current consumed when the device is active but not switching. Does not include gate drive current.
5. Guaranteed by design, not 100% tested in production.
Electrical Specifications
Recommended operating conditions unless otherwise noted. Refer to Block Diagram and Typical Application
schematic. V
DD
= 5V, CLK = 50kHz, T
A
= -40 to 105°C (Note 3), Typical values are at T
A
= 25°C
(Continued)
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
UNITS
I
OUT
Qg
f
×
=
(EQ. 1)
ISL6729
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6729IB-T | Low-Cost Single-Ended Current-Mode PWM for Microcontroller Based Power Converters |
| ISL6729IBZ | Low-Cost Single-Ended Current-Mode PWM for Microcontroller Based Power Converters |
| ISL6729IBZ-T | Low-Cost Single-Ended Current-Mode PWM for Microcontroller Based Power Converters |
| ISL6729IU-T | Low-Cost Single-Ended Current-Mode PWM for Microcontroller Based Power Converters |
| ISL6729IUZ | Low-Cost Single-Ended Current-Mode PWM for Microcontroller Based Power Converters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6729IU-T | 功能描述:IC REG CTRLR BST FLYBK ISO 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF) |
| ISL6729IUZ | 功能描述:IC REG CTRLR BST FLYBK ISO 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6729IUZ-T | 功能描述:IC REG CTRLR BST FLYBK ISO 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6730AFUZ | 功能描述:功率因數校正 IC PFC Controller RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| ISL6730AFUZ-T | 功能描述:功率因數校正 IC PFC Controller RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。