- 您現在的位置：買賣IC網 > PDF目錄383160 > ISL6605CRZ (INTERSIL CORP) Synchronous Rectified MOSFET Driver PDF資料下載
參數資料
| 型號： | ISL6605CRZ |
| 廠商： | INTERSIL CORP |
| 元件分類： | MOSFETs |
| 英文描述： | Synchronous Rectified MOSFET Driver |
| 中文描述： | 4 A HALF BRDG BASED MOSFET DRIVER, PQCC8 |
| 封裝： | 3 X 3 MM, ROHS COMPLIANT, PLASTIC, MO-220VEEC, QFN-8 |
| 文件頁數： | 6/9頁 |
| 文件大小： | 302K |
| 代理商： | ISL6605CRZ |
6
FN9091.5
January 4, 2005
This driver is optimized for voltage regulators with large step
down ratio. The lower MOSFET is usually sized much larger
compared to the upper MOSFET because the lower
MOSFET conducts for a much longer time in a switching
period. The lower gate driver is therefore sized much larger
to meet this application requirement. The 0.4
on-resistance
and 4A sink current capability enable the lower gate driver to
absorb the current injected to the lower gate through the
drain-to-gate capacitor of the lower MOSFET and prevent a
shoot through caused by the high dv/dt of the phase node.
Three-State PWM Input
A unique feature of the ISL6605 and other Intersil drivers is
the addition of a shutdown window to the PWM input. If the
PWM signal enters and remains within the shutdown window
for a set holdoff time, the output drivers are disabled and
both MOSFET gates are pulled and held low. The shutdown
state is removed when the PWM signal moves outside the
shutdown window. Otherwise, the PWM rising and falling
thresholds outlined in the ELECTRICAL SPECIFICATIONS
determine when the lower and upper gates are enabled.
Adaptive Shoot-Through Protection
Both drivers incorporate adaptive shoot-through protection
to prevent upper and lower MOSFETs from conducting
simultaneously and shorting the input supply. This is
accomplished by ensuring the falling gate has turned off one
MOSFET before the other is allowed to rise.
During turn-off of the lower MOSFET, the LGATE voltage is
monitored until it reaches a 1V threshold, at which time the
UGATE is released to rise. Adaptive shoot-through circuitry
monitors the upper MOSFET gate voltage during UGATE
turn-off. Once the upper MOSFET gate-to-source voltage
has dropped below a threshold of 1V, the LGATE is allowed
to rise.
Internal Bootstrap Diode
This driver features an internal bootstrap Schottky diode.
Simply adding an external capacitor across the BOOT and
PHASE pins completes the bootstrap circuit.The bootstrap
capacitor can be chosen from the following equation:
Q
BOOT
where Q
GATE
is the amount of gate charge required to fully
charge the gate of the upper MOSFET. The
V
BOOT
term is
defined as the allowable droop in the rail of the upper drive.
The above relationship is illustrated in Figure 1.
As an example, suppose an upper MOSFET has a gate
charge, Q
GATE
, of 65nC at 5V and also assume the droop in
the drive voltage over a PWM cycle is 200mV. One will find
that a bootstrap capacitance of at least 0.125
μ
F is required.
The next larger standard value capacitance is 0.15
μ
F. A
good quality ceramic capacitor is recommended.
Power Dissipation
Package power dissipation is mainly a function of the
switching frequency and total gate charge of the selected
MOSFETs. Calculating the power dissipation in the driver for
a desired application is critical to ensuring safe operation.
Exceeding the maximum allowable power dissipation level
will push the IC beyond the maximum recommended
operating junction temperature of 125°C. The maximum
allowable IC power dissipation for the SO-8 package is
approximately 800mW. When designing the driver into an
application, it is recommended that the following calculation
be performed to ensure safe operation at the desired
frequency for the selected MOSFETs. The power dissipated
by the driver is approximated as below and plotted as in
Figure 2.
where f
sw
is the switching frequency of the PWM signal. V
U
and V
L
represent the upper and lower gate rail voltage. Q
U
and Q
L
are the upper and lower gate charge determined by
MOSFET selection and any external capacitance added to
the gate pins. The I
DDQ
V
CC
product is the quiescent power
of the driver and is typically negligible.
C
BOOT
-----------------------
≥
V
BOOT
(V)
C
B
(
0.0
0.2
0.4
0.4
0.6
0.6
0.8
1.0
1.2
1.4
1.6
1.8
2.0
0.0
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8
0.9
1.0
Q
GATE
= 100 nC
50nC
20nC
0.0
0.1 0.2
0.3
0.4
0.5 0.6
0.7
0.8 0.9
1.0
50nC
20nC
Q
GATE
=100nC
FIGURE 1. BOOTSTRAP CAPACITANCE vs. BOOT RIPPLE
VOLTAGE
P
f
sw
1.5V
U
Q
U
V
L
Q
L
+
(
)
I
DDQ
V
CC
+
=
ISL6605
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6605CRZA | Synchronous Rectified MOSFET Driver |
| ISL6605IRZ | Synchronous Rectified MOSFET Driver |
| ISL6605 | Synchronous Rectified MOSFET Driver |
| ISL6605CB | Synchronous Rectified MOSFET Driver |
| ISL6605CBZ | Triple 3-Input Positive-AND Gates 14-PDIP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6605CRZ | 制造商:Intersil Corporation 功能描述:MOSFET Driver IC |
| ISL6605CRZA | 功能描述:IC MOSFET DRVR SYNC BUCK 8-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - MOSFET，電橋驅動器 - 外部開關 系列:- 標準包裝:6,000 系列:* |
| ISL6605CRZA-T | 功能描述:IC MOSFET DRVR SYNC BUCK 8-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - MOSFET，電橋驅動器 - 外部開關 系列:- 標準包裝:6,000 系列:* |
| ISL6605CRZR5168 | 制造商:Intersil Corporation 功能描述:MOSFET DRVR 4A 2-OUT HI/LO SIDE INV/NON-INV 8QFN EP - Rail/Tube 制造商:Intersil Corporation 功能描述:IC MOSFET DRVR SYNCH RECT 8QFN 制造商:Intersil 功能描述:52831C01 MASK |
| ISL6605CRZ-T | 功能描述:功率驅動器IC VER OF ISL6605CR-T RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。