- 您現在的位置：買賣IC網 > PDF目錄383157 > ISL6563IR-T (INTERSIL CORP) Two-Phase Multi-Phase Buck PWM Controller with Integrated MOSFET Drivers PDF資料下載
參數資料
| 型號： | ISL6563IR-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Two-Phase Multi-Phase Buck PWM Controller with Integrated MOSFET Drivers |
| 中文描述： | SWITCHING CONTROLLER, 255 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 4 X 4 MM, PLASTIC, MO-220-VGGD-2, QFN-24 |
| 文件頁數： | 7/19頁 |
| 文件大?。?/td> | 516K |
| 代理商： | ISL6563IR-T |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁
7
FN9126.6
April 13, 2005
Operation
Figure 1 shows a simplified diagram of the voltage regulation
and current control loops. Both voltage and current feedback
are used to precisely regulate the output voltage and tightly
control the output currents, I
L1
and I
L2
, of the two power
channels.
Voltage Loop
Feedback from the output voltage is applied via resistor R1
to the inverting input of the Error Amplifier. This signal can
drive the Error Amplifier output either high or low, depending
upon the output voltage. Low output voltage makes the
amplifier output move towards a higher output voltage level.
Amplifier output voltage is applied to the positive inputs of
the PWM Circuit comparators via the correction summing
networks. Out-of-phase sawtooth signals are applied to the
two PWM comparators inverting inputs. Increasing Error
Amplifier voltage results in increased Comparator output
duty cycle. This increased duty cycle signal is passed
through the output drivers with no phase reversal to drive the
external upper MOSFETs. Increased duty cycle or ON time
for the upper MOSFET transistors results in increased
output voltage to compensate for the low output voltage
sensed.
Current Loop
The current control loop works in a similar fashion to the
voltage control loop, but with current control information
applied individually to each channel’s Comparator. The
information used for this control is the voltage that is
developed across the r
DS(ON)
of each lower MOSFET, while
they are conducting. A single resistor converts and scales
the voltage across the MOSFETs to a current that is applied
to the Current Sensing circuit within the ISL6563. Output
from these sensing circuits is applied to the current
averaging circuit. Each PWM channel receives the
difference current signal from the summing circuit that
compares the average sensed current to the individual
channel current. When a power channel’s current is greater
than the average current, the signal applied via the summing
Correction circuit to the Comparator, reduces the output
pulse width of the Comparator to compensate for the
detected “above average” current in that channel.
Droop Implementation
In addition to controlling each channel’s output current, the
average channel current is used to implement an output
voltage droop characteristic. Internal average channel
current is fed into the FB pin; the voltage thus developed
across R
1
is equal to the droop voltage.
FIGURE 1. SIMPLIFIED BLOCK DIAGRAM OF THE ISL6563 VOLTAGE AND CURRENT CONTROL LOOPS
DROOP
SOURCE, I
FB
AVERAGE
CURRENT
SENSE
Σ
Σ
Σ
DAC
&
REFERENCE
PWM
CIRCUIT
PWM
CIRCUIT
HALF-BRIDGE
DRIVE
HALF-BRIDGE
DRIVE
Σ
OSCILLATOR
COMP
FB
L1
L2
C
OUT
V
OUT
V
IN
V
IN
R
ISEN
UGATE1
UGATE2
LGATE1
LGATE2
PHASE1
PHASE2
ISEN
CURRENT
SENSE
VCC
R1
R2
C2
ERROR
AMP
ISL6563
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6563CR | Two-Phase Multi-Phase Buck PWM Controller with Integrated MOSFET Drivers |
| ISL6563CRZ | Two-Phase Multi-Phase Buck PWM Controller with Integrated MOSFET Drivers |
| ISL6563IR | Two-Phase Multi-Phase Buck PWM Controller with Integrated MOSFET Drivers |
| ISL6563CR-T | Two-Phase Multi-Phase Buck PWM Controller with Integrated MOSFET Drivers |
| ISL6563EVAL1 | Two-Phase Multi-Phase Buck PWM Controller with Integrated MOSFET Drivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6563IRZ | 功能描述:電流型 PWM 控制器 P6 TWO PHS CONT INTEGRTD DRVRS DESKT RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| ISL6563IRZ-T | 功能描述:電流型 PWM 控制器 P6 TWO PHS CONT INTEGRTD DRVRS DESKT RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| ISL6564ACRZ | 功能描述:IC REG CTRLR BUCK PWM VM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6564ACRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6564AIRZ | 功能描述:IC REG CTRLR BUCK PWM VM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。