- 您現在的位置：買賣IC網 > PDF目錄381959 > ISL6534CV-T (INTERSIL CORP) PWM Control Circuit 16-TSSOP 0 to 70 PDF資料下載
參數資料
| 型號： | ISL6534CV-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | PWM Control Circuit 16-TSSOP 0 to 70 |
| 中文描述： | DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封裝： | PLASTIC, MO-153-ADT, TSSOP-24 |
| 文件頁數： | 1/26頁 |
| 文件大?。?/td> | 612K |
| 代理商： | ISL6534CV-T |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
1
ISL6534
Dual PWM with Linear
The ISL6534 is a versatile triple regulator that has two
independent synchronous-rectified buck controllers with
integrated 12V gate drivers (OUT1 and OUT2) and a linear
controller (OUT3) to offer precision regulation of up to three
voltage rails. An optional shunt regulator allows 12V only
operation, when a 5V supply is not available.
Each controller has independent soft-start and enable
functions combined on a single pin. A capacitor from each
SS/EN pin to ground sets the soft-start time, and pulling
SS/EN below 1.0V disables the controller. The SS/EN pins
can be controlled independently or they can be ganged
together to provide complete control of start-up coordination.
The PGOOD function indicates when all regulators have
completed their soft start and provides an indication of short-
circuit conditions on either switching regulator.
There are two ways to control the switching frequency of the
PWM regulators. The default switching frequency is 300kHz
(FS_SYNC pin open). A resistor from FS_SYNC to ground
increases the switching frequency (up to 1MHz). Connecting
the gate signal from another PWM IC synchronizes the
ISL6534 switchers to the frequency of the other controller.
This allows independent regulators operating at a common
frequency to avoid low-frequency beats. The gate drivers for
DDR mode can be staggered by 90° in order to minimize
cross-conduction.
Switcher OUT1 has an internal 0.8% accurate reference for
regulating any voltage down to 0.6V. OUT2 has current
sinking capability and an external reference input allowing
convenient connection to OUT1 through a resistor divider for
DDRAM applications. The 3.3V reference pin provides the
option for independent regulation of OUT2. The linear
controller drives an external N-Channel MOSFET, making
the ISL6534 one of the most versatile regulators available.
Simplified Block Diagram
Features
Two Synchronous-Rectified Buck Controllers
- Voltage Mode control
- VIN range up to 12V
- VOUT range from 0.6V to 6V
- 12V LGATE drivers; up to 12V Boot Strap for UGATE
Switcher References
- 0.6V Reference for OUT1 (0.8% Accurate)
- 3.3V Reference Output for OUT2 (0.8% Accurate)
- External Reference Input for OUT2
- Buffered VTT Reference Output
Switcher clocking
- Phase options for Optimal Clock Relationship
- Resistor-Selectable Switching Frequency (300kHz
default; Resistor to Ground for 300kHz to 1MHz range)
- Synchronization-Capable Switching Frequency
(Connect FS_SYNC to Separate Regulator)
Single Linear Controller
- Drives N-Channel MOSFET
- 0.6V Reference (0.8% Accurate)
- VIN range up to 12V
- VOUT range from 0.6V to 6V
12V and 5V supplies required (but optional shunt regulator
can generate VCC = 5.8V from 12V)
Three Independent Soft-Start/Enable Pins
- Gang Together or Control Independently
PGOOD Output Indicates All Outputs Available
Thermally Enhanced QFN or TSSOP Package
QFN Package:
- Compliant to JEDEC PUB95 MO-220
QFN - Quad Flat No Leads - Package Outline
- Near Chip Scale Package footprint, which improves
PCB efficiency and has a thinner profile
Pb-Free Available (RoHS Compliant)
BOOT1
UGATE1
LGATE1
BOOT2
UGATE2
LGATE2
SS2/EN2
REFIN
FB2
COMP2
FB1
FS/SYNC
DRIVE3
COMP1
SS3/EN3
SS1/EN1
OUT1
PWM CONTROLLER
OUT2
PWM CONTROLLER
OUT3
LINEAR CONTROLLER
FB3
REFOUT
VREF
3.3V
PGOOD
Data Sheet
December 21, 2004
FN9134.1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143
Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2004. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6534CVZ | PWM Control Circuit 16-TSSOP 0 to 70 |
| ISL6534CR-T | Dual PWM with Linear |
| ISL6534CVZ-T | Dual PWM with Linear |
| ISL6552 | Wide-Range Power-Supply Controller 8-SO -20 to 85 |
| ISL6552CB | Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6534CV-TR5173 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intersil Corporation 功能描述: |
| ISL6534CV-TR5229 | 制造商:Intersil Corporation 功能描述:VOLT MODE PWM CNTRLR 0.6V TO 9V/0.6V TO 9V 20A 24TSSOP EP - Tape and Reel 制造商:Intersil Corporation 功能描述:IC REG 3OUT BCK/LINEAR 24EPTSSOP 制造商:Intersil 功能描述:W/MODIFIED VAGEF TEST 24LD EPTSSOP |
| ISL6534CVZ | 功能描述:IC REG TRPL BCK/LINEAR 24EPTSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| ISL6534CVZR5229 | 功能描述:IC REG TRPL BCK/LINEAR 24TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| ISL6534CVZ-T | 功能描述:IC REG 3OUT BCK/LINEAR 24EPTSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
發布緊急采購，3分鐘左右您將得到回復。