參數資料
型號： ISL6310IRZ
廠商： INTERSIL CORP
元件分類： 穩壓器
英文描述： Two-Phase Buck PWM Controller with High Current Intergrated MOSFET Driver
中文描述： SWITCHING CONTROLLER, 1500 kHz SWITCHING FREQ-MAX, PQCC32
封裝： 5 X 5 MM, ROHS COMPLIANT, PLASTIC, MO-220VHHD-2, QFN-32
文件頁數： 24/27頁
文件大小： 711K
代理商： ISL6310IRZ
24
FN9209.2
October 19, 2005
Switching Frequency
There are a number of variables to consider when choosing
the switching frequency, as there are considerable effects on
the upper MOSFET loss calculation. These effects are
outlined in
MOSFETs
, and they establish the upper limit for
the switching frequency. The lower limit is established by the
requirement for fast transient response and small output-
voltage ripple as outlined in
Output Filter Design
. Choose the
lowest switching frequency that allows the regulator to meet
the transient-response requirements.
Switching frequency is determined by the selection of the
frequency-setting resistor, R
FS
. Figure 24 and Equation 33
are provided to assist in selecting the correct value for R
FS
.
[
=
Input Capacitor Selection
The input capacitors are responsible for sourcing the AC
component of the input current flowing into the upper
MOSFETs. Their RMS current capacity must be sufficient to
handle the ac component of the current drawn by the upper
MOSFETs which is related to duty cycle and the number of
active phases.
For a Two-phase design, use Figure 25 to determine the
input-capacitor RMS current requirement set by the duty
cycle, maximum sustained output current (I
O
), and the ratio
of the peak-to-peak inductor current (I
L,PP
) to I
O
. Select a
bulk capacitor with a ripple current rating which will minimize
the total number of input capacitors required to support the
RMS current calculated. The voltage rating of the capacitors
should also be at least 1.25 times greater than the maximum
input voltage. Figure 26 provides the same input RMS
current information for single-phase designs. Use the same
approach for selecting the bulk capacitor type and number.
Low ESL, high-frequency ceramic capacitors are needed in
addition to the input bulk capacitors to suppress leading and
falling edge voltage spikes. The spikes result from the high
current slew rate produced by the upper MOSFET turn on and
off. Place them as close as possible to each upper MOSFET
drain to minimize board parasitics and maximize suppression.
Layout Considerations
MOSFETs switch very fast and efficiently. The speed with
which the current transitions from one device to another
causes voltage spikes across the interconnecting
impedances and parasitic circuit elements. These voltage
spikes can degrade efficiency, radiate noise into the circuit
and lead to device overvoltage stress. Careful component
layout and printed circuit design minimizes the voltage
spikes in the converter. Consider, as an example, the turnoff
transition of the upper PWM MOSFET. Prior to turnoff, the
upper MOSFET was carrying channel current. During the
turnoff, current stops flowing in the upper MOSFET and is
picked up by the lower MOSFET. Any inductance in the
R
FS
10
10.61
1.035
FSW
(
)
log
–
]
(EQ. 33)
FIGURE 24. R
FS
vs SWITCHING FREQUENCY
100K
200K
SWITCHING FREQUENCY (Hz)
500K
1M
2M
R
F
)
10
20
50
100
200
FIGURE 25. NORMALIZED INPUT-CAPACITOR RMS
CURRENT FOR 2-PHASE CONVERTER
0.3
0.1
0
0.2
I
R
I
O
)
0
0.4
1.0
0.2
0.6
0.8
DUTY CYCLE (V
IN/
V
O
)
I
L,PP
= 0
I
L,PP
= 0.5 I
O
I
L,PP
= 0.75 I
O
FIGURE 26. NORMALIZED INPUT-CAPACITOR RMS
CURRENT FOR SINGLE-PHASE CONVERTER
0
0.4
1.0
0.2
0.6
0.8
DUTY CYCLE (V
IN
/V
O
)
I
R
/
O
)
0.6
0.2
0
0.4
I
L,PP
= 0
I
L,PP
= 0.5 I
O
I
L,PP
= 0.75 I
O
ISL6310
相關PDF資料
PDF描述
ISL6431A Advanced Pulse Width Modulation (PWM) Controller for Broadband Applications
ISL6431ACB Advanced Pulse Width Modulation (PWM) Controller for Broadband Applications
ISL6520A Adjustable Precision Shunt Regulator 3-SOT-23 -40 to 125
ISL6525CBZ Buck and Synchronous-Rectifier Pulse-Width Modulator (PWM) Controller
ISL6525 Adjustable Precision Shunt Regulator 5-SOT-23 -40 to 125
相關代理商/技術參數
參數描述
ISL6310IRZ-T 功能描述:電壓模式 PWM 控制器 W/ANNEAL 2-PH PWM CNTROL W/2-DRVRS RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel
ISL6312ACRZ 功能描述:IC CTRLR PWM 4PHASE BUCK 48-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,000 系列:- 應用:電源，ICERA E400，E450 輸入電壓:4.1 V ~ 5.5 V 輸出數:10 輸出電壓:可編程 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:42-WFBGA，WLCSP 供應商設備封裝:42-WLP 包裝:帶卷 (TR)
ISL6312ACRZ-T 功能描述:IC CTRLR PWM 4PHASE BUCK 48-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,000 系列:- 應用:電源，ICERA E400，E450 輸入電壓:4.1 V ~ 5.5 V 輸出數:10 輸出電壓:可編程 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:42-WFBGA，WLCSP 供應商設備封裝:42-WLP 包裝:帶卷 (TR)
ISL6312AIRZ 功能描述:IC CTRLR PWM 4PHASE BUCK 48-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,000 系列:- 應用:電源，ICERA E400，E450 輸入電壓:4.1 V ~ 5.5 V 輸出數:10 輸出電壓:可編程 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:42-WFBGA，WLCSP 供應商設備封裝:42-WLP 包裝:帶卷 (TR)
ISL6312AIRZ-T 功能描述:IC CTRLR PWM 4PHASE BUCK 48-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,000 系列:- 應用:電源，ICERA E400，E450 輸入電壓:4.1 V ~ 5.5 V 輸出數:10 輸出電壓:可編程 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:42-WFBGA，WLCSP 供應商設備封裝:42-WLP 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*