- 您現在的位置：買賣IC網 > PDF目錄384522 > ISL59311IRZ (INTERSIL CORP) Differential Video Amplifier with Common Mode Sync Encoder and Serial Digital Interface PDF資料下載
參數資料
| 型號： | ISL59311IRZ |
| 廠商： | INTERSIL CORP |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | Differential Video Amplifier with Common Mode Sync Encoder and Serial Digital Interface |
| 中文描述： | 3 CHANNEL, VIDEO AMPLIFIER, PQCC32 |
| 封裝： | 5 X 6 MM, ROHS COMPLIANT, MO-220, QFN-32 |
| 文件頁數： | 11/14頁 |
| 文件大?。?/td> | 388K |
| 代理商： | ISL59311IRZ |
11
FN6372.2
April 4, 2007
Twisted Pair Termination
The schematic in Figure 20 illustrates a termination scheme
for 50
Ω
series termination and a 100
Ω
twisted pair cable.
Note RCM is the common mode termination to allow
measurement of V
CM
and should not be too small since it
loads the ISL59311; a little over a 100
Ω
is recommended for
RCM.
Video Transmission
The ISL59311 is a twisted pair differential line driver directed
at the transmission of Video Signals through cables up to
100 feet; however, as signal losses increase with
transmission line length the ISL59311 will need additional
support to equalize video signals along longer twisted pair
transmission lines. A full solution to accomplish this is the
SXGA Video Transmission System presented in the
ISL59311 Data Sheet. Note the inclusion of the EL9111 for
signal equalization of up to 1000ft of CAT-5 cable and
common mode extraction; see Data Sheet for additional
information on the EL9111.
Long Distance Video Transmission
The SXGA Video Transmission System makes it possible to
transmit Red, Green and Blue (RGB) video plus sync up to
1000ft through CAT-5 cable. The input to the SXGA Video
Transmission System is the output of a video source
transmitting RGB video signals plus sync. The signals are
received initially by the ISL59311; which converts the single
ended input RGB signals to three fully differential waveforms
with sync encoded on the discrete common modes of each
color channel and then drives the signals through a length of
CAT-5 cable. The signal is received by the EL9111, which
can provide 6-pole equalization for both high and low
frequency signal transmission line losses. Then the EL9111
converts the differential RGB video signals back into single
ended format while extracting the common mode component
for decoding. The single ended RGB signal is taken directly
from the output of the EL9111 and is ready for the output
device. The EL9111 Common Mode Decoder Circuit
receives the common mode signals and decodes them and
transmits H
SYNC
and V
SYNC
to the output device.
Disabling the Amplifiers with the Disable Pin
The Disable pin must be a logic low for normal operation of
the video amplifiers. When Disable is taken high, the
amplifiers are disabled, reducing supply V
CCA
supply
current. (The Disable pin has no effect on the Serial Digital
Transceiver - it is always enabled as long as power is
applied to V
CCD
.)
Serial Digital Transceiver Operation
The digital transceiver is a half-duplex design, either
receiving data on the S
IN
pins and sending it out on the
S
DATA
pin, or transmitting data from the S
DATA
pin out on
some the 2 S
OUT
pins. The digital transceiver operates in a
high speed (up to 50MBaud) differential mode. The S
DATA
pin is the half-duplex logic-level transmit and receive data
pin. S
DATA
is an output when Transmit = low (receive mode)
and an input when Transmit = high (transmit mode). This can
be made to work with existing designs that use independent
transmit and receive pins by connecting
S
DATA
directly to the
transmit pin and through a resistor to the receive pin.
Figure 21 shows an example of how to interface the
ISL59311 with an RS485 transceiver.
V
CCD
is the power source for the digital line interface drivers
and receivers.
-
+
-
+
-
+
V
OUT
A
V
IN
A
DISABLE
V
REF
-
+
-
+
-
+
V
OUT
B
V
IN
B
DISABLE
V
REF
-
+
-
+
-
+
V
OUT
C
V
IN
C
DISABLE
V
REF
LOGIC
DECODING
CM
A
CM
B
CM
C
V
SYNC
H
SYNC
DISABLE
D
FIGURE 19. VIDEO DRIVER BLOCK DIAGRAM
-
+
V
REF
-
+
TWISTED
PAIR
Z
O
=100
Ω
50
Ω
50
Ω
50
Ω
50
Ω
120
Ω
(RCM: SHOULD BE >100
Ω
)
(FOR LOADING
CONSIDERATIONS)
V
CM
FIGURE 20. TWISTED PAIR TERMINATION
ISL59311
相關PDF資料 |
PDF描述 |
|---|---|
| ISL59311 | Differential Video Amplifier with Common Mode Sync Encoder and Serial Digital Interface |
| ISL59311IRZ-T13 | Differential Video Amplifier with Common Mode Sync Encoder and Serial Digital Interface |
| ISL59420 | 400MHz Multiplexing Amplifier |
| ISL59420IU-T13 | 400MHz Multiplexing Amplifier |
| ISL59420IU-T7 | 400MHz Multiplexing Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL59311IRZ-T13 | 制造商:Intersil Corporation 功能描述:DIFFERENTIAL VIDEO AMPLIFIER W/COMMON 制造商:Intersil Corporation 功能描述:VID AMP TRIPLE 1.3GHZ 5.5V 32QFN EP - Tape and Reel 制造商:Intersil 功能描述:ISL6558IRZ-T W/SCM ASSY & MSL2 ONLY 4 |
| ISL59420 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:400MHz Multiplexing Amplifier |
| ISL59420EVAL1 | 功能描述:EVAL BOARD 1 FOR ISL59420 RoHS:否 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:PSoC® 主要目的:電源管理，熱管理 嵌入式:- 已用 IC / 零件:- 主要屬性:- 次要屬性:- 已供物品:板，CD，電源 |
| ISL59420IU | 功能描述:IC AMP MULTIPLEX 400MHZ 10-MSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| ISL59420IU-T13 | 功能描述:IC AMP MULTIPLEX 400MHZ 10-MSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。