- 您現在的位置：買賣IC網 > PDF目錄383134 > ISL54416 (Intersil Corporation) Low Voltage, Dual SPDT, USB/CVBS/Audio Switches with Negative Signal Capability(具有負信號能力的低電壓, 雙路單刀雙擲, USB/CVBS/音頻開關) PDF資料下載
參數資料
| 型號： | ISL54416 |
| 廠商： | Intersil Corporation |
| 英文描述： | Low Voltage, Dual SPDT, USB/CVBS/Audio Switches with Negative Signal Capability(具有負信號能力的低電壓, 雙路單刀雙擲, USB/CVBS/音頻開關) |
| 中文描述： | 低電壓，雙路SPDT，的USB / CVBS輸入/音頻開關具有負信號功能（具有負信號能力的低電壓，雙路單刀雙擲，的USB / CVBS輸入/音頻開關） |
| 文件頁數： | 10/14頁 |
| 文件大?。?/td> | 490K |
| 代理商： | ISL54416 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁
10
FN6318.1
June 27, 2006
Figure 15 shows the measured gain and phase of a
3.58MHz, 300MV
P-P
signal at the output of the switch
relative to the signal at the input of the switch as you vary the
DC offset of the signal from 0V to 1V using a network
analyzer. The data from the sweep was used to calculated
the differential gain (DG) and differential phase (DP). Over
luminance range of 0V to 1V: DG = 0.03% and DP = 0.05°.
Over luminanace range of 0V to 0.7V: DG = 0.03% and
DP = 0.03°. DG and DP plot using an actual NTSC video
signal is shown in Figure 16. DG = 0.05% and DP = 0.02°.
These NC switches are uni-directional switches. The
audio/video sources should be connected at the NC side of
the switch (pins 7 and 8) and the speaker load and video
receiver should be connected at the COM side of the switch
(pins 3 and 4).
For the ISL54415 and ISL54416 parts the NC audio/video
switches are active (turned ON) whenever the V
BUS
voltage
is
≤
V
DD
+ 0.2V. The V
BUS
pin is internally pulled low
through a pull-down resistor allowing the V
BUS
pin to float.
When the V
BUS
pin is floating the NC audio/video switches
are ON.
Note: Whenever the audio/video switches are ON the USB
transceivers need to be in the high impedance state or static
high or low state to keep from interfering with the audio/video
transmission.
For the ISL54417 part the NC1 audio/video switch is active
(turned ON) whenever logic pin IN1 (pin 10) is LOW. The
NC2 audio/video switch is active (turned ON) whenever the
logic pin IN2 (pin 2) is LOW. Unlike the ISL54415 and
ISL54416 parts were the two SPDT switches work in
tandem, the ISL54417 gives you independent control over
each SPDT switch.
NO1 and NO2 USB Switches
The two NO (normally open) USB switches (NO1, NO2) are
5
Ω
bidirectional switches that were designed to pass low
speed and full-speed USB differential signals typically in the
range of 0V to 3.6V. The switches have low capacitance
(0.47pF) and high bandwidth (239MHz) to pass USB full-
speed signals (12Mbps) with minimum edge and phase
distortion to meet USB 2.0 signal quality specifications. See
Figure 12 for full-speed USB eye diagram.
For the ISL54415 and ISL54416 parts the maximum signal
range for the USB switches is from -1.5V to V
BUS
. The
signal voltage should not be allow to exceed the V
BUS
voltage rail or go below ground by more than -1.5V.
For the ISL54417 part the maximum signal range is from
-1.5V to V
DD
. The signal voltage should not be allowed to
exceed the V
DD
voltage rail or go below ground by more
than -1.5V.
When using the ISL54415 and ISL54416 parts the USB
switches are active (turned ON) whenever the V
BUS
voltage
is
≥
V
DD
+ 0.8V. V
BUS
is internally pulled low, so when V
BUS
is floating the USB switches are OFF.
Note: Whenever the USB switches are ON the audio and
video drivers need to be at AC or DC ground or floating to
keep from interfering with the data transmission.
When using the ISL54417 part the NO1 USB switch is active
(turned ON) whenever logic pin IN1 (pin 10) is HIGH. The
NO2 USB switch is active (turned ON) whenever the logic
pin IN2 (pin 2) is HIGH. Unlike the ISL54415 and ISL54416
parts were the two SPDT switches work in tandem, the
ISL54417 gives you independent control over each SPDT
switch.
FIGURE 8. VECTOR-SCOPE PLOT BEFORE SWITCH
FIGURE 9. VECTOR-SCOPE PLOT AFTER SWITCH
ISL54415, ISL54416, ISL54417
相關PDF資料 |
PDF描述 |
|---|---|
| ISL55004IBZ | High Supply Voltage 220MHz Unity-Gain Stable Operational Amplifiers |
| ISL55002 | High Supply Voltage 220MHz Unity-Gain Stable Operational Amplifiers |
| ISL55002IB | High Supply Voltage 220MHz Unity-Gain Stable Operational Amplifiers |
| ISL55002IBZ | High Supply Voltage 220MHz Unity-Gain Stable Operational Amplifiers |
| ISL55002IBZ-T13 | High Supply Voltage 220MHz Unity-Gain Stable Operational Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL54416IRUZ-T | 功能描述:IC USB SWITCH DUAL SPDT 10UTQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:36 系列:- 功能:多路復用器 電路:2 x 4:1 導通狀態電阻:75 歐姆 電壓電源:單/雙電源 電壓 - 電源，單路/雙路(±):2 V ~ 12 V，±2 V ~ 6 V 電流 - 電源:- 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:20-SOIC W 包裝:管件 |
| ISL54417 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Voltage, Dual SPDT, USB/CVBS/ Audio Switches with Negative Signal Capability |
| ISL54417IRUZ-T | 功能描述:IC USB SWITCH DUAL SPDT 10UTQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:36 系列:- 功能:多路復用器 電路:2 x 4:1 導通狀態電阻:75 歐姆 電壓電源:單/雙電源 電壓 - 電源，單路/雙路(±):2 V ~ 12 V，±2 V ~ 6 V 電流 - 電源:- 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:20-SOIC W 包裝:管件 |
| ISL54500 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:+1.8V to +5.5V, 5ヘ, Single SPDT Analog Switch |
| ISL54500IHZ-T | 功能描述:IC SWITCH SPDT SGL SOT23-6 RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 標準包裝:2,500 系列:- 功能:視頻交叉點開關 電路:1 x 8:6 導通狀態電阻:- 電壓電源:單電源 電壓 - 電源，單路/雙路(±):3.135 V ~ 5.25 V 電流 - 電源:55mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:24-TSSOP 包裝:帶卷 (TR) 產品目錄頁面:1214 (CN2011-ZH PDF) 其它名稱:FMS6502MTC24XTR |
發布緊急采購，3分鐘左右您將得到回復。