16 FN6639.3 November 29, 2012 Power Dissipation It is possible to exceed the +150掳C maximum junction temperatures under cert" />
鍙冩暩(sh霉)璩囨枡
鍨嬭櫉锛� ISL28110FBZ-T13
寤犲晢锛� Intersil
鏂囦欢闋佹暩(sh霉)锛� 8/23闋�
鏂囦欢澶�?銆�?/td> 0K
鎻忚堪锛� IC OPAMP JFET 12.5MHZ LN 8SOIC
鐢�(ch菐n)鍝佸煿瑷�(x霉n)妯″锛� Patient Monitoring and Diagnostic Equipment Solutions
Solutions for Industrial Control Applications
妯�(bi膩o)婧�(zh菙n)鍖呰锛� 2,500
鏀惧ぇ鍣ㄩ鍨嬶細 J-FET
闆昏矾鏁�(sh霉)锛� 1
杓稿嚭椤炲瀷锛� 婊挎摵骞�
杞�(zhu菐n)鎻涢€熺巼锛� 20 V/µs
澧炵泭甯跺绌嶏細 12.5MHz
闆绘祦 - 杓稿叆鍋忓锛� 2pA
闆诲 - 杓稿叆鍋忕Щ锛� 300µV
闆绘祦 - 闆绘簮锛� 2.55mA
闆绘祦 - 杓稿嚭 / 閫氶亾锛� 50mA
闆诲 - 闆绘簮锛屽柈璺�/闆欒矾(±)锛� 9 V ~ 40 V锛�±4.5 V ~ 20 V
宸ヤ綔婧害锛� -40°C ~ 125°C
瀹夎椤炲瀷锛� 琛ㄩ潰璨艰
灏佽/澶栨锛� 8-SOIC锛�0.154"锛�3.90mm 瀵級
渚涙噳(y墨ng)鍟嗚ō(sh猫)鍌欏皝瑁濓細 8-SOIC
鍖呰锛� 甯跺嵎 (TR)
ISL28110, ISL28210
16
FN6639.3
November 29, 2012
Power Dissipation
It is possible to exceed the +150掳C maximum junction
temperatures under certain load and power supply conditions. It
is therefore important to calculate the maximum junction
temperature (TJMAX) for all applications to determine if power
supply voltages, load conditions, or package type need to be
modified to remain in the safe operating area. These parameters
are related using Equation 1:
where:
PDMAXTOTAL is the sum of the maximum power dissipation of
each amplifier in the package (PDMAX)
PDMAX for each amplifier can be calculated using Equation 2:
where:
TMAX = Maximum ambient temperature
JA = Thermal resistance of the package
PDMAX = Maximum power dissipation of 1 amplifier
VS = Total supply voltage
IqMAX = Maximum quiescent supply current of 1 amplifier
VOUTMAX = Maximum output voltage swing of the application
RL = Load resistance
ISL28110 and ISL28210 SPICE Model
Figure 46 shows the SPICE model schematic and Figure 47 shows
the net list for the SPICE model. The model is a simplified version
of the actual device and simulates important AC and DC
parameters. AC parameters incorporated into the model are: 1/f
and flatband noise voltage, Slew Rate, CMRR, Gain and Phase. The
DC parameters are IOS, total supply current and output voltage
swing. The model uses typical parameters given in the 鈥淓lectrical
Specifications鈥� Table beginning on page 4. The AVOL is adjusted
for 125dB with the dominant pole at 7Hz. The CMRR is set 120dB,
f = 280kHz. The input stage models the actual device to present
an accurate AC representation. The model is configured for
ambient temperature of +25掳C.
Figures 48 through 61 show the characterization vs simulation
results for the Noise Voltage, Closed Loop Gain vs Frequency,
Small Signal 0.1V Step, Large Signal 5V Step Response, Open
Loop Gain Phase, CMRR and Output Voltage Swing for 卤5V and
卤15V supplies.
LICENSE STATEMENT
The information in this SPICE model is protected under the
United States copyright laws. Intersil Corporation hereby grants
users of this macro-model hereto referred to as 鈥淟icensee鈥�, a
nonexclusive, nontransferable licence to use this model as long
as the Licensee abides by the terms of this agreement. Before
using this macro-model, the Licensee should read this license. If
the Licensee does not accept these terms, permission to use the
model is not granted.
The Licensee may not sell, loan, rent, or license the macro-model,
in whole, in part, or in modified form, to anyone outside the
Licensee鈥檚 company. The Licensee may modify the macro-model
to suit his/her specific applications, and the Licensee may make
copies of this macro-model for use within their company only.
This macro-model is provided 鈥淎S IS, WHERE IS, AND WITH NO
WARRANTY OF ANY KIND EITHER EXPRESSED OR IMPLIED,
INCLUDING BUY NOT LIMITED TO ANY IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.鈥�
In no event will Intersil be liable for special, collateral, incidental,
or consequential damages in connection with or arising out of
the use of this macro-model. Intersil reserves the right to make
changes to the product and the macro-model without prior
notice.
FIGURE 45. UNITY-GAIN THD+N vs OUTPUT VOLTAGE vs
TEMPERATURE AT VS = 卤5V FOR 600惟 LOAD
0.0001
0.001
0.01
0.1
1
0
1
2
345
67
8
9
10
VP-P (V)
THD+N
(%)
VS = 卤5V
RL = 600
AV = 1
+25掳C
0掳C
-40掳C
+125掳C
+85掳C
TJMAX
TMAX JAxPDMAXTOTAL
+
=
(EQ. 1)
PDMAX
VS IqMAX VS
(
- VOUTMAX)
VOUTMAX
RL
----------------------------
+
=
(EQ. 2)
鐩搁棞(gu膩n)PDF璩囨枡
PDF鎻忚堪
160666-4 CONN UNINS RECPT 22-26AWG 0.110
N3627-6603 CONN HEADER 24POS STR LONG LATCH
929665-01-25-EU CONN HEADER 50POS .100 DUAL STR
961130-5900-AR-PT CONN HEADER R/A 30POS GOLD SMD
961242-6300-AR-TP CONN HEADER STR DL 42PS GOLD SMD
鐩搁棞(gu膩n)浠g悊鍟�/鎶€琛�(sh霉)鍙冩暩(sh霉)
鍙冩暩(sh霉)鎻忚堪
ISL28110FBZ-T7 鍔熻兘鎻忚堪:鏀惧ぇ鍣� IC 闁嬬櫦(f膩)宸ュ叿 ISL28110FBZ SINGLE PRECISION LW NOISE RoHS:鍚� 鍒堕€犲晢:International Rectifier 鐢�(ch菐n)鍝�:Demonstration Boards 椤炲瀷:Power Amplifiers 宸ュ叿鐢ㄤ簬瑭曚及:IR4302 宸ヤ綔闆绘簮闆诲:13 V to 23 V
ISL28110FBZ-T7A 鍔熻兘鎻忚堪:鏀惧ぇ鍣� IC 闁嬬櫦(f膩)宸ュ叿 ISL28110FBZ SINGLE PRECISION LW NOISE RoHS:鍚� 鍒堕€犲晢:International Rectifier 鐢�(ch菐n)鍝�:Demonstration Boards 椤炲瀷:Power Amplifiers 宸ュ叿鐢ㄤ簬瑭曚及:IR4302 宸ヤ綔闆绘簮闆诲:13 V to 23 V
ISL28110FRTBZ 鍒堕€犲晢:INTERSIL 鍒堕€犲晢鍏ㄧū:Intersil Corporation 鍔熻兘鎻忚堪:Precision Low Noise JFET Operational Amplifiers
ISL28110FRTZ 鍒堕€犲晢:INTERSIL 鍒堕€犲晢鍏ㄧū:Intersil Corporation 鍔熻兘鎻忚堪:Precision Low Noise JFET Operational Amplifiers
ISL28110FUBZ 鍒堕€犲晢:INTERSIL 鍒堕€犲晢鍏ㄧū:Intersil Corporation 鍔熻兘鎻忚堪:Precision Low Noise JFET Operational Amplifiers