13 FN7904.1 July 19, 2012 Functional Pin Descriptions Potentiometers Pins RHI
參數資料
型號: ISL23428UFVZ
廠商: Intersil
文件頁數: 5/21頁
文件大小: 0K
描述: IC DGTL POT 2CH 50K 14TSSOP
標準包裝: 960
系列: XDCP™
接片: 128
電阻(歐姆): 50k
電路數: 2
溫度系數: 標準值 65 ppm/°C
存儲器類型: 易失
接口: 4 線 SPI(芯片選擇)
電源電壓: 1.2 V ~ 5.5 V,1.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 14-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 14-TSSOP
包裝: 管件
ISL23428
13
FN7904.1
July 19, 2012
Functional Pin Descriptions
Potentiometers Pins
RHI AND RLI
The high (RHi, i = 0, 1) and low (RLi, i = 0, 1) terminals of the
ISL23428 are equivalent to the fixed terminals of a mechanical
potentiometer. RHi and RLi are referenced to the relative position
of the wiper and not the voltage potential on the terminals. With
WRi set to 127 decimal, the wiper will be closest to RHi, and with
the WRi set to 0, the wiper is closest to RLi.
RWI
RWi (i = 0, 1) is the wiper terminal, and it is equivalent to the
movable terminal of a mechanical potentiometer. The position of
the wiper within the array is determined by the WRi register.
Power Pins
VCC
Power terminal for the potentiometer section analog power
source. Can be any value needed to support voltage range of DCP
pins, from 1.7V to 5.5V, independent of the VLOGIC voltage.
Bus Interface Pins
SERIAL CLOCK (SCK)
This input is the serial clock of the SPI serial interface.
SERIAL DATA INPUT (SDI)
The SDI is a serial data input pin for SPI interface. It receives
operation code, wiper address and data from the SPI remote
host device. The data bits are shifted in at the rising edge of the
serial clock SCK, while the CS input is low.
FIGURE 21. WIPER LARGE SIGNAL SETTLING TIME
FIGURE 22. POWER-ON START-UP IN VOLTAGE DIVIDER MODE
FIGURE 23. 10k -3dB CUT OFF FREQUENCY
FIGURE 24. STANDBY CURRENT vs TEMPERATURE
Typical Performance Curves (Continued)
1V/DIV
0.2s/DIV
WIPER
CS RISING
0.5V/DIV
20s/DIV
VCC
WIPER
0.5V/DIV, 0.2s/DIV
-3dB FREQUENCY = 1.4MHz AT MIDDLE TAP
CH1: RH TERMINAL
CH2: RW TERMINAL
0
0.2
0.4
0.6
0.8
1.0
1.8
-40
-15
10
35
60
85
110
S
T
A
N
D
B
Y
C
U
R
E
N
T
I C
C
(
A
)
TEMPERATURE (°C)
VCC = 5.5V, VLOGIC = 5.5V
VCC = 1.7V, VLOGIC = 1.2V
1.6
1.4
1.2
相關PDF資料
PDF描述
ISL23445WFVZ-T7A IC DGTL POT QUAD 10K 20TSSOP
ISL23448WFVZ IC DGTL POT 4CH 10K 20TSSOP
ISL23511WFB8Z IC POT DGTL PB 32TP LN LP 8-SOIC
ISL23512WFRU10Z-TK IC POT DGTL PB 16TP LN LP 10TQFN
ISL31478EIBZ IC TXRX RS485 FAULT PROT 8SOIC
相關代理商/技術參數
參數描述
ISL23428UFVZ-T7A 功能描述:數字電位計 IC 128 TAPVOLATILE SPI DUAL RNG IND 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23428UFVZ-TK 功能描述:數字電位計 IC 128 TAP VOLATILE SPI DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23428WFRUZ-T7A 功能描述:數字電位計 IC 128 TAPVOLATILE SPI DUAL RNG IND 16LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23428WFRUZ-TK 功能描述:數字電位計 IC 128 TAP VOLATILE SPI DL FL RNG DCP 16LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23428WFVZ 功能描述:數字電位計 IC 128 TAP VOLATILE SPI DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel