13 FN7870.0 June 21, 2011 Functional Pin Descriptions Potentiometers Pins RHI
參數資料
型號: ISL23325WFRUZ-T7A
廠商: Intersil
文件頁數: 5/20頁
文件大?。?/td> 0K
描述: IC DGTL POT DUAL 10K 16UTQFN
標準包裝: 1
系列: XDCP™
接片: 256
電阻(歐姆): 10k
電路數: 2
溫度系數: 標準值 125 ppm/°C
存儲器類型: 易失
接口: I²C,2 線串口
電源電壓: 1.2 V ~ 5.5 V,1.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 16-UFQFN
供應商設備封裝: 16-UTQFN(2.6x1.8)
包裝: 標準包裝
其它名稱: ISL23325WFRUZ-T7ADKR
ISL23325
13
FN7870.0
June 21, 2011
Functional Pin Descriptions
Potentiometers Pins
RHI AND RLI
The high (RHi, i = 0, 1) and low (RLi, i = 0,1) terminals of the
ISL23325 are equivalent to the fixed terminals of a mechanical
potentiometer. RHi and RLi are referenced to the relative position
of the wiper and not the voltage potential on the terminals. With
WRi set to 255 decimal, the wiper will be closest to RHi, and with
the WR set to 0, the wiper is closest to RLi.
RWI
RWi (i = 0,1) is the wiper terminal, and it is equivalent to the
movable terminal of a mechanical potentiometer. The position of
the wiper within the array is determined by the WRi register.
VCC
Power terminal for the potentiometer section analog power
source. Can be any value needed to support voltage range of DCP
pins, from 1.7V to 5.5V, independent of the VLOGIC voltage.
Bus Interface Pins
SERIAL DATA INPUT/OUTPUT (SDA)
The SDA is a bi-directional serial data input/output pin for I2C
interface. It receives device address, wiper address and data
from an I2C external master device at the rising edge of the serial
clock SCL, and it shifts out data after each falling edge of the
serial clock.
SDA requires an external pull-up resistor, since it is an open drain
input/output.
FIGURE 21. WIPER LARGE SIGNAL SETTLING TIME
FIGURE 22. POWER-ON START-UP IN VOLTAGE DIVIDER MODE
FIGURE 23. 10k -3dB CUT OFF FREQUENCY
FIGURE 24. STANDBY CURRENT vs TEMPERATURE
Typical Performance Curves (Continued)
9TH CLOCK OF THE
DATA BYTE (ACK)
1V/DIV
0.2s/DIV
SCL
WIPER
0.5V/DIV
20s/DIV
VCC
WIPER
0.5V/DIV, 0.2s/DIV
-3dB FREQUENCY = 1.4MHz AT MIDDLE TAP
CH1: RH TERMINAL
CH2: RW TERMINAL
0
0.2
0.4
0.6
0.8
1.0
1.8
-40
-15
10
35
60
85
110
S
T
A
N
D
B
Y
C
U
R
E
N
T
I C
C
(
A
)
TEMPERATURE (°C)
VCC = 5.5V, VLOGIC = 5.5V
VCC = 1.7V, VLOGIC = 1.2V
1.6
1.4
1.2
相關PDF資料
PDF描述
D38999/24JE26PC CONN RCPT 26POS JAM NUT W/PINS
MS27468T21A41SB CONN RCPT 41POS JAM NUT W/SCKT
MS27484T24B35P CONN PLUG 128POS STRAIGHT W/PINS
M83723/91W1412N CONN PLUG 12POS STRAIGHT W/SCKT
ISL23325UFRUZ-T7A IC DGTL POT DUAL 50K 16UTQFN
相關代理商/技術參數
參數描述
ISL23325WFRUZ-TK 功能描述:數字電位計 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23325WFVZ 功能描述:數字電位計 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23325WFVZ-T7A 功能描述:數字電位計 IC 256 TAPVOLATILE I2C DUAL FL RNG IND 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23325WFVZ-TK 功能描述:數字電位計 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23328 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Dual, 128-Tap, Low Voltage Digitally Controlled Potentiometer (XDCPa?¢)