RESISTOR MODE (Measurements between RW and R
參數資料
型號： ISL22416UFRT10Z-TK
廠商： Intersil
文件頁數： 9/14頁
文件大?。?/td> 0K
描述： IC POT DGTL 128TP LN LP 10-TDFN
產品培訓模塊： Solutions for Industrial Control Applications
標準包裝： 1,000
系列： XDCP™
接片： 128
電阻（歐姆）： 50k
電路數： 1
溫度系數： 標準值 ±80 ppm/°C
存儲器類型： 非易失
接口： 4 線 SPI（芯片選擇）
電源電壓： 2.7 V ~ 5.5 V
工作溫度： -40°C ~ 125°C
安裝類型： 表面貼裝
封裝/外殼： 10-WFDFN 裸露焊盤
供應商設備封裝： 10-TDFN-EP（3x3）
包裝： 帶卷 (TR)
4
FN6227.2
September 9, 2009
RESISTOR MODE (Measurements between RW and RL with RH not connected, or between RW and RH with RL not connected)
RINL
(Note 14)
Integral Non-linearity
DCP register set between 10 hex and 7F
hex; monotonic over all tap positions;
W and U option
-1
1
MI
(Note 11)
RDNL
(Note 13)
Differential Non-linearity
W option
-1
1
MI
(Note 11)
U option
-0.5
0.5
MI
(Note 11)
Roffset
(Note 12)
Offset
W option
0
1
5
MI
(Note 11)
U option
0
0.5
2
MI
(Note 11)
Analog Specifications
Over recommended operating conditions, unless otherwise stated. Parameters with MIN and/or MAX limits are
100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization and are not
production tested. (Continued)
SYMBOL
PARAMETER
TEST CONDITIONS
MIN
TYP
(Note 4)
MAX
UNIT
Operating Specifications Over the recommended operating conditions, unless otherwise specified. Parameters with MIN and/or MAX
limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
SYMBOL
PARAMETER
TEST CONDITIONS
MIN
TYP
(Note 4)
MAX
UNIT
ICC1
VCC Supply Current (Volatile
Write/Read)
fSCK = 5MHz; (for SPI Active, Read and
Volatile Write states only)
0.5
mA
ICC2
VCC Supply Current (Non-volatile
Write/Read)
fSCK = 5MHz; (for SPI Active, Read and
Non-volatile Write states only)
3mA
ISB
VCC Current (Standby)
VCC = +5.5V @ +85°C, SPI interface in
standby state
5A
VCC = +5.5V @ +125°C, SPI interface in
standby state
7A
VCC = +3.6V @ +85°C, SPI interface in
standby state
3A
VCC = +3.6V @ +125°C, SPI interface in
standby state
5A
ISD
VCC Current (Shutdown)
VCC = +5.5V @ +85°C, SPI interface in
standby state
3A
VCC = +5.5V @ +125°C, SPI interface in
standby state
5A
VCC = +3.6V @ +85°C, SPI interface in
standby state
2A
VCC = +3.6V @ +125°C, SPI interface in
standby state
4A
ILkgDig
Leakage Current, at Pins SHDN, SCK,
SDI, SDO and CS
Voltage at pin from GND to VCC,
SDO is inactive
-1
1
A
tWRT
(Note 18)
Wiper Response Time
Wiper Response Time after SPI write to WR
register
1.5
s
tShdnRec
(Note 18)
DCP Recall Time from Shutdown
Mode
From rising edge of SHDN signal to wiper
stored position and RH connection
1.5
s
SCK rising edge of last bit of ACR data byte
to wiper stored position and RH connection
1.5
s
VPOR
Power-on Recall Voltage
Minimum VCC at which memory recall occurs
2.0
2.6
V
VCC Ramp VCC Ramp Rate
0.2
V/ms
ISL22416
相關PDF資料
PDF描述
ISL22419UFU8Z-TK IC POT DGTL 128TP LN LP 8-MSOP
ISL22424WFV14Z IC POT DGTL 256TP LN LP 14-TSSOP
ISL22426WFV14Z IC POT DGTL 128TP LN LP 14-TSSOP
ISL22429WFU10Z-TK IC POT DGTL 128TP LN LP 10-MSOP
ISL22444TFV20Z IC POT DGTL 256TP LN LP 20-TSSOP
相關代理商/技術參數
參數描述
ISL22416UFU10Z 功能描述:數字電位計 IC 128 TAP FL RNG DCP 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL22416UFU10Z-TK 功能描述:數字電位計 IC 128 TAP FL RNG DCP 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL22416WFRT10Z 功能描述:數字電位計 IC 128 TAP FL RNG DCP 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL22416WFRT10Z-TK 功能描述:數字電位計 IC 128 TAP FL RNG DCP 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL22416WFU10Z 功能描述:數字電位計 IC 128 TAP FL RNG DCP 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*