參數資料
型號： ISD5116X
廠商： WINBOND ELECTRONICS CORP
元件分類： 音頻合成
英文描述： Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
中文描述： 960 SEC, SPEECH SYNTHESIZER WITH RCDG, UUC27
封裝： LEAD FREE, DIE-27
文件頁數： 33/57頁
文件大?。?/td> 735K
代理商： ISD5116X
October 2000
Page 32
RAC Waveform During Digital Erase
Sample Rate
t
RAC
t
RACL0
t
RACL1
4.0 kHz
2.5μs
0.5μs
2.0μs
5.3 kHz
1.87μs
0.37μs
1.50μs
6.4 kHz
1.56μs
0.31μs
1.25μs
8.0 kHz
1.25μs
0.25μs
1.00μs
INT (Interrupt)
INT is an open drain output pin. The ISD5116 interrupt pin goes LOW and stays LOW when an Overflow
(OVF) or End of Message (EOM) marker is detected. Each operation that ends in an EOM or OVF
generates an interrupt, including the message cueing cycles. The interrupt is cleared by a READ
STATUS instruction that will give a status byte out the SDA line.
XCLK (External Clock Input)
The external clock input for the ISD5116 product has an internal pull-down device. Normally, the ISD5116
is operated at one of four internal rates selected for its internal oscillator by the Sample Rate Select bits. If
greater precision is required, the device can be clocked through the XCLK pin at 4.096 MHz as described
in
Section 4.3
on page 22.
Because the anti-aliasing and smoothing filters track the Sample Rate Select bits, one must, for optimum
performance, maintain the external clock at 4.096 MHz
AND
set the Sample Rate Configuration bits to
one of the four values to properly set the filters to the correct cutoff frequency as described in
Section 4.3
on page 22. The duty cycle on the input clock is not critical, as the clock is immediately divided by two
internally. If the XCLK is not used, this input should be connected to V
SSD
.
External Clock Input Table
Required Clock
(kHz)
4096
4096
4096
4096
Duration
(Minutes)
8.73
10.9
13.1
17.5
Sample Rate
(kHz)
8.0
6.4
5.3
4.0
FLD1
FLD0
Filter Knee (kHz)
0
0
1
1
0
1
0
1
3.4
2.7
2.3
1.7
A0, A1 (Address Pins)
These two pins are normally strapped for the desired address that the ISD5116 will have on the I
2
C serial
interface. If there are four of these devices on the bus, then each must be strapped differently in order to
allow the Master device to address them individually. The possible addresses range from 80h to 87h,
depending upon whether the device is being written to, or read from, by the host. The ISD5116 has a 7-
bit slave address of which only A0 and A1 are pin programmable. The eighth bit (LSB) is the R/W bit.
Thus, the address will be 1000 0xy0 or 1000 0xy1. (See the
table in section 3.1.1
on page 9.)
.
25 μsec
1
.
25 μsec
相關PDF資料
PDF描述
ISG510065 CATV OUT-OF-BAND TUNER
ISG510067 DTV IF AGC AMPLIFIER
ISL12025 Real-Time Clock/Calendar with EEPROM(EEPROM實時時鐘/日歷)
ISL1209IU10 Low Power RTC with Battery Backed SRAM and Event Detection
ISL1209IU10Z-TK Hook-Up Wire; Conductor Size AWG:18; No. Strands x Strand Size:19 x 30; Jacket Color:Purple; Approval Bodies:UL; Approval Categories:UL AWM Style 1180; Passes VW-1 Flame Test; Cable/Wire MIL SPEC:MIL-W-16878/5 Type EE RoHS Compliant: Yes
相關代理商/技術參數
參數描述
ISD5216 制造商:WINBOND 制造商全稱:Winbond 功能描述:8 to 16 minutes voice record/playback device with integrated codec
ISD5216E 制造商:WINBOND 制造商全稱:Winbond 功能描述:8 to 16 minutes voice record/playback device with integrated codec
ISD5216EI 制造商:WINBOND 制造商全稱:Winbond 功能描述:8 to 16 minutes voice record/playback device with integrated codec
ISD5216EY 功能描述:IC VOICE REC/PLAY 8-16MIN 28TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISL5216 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5216EYI 功能描述:IC VOICE REC/PLAY 8-16MIN 28TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISL5216 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*