參數資料
型號： ISD5100
廠商： WINBOND ELECTRONICS CORP
英文描述： SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
中文描述： 單芯片1到16分鐘的語音記錄/播放設備數字存儲能力
文件頁數： 72/88頁
文件大?。?/td> 612K
代理商： ISD5100
ISD5100 – SERIES
- 72 -
10.5. I
2
C P
ROTOCOL
Since the I2C protocol allows multiple devices on the bus, each device must have an address. This
address is known as a “Slave Address”. A Slave Address consists of 7 bits, followed by a single bit
that indicates the direction of data flow. This single bit is 1 for a Write cycle, which indicates the data is
being sent from the current bus master to the device being addressed. This single bit is a 0 for a Read
cycle, which indicates that the data is being sent from the device being addressed to the current bus
master. For example, the valid Slave Addresses for the ISD5100 Series device, for both Write and
Read cycles, are shown in
section 7.3.1
on page 13 of this datasheet.
Before any data is transmitted on the I2C interface, the current bus master must address the slave it
wishes to transfer data to or from. The Slave Address is always sent out as the 1
st
byte following the
Start Condition sequence. An example of a Master transmitting an address to a ISD5100 Series slave
is shown below. In this case, the Master is writing data to the slave and the R/W bit is “0”, i.e. a Write
cycle. All the bits transferred are from the Master to the Slave, except for the indicated Acknowledge
bits. The following example details the transfer explained in
section 7.3.1
-
2
-
3
on pages 13-20 of this
datasheet
.
Master Transmits to Slave Receiver (Write) Mode
S
W A
A
A
A
P
SLAVE ADDRESS
COMMAND BYTE
High ADDR. BYTE
Low ADDR. BYTE
acknowledgement
from slave
acknowledgement
from slave
acknowledgement
from slave
acknowledgement
from slave
R/W
Start Bit
Stop Bit
A common procedure in the ISD5100 Series is the reading of the Status Bytes. The Read Status
condition in the ISD5100 Series is triggered when the Master addresses the chip with its proper Slave
Address, immediately followed by the R/W bit set to a “1” and without the Command Byte being sent.
This is an example of the Master sending to the Slave, immediately followed by the Slave sending
data back to the Master. The “N” not-acknowledge cycle from the Master ends the transfer of data
from the Slave. The following example details the transfer explained in
section 7.3.1
on page 13 of this
datasheet.
相關PDF資料
PDF描述
ISD5116 Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116E Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116ED Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116EI Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116P Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
相關代理商/技術參數
參數描述
ISD5102EY 功能描述:IC VOICE REC/PLAY 1-2MN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5102EYI 功能描述:IC VOICE REC/PLAY 1-2MN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5102EYIR 功能描述:IC VOICE REC/PLAY 1-2MN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5102EYR 功能描述:IC VOICE REC/PLAY 1-2MN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5102SY 功能描述:IC VOICE REC/PLAY 1-2MN 28-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*