- 您現在的位置：買賣IC網 > PDF目錄384518 > ISD2575 (WINBOND ELECTRONICS CORP) ISD2560 PDF資料下載
參數資料
| 型號： | ISD2575 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 英文描述： | ISD2560 |
| 中文描述： | ISD2560 |
| 文件頁數： | 9/42頁 |
| 文件大?。?/td> | 380K |
| 代理商： | ISD2575 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
ISD2560/75/90/120
Publication Release Date: May 2003
- 9 -
Revision 1.0
PIN NO.
PIN NAME
SOIC/
PDIP
TSOP
FUNCTION
XCLK
26
5
External Clock
: The external clock input has an internal pull-down
device. The device is configured at the factory with an internal
sampling clock frequency centered to
±
1 percent of specification.
The frequency is then maintained to a variation of
±
2.25 percent
over the entire commercial temperature and operating voltage
ranges. If greater precision is required, the device can be clocked
through the XCLK pin as follows:
Part Number
Sample Rate
Required Clock
ISD2560
8.0 kHz
1024 kHz
ISD2575
6.4 kHz
819.2 kHz
ISD2590
5.3 kHz
682.7 kHz
ISD25120
4.0 kHz
512 kHz
These recommended clock rates should not be varied because the
antialiasing and smoothing filters are fixed, and aliasing problems
can occur if the sample rate differs from the one recommended.
The duty cycle on the input clock is not critical, as the clock is
immediately divided by two.
If the XCLK is not used, this input
must be connected to ground.
P/
R
27
6
Playback/Record
: The P/
R
input pin is latched by the falling edge
of the
CE
pin. A HIGH level selects a playback cycle while a LOW
level selects a record cycle. For a record cycle, the address pins
provide the starting address and recording continues until PD or
CE
is pulled HIGH or an overflow is detected (i.e. the chip is full).
When a record cycle is terminated by pulling PD or
CE
HIGH,
then End-Of-Message (
EOM
) marker is stored at the current
address in memory. For a playback cycle, the address inputs
provide the starting address and the device will play until an
EOM
marker is encountered. The device can continue to pass an EOM
marker if
CE
is held LOW in address mode, or in an Operational
Mode. (See Operational Modes section)
相關PDF資料 |
PDF描述 |
|---|---|
| ISD2590 | ISD2560 |
| ISD2532E | SINGLE-CHIP, MULTIPLE-MESSAGES, VOICE RECORD/PLAYBACK DEVICE 32-, 40-, 48-, AND 64-SECOND DURATION |
| ISD2532P | SINGLE-CHIP, MULTIPLE-MESSAGES, VOICE RECORD/PLAYBACK DEVICE 32-, 40-, 48-, AND 64-SECOND DURATION |
| ISD2532S | SINGLE-CHIP, MULTIPLE-MESSAGES, VOICE RECORD/PLAYBACK DEVICE 32-, 40-, 48-, AND 64-SECOND DURATION |
| ISD2532X | SINGLE-CHIP, MULTIPLE-MESSAGES, VOICE RECORD/PLAYBACK DEVICE 32-, 40-, 48-, AND 64-SECOND DURATION |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISD2575E | 功能描述:IC VOICE REC/PLAY 75-SEC 28-TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD2500 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD2575EI | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip Voice Record/Playback Devices 32-, 40-, 48-, 64-,60-,75,90-, and 120-Second Durations |
| ISD2575ER | 功能描述:IC VOICE REC/PLAY 75-SEC 28-TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD2500 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD2575G | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| ISD2575GI | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip Voice Record/Playback Devices 60-, 75-, 90-, and 120-Second Durations |
發布緊急采購，3分鐘左右您將得到回復。