參數資料
型號: IF180C52TXXX-36:RD
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 36 MHz, MICROCONTROLLER, PQFP44
封裝: PLASTIC, QFP-44
文件頁數: 13/60頁
文件大?。?/td> 5137K
20
8266D-MCU Wireless-06/12
ATmega128RFA1
Figure 8-8. On-Chip Data SRAM Access Cycles
clk
WR
RD
Data
Address
Address valid
T1
T2
T3
Compute Address
Read
Wr
ite
CPU
Memory Access Instruction
Next Instruction
8.3 EEPROM Data Memory
The ATmega128RFA1 contains 4K Bytes of data EEPROM memory. It is organized as
a separate data space. Read access is byte-wise. The access between the EEPROM
and the CPU is described in the following, specifying the EEPROM Address Registers,
the EEPROM Data Register, and the EEPROM Control Register.
For a detailed description of SPI, JTAG and Parallel data downloading to the EEPROM,
8.3.1 EEPROM Read Write Access
The EEPROM Access Registers are accessible in the I/O space, see "EEPROM
The write access time for the EEPROM is given in Table 8-3 below. A self-timing
function, however, lets the user software detect when the next byte can be written. If the
user code contains instructions that write the EEPROM, some precautions must be
taken. In heavily filtered power supplies, DVDD is likely to rise or fall slowly on power-
up/down. This causes the device for some period of time to run at a voltage lower than
specified as minimum for the clock frequency used. See "Preventing EEPROM
Corruption" on page 24 for details on how to avoid problems in these situations.
In order to prevent unintentional EEPROM writes, a specific write procedure must be
followed. See the description of the EEPROM Control Register for details on this,
When the EEPROM is read, the CPU is halted for four clock cycles before the next
instruction is executed. When the EEPROM is written, the CPU is halted for two clock
cycles before the next instruction is executed.
The calibrated oscillator is used to time the EEPROM accesses. The following table
lists the typical programming time for EEPROM access from the CPU.
Table 8-3. EEPROM Programming Time
Symbol
Typical Programming time
EEPROM write (from CPU)
4.5 ms
EEPROM erase (from CPU)
8.5 ms
相關PDF資料
PDF描述
IT80C52EXXX-30SHXXX:R 8-BIT, MROM, 30 MHz, MICROCONTROLLER, PQFP44
MC80C52CXXX-20/883D 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CDIP40
MR80C52CXXX-25SB 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44
MR80C52UXXX-25 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44
IS80C32U-S 8-BIT, 20 MHz, MICROCONTROLLER, PQCC44
相關代理商/技術參數
參數描述
IF-18-10 功能描述:XFRMR 115/230V 5V 3.6A 18VA PCB RoHS:是 類別:變壓器 >> 功率 系列:IF 標準包裝:1 系列:260 類型:標準 最大功率:65 VA 主線圈:雙 副線圈:三路,中心抽頭 在某電流時的串聯輸出電壓:500 VAC @ 85mA,5 VAC @ 2A,6.3 VAC @ 2A 在某電流時的并聯輸出電壓:- 安裝類型:底座安裝 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高(最大):66.80mm 端接類型:導線引線
IF-18-12 功能描述:XFRMR 115/230V 6V 3A 18VA PCB RoHS:是 類別:變壓器 >> 功率 系列:IF 標準包裝:1 系列:260 類型:標準 最大功率:65 VA 主線圈:雙 副線圈:三路,中心抽頭 在某電流時的串聯輸出電壓:500 VAC @ 85mA,5 VAC @ 2A,6.3 VAC @ 2A 在某電流時的并聯輸出電壓:- 安裝類型:底座安裝 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高(最大):66.80mm 端接類型:導線引線
IF-18-16 功能描述:XFRMR 115/230V 8V 2.3A 18VA PCB RoHS:是 類別:變壓器 >> 功率 系列:IF 標準包裝:1 系列:260 類型:標準 最大功率:65 VA 主線圈:雙 副線圈:三路,中心抽頭 在某電流時的串聯輸出電壓:500 VAC @ 85mA,5 VAC @ 2A,6.3 VAC @ 2A 在某電流時的并聯輸出電壓:- 安裝類型:底座安裝 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高(最大):66.80mm 端接類型:導線引線
IF-18-20 功能描述:XFRMR 115/230V 10V 1.8A 18VA PCB RoHS:是 類別:變壓器 >> 功率 系列:IF 標準包裝:1 系列:260 類型:標準 最大功率:65 VA 主線圈:雙 副線圈:三路,中心抽頭 在某電流時的串聯輸出電壓:500 VAC @ 85mA,5 VAC @ 2A,6.3 VAC @ 2A 在某電流時的并聯輸出電壓:- 安裝類型:底座安裝 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高(最大):66.80mm 端接類型:導線引線
IF-18-230 功能描述:XFRMR 115/230V 115V 160MA PCB RoHS:是 類別:變壓器 >> 功率 系列:IF 標準包裝:1 系列:260 類型:標準 最大功率:65 VA 主線圈:雙 副線圈:三路,中心抽頭 在某電流時的串聯輸出電壓:500 VAC @ 85mA,5 VAC @ 2A,6.3 VAC @ 2A 在某電流時的并聯輸出電壓:- 安裝類型:底座安裝 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高(最大):66.80mm 端接類型:導線引線