- 您現在的位置：買賣IC網 > PDF目錄9671 > IDT82V3001APVG (IDT, Integrated Device Technology Inc)IC PLL WAN W/SGL REF INP 56SSOP PDF資料下載
參數資料
| 型號： | IDT82V3001APVG |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 3/28頁 |
| 文件大小： | 0K |
| 描述： | IC PLL WAN W/SGL REF INP 56SSOP |
| 標準包裝： | 26 |
| 類型： | 時鐘/頻率發生器 |
| PLL： | 是 |
| 主要目的： | WAN |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:14 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 32.768MHz |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 56-BSSOP（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 56-SSOP |
| 包裝： | 管件 |
| 其它名稱： | 82V3001APVG IDT82V3001APVG-ND |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
FUNCTIONAL DESCRIPTION
11
October 15, 2008
IDT82V3001A
WAN PLL WITH SINGLE REFERENCE INPUT
Figure - 4 State Control Diagram
3.1.1
NORMAL MODE
Normal Mode is typically used when a slave clock source
synchronized to the network is required.
In this mode, the IDT82V3001A provides timing (C1.5o, C3o, C2o,
C4o, C6o, C8o, C16o and C32o) and synchronization (F0o, F8o, F16o,
F32o, TSP, RSP) signals, which are synchronous to the input reference.
The input reference signal has a nominal frequency of 8 kHz, 2.048 MHz
or 1.544 MHz.
From a reset condition, the IDT82V3001A will take 30 seconds at
most to make the output signals synchronous (phase locked) to the input
reference.
Whenever the IDT82V3001A enters Normal Mode, it will give an
indication by setting the NORMAL pin to high.
3.1.2
FAST LOCK MODE
Fast Lock Mode is a submode of Normal Mode. It is used to allow the
IDT82V3001A to lock to a reference more quickly than Normal Mode will
do. Typically, the DPLL will lock to the input reference within 500 ms if
the FLOCK pin is high.
3.1.3
HOLDOVER MODE
Holdover Mode is typically used for short duration (e.g., 2 seconds)
while network synchronization is temporarily disrupted.
In Holdover Mode, the IDT82V3001A provides timing and
synchronization signals, which are not locked to the external reference
signal but based on storage techniques. The storage value is
determined while the device is in Normal Mode and locked to the
external reference signal.
In Normal Mode, when the output signal is locked to the input
reference signal, a numerical value corresponding to the output
frequency is stored alternately in two memory locations every 30 ms.
When the device is switched into Holdover Mode, the stored value in
memory from between 30 ms and 60 ms is used to set the output
frequency of the device.
The frequency accuracy in Holdover Mode is ±0.025 ppm, which
corresponds to the worst case of 18 frame (125 s per frame) slips in 24
hours. This meets AT&T TR62411 requirement of ±0.37 ppm (255 frame
slips per 24 hours).
The HOLDOVER pin will be set to logic high whenever the
IDT82V3001A goes into Holdover Mode.
S2
Auto - Holdover
Mode_sel1=0
Mode_sel0=0
S1
Normal
Mode_sel1=0
Mode_sel0=0
S3
Holdover
Mode_sel1=0
Mode_sel0=1
S0
Freerun
Mode_sel1=1
Mode_sel0=0
(Invalid Input Reference Signal)
(Valid Input Reference Signal)
Au
to
TIE
Di
sa
ble
Au
to
TIE
Di
sa
ble
Auto TIE Disable
Auto
TIE
Dis
able
Auto
TIE
Disa
ble
Auto
TI
E D
isa
ble
TIE
D
isable
(TI
E_e
n =
L)
Au
toT
IE D
isab
le
TIE
Ena
ble
(TIE
_e
n =
H)
Reset *
TIE Enable (TIE_en = H)
(Valid Input Reference Signal)
TIE Disable (TIE_en = L)
* Note: After reset, Mode_sel1 and Mode_sel0 should be initially set to '10' or '00'.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-B40-MW-F3 | CONVERTER MOD DC/DC 5V 100W |
| ICS874005AG-04LF | IC PCI EXPRSS/JITT ATTEN 24TSSOP |
| VE-B40-MW-F2 | CONVERTER MOD DC/DC 5V 100W |
| ICS8741004AGLF | IC PCI EXPRSS/JITT ATTEN 24TSSOP |
| ICS9DB306BLLF | IC JITTER ATTENUATOR 28TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IDT82V3001APVG8 | 功能描述:IC PLL WAN W/SGL REF INP 56-SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT |
| IDT82V3002A | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL WITH DUAL REFERENCE INPUTS |
| IDT82V3002A_08 | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL WITH DUAL REFERENCE INPUTS |
| IDT82V3002A-01PVG | 功能描述:IC PLL WAN T1/E1 56SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT |
| IDT82V3002A-01PVG8 | 制造商:Integrated Device Technology Inc 功能描述:IC PLL WAN T1/E1 56SSOP |
發布緊急采購，3分鐘左右您將得到回復。