參數資料
型號： IDT723616L15PFG
廠商： IDT, Integrated Device Technology Inc
文件頁數： 2/26頁
文件大?。?/td> 0K
描述： IC FIFO 64X36X2 15NS 128TQFP
標準包裝： 72
系列： 7200
功能： 同步
存儲容量： 4.6K（64 x 36 x2）
數據速率： 67MHz
訪問時間： 15ns
電源電壓： 4.5 V ~ 5.5 V
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 128-LQFP
供應商設備封裝： 128-TQFP（14x20）
包裝： 托盤
10
COMMERCIALANDINDUSTRIAL
TEMPERATURERANGES
IDT723616 CMOS TRIPLE BUS SyncFIFO
WITH
BUS-MATCHING AND BYTE SWAPPING 64 x 36 x 2
TABLE 4 — PORT-C ENABLE FUNCTION TABLE
NOTE:
1. At no time during the operation of the FIFO is it permissible to apply a LOW logic level simultaneously to both SIZ0 and SIZ1, nor is it permissible to apply a HIGH logic level
simultaneously to both these inputs. These state combinations are reserved.
WENC
SIZ1, SIZ0
CLKC
C0-C17 Inputs
Port Functions
L
X
In High-Impedance State
None
H
One or the other LOW(1)
↑
In High-Impedance State
FIFO2 write
SIGNALDESCRIPTIONS
RESET
The IDT723616 is reset by taking the reset (
RST) input LOW for at least
four Port A clock (CLKA), four Port B clock (CLKB) and four Port C clock
(CLKC) LOW-to-HIGH transitions. The reset input can switch asynchro-
nously to the clocks. A device reset initializes the internal read and write
pointers of each FIFO and forces the full flags (
FFA, FFC) LOW, the empty
flags (
EFA, EFB) LOW, the Almost-Empty flags (AEA, AEB) LOW and the
Almost-Full flags (
AFA, AFC) HIGH. After a reset, FFA is set HIGH after
two LOW-to-HIGH transitions of CLKA and FFC is set HIGH after two
LOW-to-HIGH transitions of CLKC. The device must be reset after power
up before data is written to its memory.
A LOW-to-HIGH transition on the
RST input loads the Almost-Full and
Almost-Empty Offset register (X) with the values selected by the flag-
select (FS0, FS1) inputs. The values that can be loaded into the registers
are shown in Table 1.
TABLE 2 — PORT-A ENABLE FUNCTION TABLE
FIFO WRITE/READ OPERATION
The state of Port A data A0-A35 outputs is controlled by the Port A chip
select (
CSA)andthePortAwrite/readselect(W/RA).TheA0-A35outputsare
in the high-impedance state when either
CSA or W/RA is HIGH. The A0-A35
outputs are active when both CSA and W/
RA are LOW. Data is loaded into
FIFO1 from the A0-A35 inputs on a LOW-to-HIGH transition of CLKA when
CSA is LOW, W/RA is HIGH, ENA is HIGH, and FFA is HIGH. Data is read
fromFIFO2totheA0-A35outputsbyaLOW-to-HIGHtransitionofCLKAwhen
CSA is LOW, W/
RA is LOW, ENA is HIGH, and EFA is HIGH (see Table 2).
The state of the Port B data (B0-B17) outputs is controlled by Port B read
select (RENB). The B0-B17 outputs are in the high-impedance state when
REN is LOW. The B0-B17 outputs are active when REN IS HIGH. Data is
read from FIFO1 to the B0-B17 outputs by a LOW-to-HIGH transition of
CLKB when RENB is HIGH,
EFB is HIGH, and either SIZ0 or SIZ1 is LOW
(see Table 3).
Data is loaded into FIFO2 from the C0-C17 inputs on a LOW-to-HIGH
transition of CLKC when WENC is HIGH,
FFC is HIGH, and either SIZ0 or
SIZ1 is LOW (see Table 4).
ThesetupandholdtimeconstraintstothePortClocksforthePortAchipselect
(CSA) and write/read selects (W/
RA, RENB, WENC) are only for enabling
write and read operations and are not related to high-impedance control of the
data outputs. If a port enable is LOW during a clock cycle, the Port Chip select
(for Port A) and write/read select (for all ports) can change states during the
setup and hold time window of the cycle.
TABLE 1 — FLAG PROGRAMMING
TABLE 3 — PORT-B ENABLE FUNCTION TABLE
NOTE:
1. At no time during the operation of the FIFO is it permissible to apply a LOW logic level simultaneously to both SIZ0 and SIZ1, nor is it permissible to apply a HIGH logic level
simultaneously to both these inputs. These state combinations are reserved.
ALMOST-FULL AND
FS1
FS0
RST
ALMOST-EMPTY FLAG
OFFSET REGISTER (X)
HH
↑
16
HL
↑
12
LH
↑
8
LL
↑
4
CSA
W/
RA
ENA
CLKA
A0-A35 Outputs
Port Functions
H
X
In High-Impedance State
None
L
H
L
X
In High-Impedance State
None
LH
H
↑
In High-Impedance State
FIFO1 Write
L
X
Active, FIFO2 Output Register
None
LL
H
↑
Active, FIFO2 Output Register
FIFO2 Read
RENB
SIZ1, SIZ0
CLKB
B0-B17 Outputs
Port Functions
L
X
In High-Impedance State
None
H
One or the other LOW(1)
↑
Active, FIFO1 Output Register
FIFO1 read
相關PDF資料
PDF描述
IDT723642L15PQFGI IC FIFO SYNC 2048X36 132QFP
IDT723643L12PF IC FIFO SYNC 1024X36 128QFP
IDT723644L12PF IC FIFO SYNC 2048X36 128QFP
IDT723646L12PF IC FIFO SYNC 2048X36 128QFP
IDT723651L20PQFI IC FIFO SYNC 2048X36 132QFP
相關代理商/技術參數
參數描述
IDT723616L15PFG8 制造商:Integrated Device Technology Inc 功能描述:IC FIFO TRPL BUS 64X36X2 128QFP
IDT723616L20PF 功能描述:IC FIFO TRPL BUS 64X36X2 128QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
IDT723616L20PF8 功能描述:IC FIFO TRPL BUS 64X36X2 128QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
IDT723616L20PFI 功能描述:IC FIFO TRPL BUS 64X36X2 128QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
IDT723616L20PFI8 功能描述:IC FIFO TRPL BUS 64X36X2 128QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*