- 您現在的位置：買賣IC網 > PDF目錄360784 > ICS9342 133MHz Clock Generator and Integrated Buffer for PowerPC⑩ PDF資料下載
參數資料
| 型號： | ICS9342 |
| 英文描述： | 133MHz Clock Generator and Integrated Buffer for PowerPC⑩ |
| 中文描述： | 133MHz的時鐘發生器和集成緩沖器，用于PowerPC的⑩ |
| 文件頁數： | 7/10頁 |
| 文件大?。?/td> | 175K |
| 代理商： | ICS9342 |
ICS9342
Third party brands and names are the property of their respective owners.
Fig. 1
Shared Pin Operation -
Input/Output Pins
The I/O pins designated by (input/output) on the ICS9342
serve as dual signal functions to the device. During initial
power-up, they act as input pins. The logic level (voltage)
that is present on these pins at this time is read and stored
into a 5-bit internal data latch. At the end of Power-On reset,
(see AC characteristics for timing values), the device changes
the mode of operations for these pins to an output function.
In this mode the pins produce the specified buffered clocks
to external loads.
To program (load) the internal configuration register for
these pins, a resistor is connected to either the VDD (logic 1)
power supply or the GND (logic 0) voltage potential. A 10
Kilohm (10K) resistor is used to provide both the solid
CMOS programming voltage needed during the power-up
programming period and to provide an insignificant load on
the output clock during the subsequent operating period.
Via to
VDD
Clock trace to load
Series Term. Res.
Programming
Header
Via to Gnd
Device
Pad
2K
8.2K
Figure 1 shows a means of implementing this function
when a switch or 2 pin header is used. With no jumper is
installed the pin will be pulled high. With the jumper in
place the pin will be pulled low. If programmability is not
necessary, than only a single resistor is necessary. The
programming resistors should be located close to the series
termination resistor to minimize the current loop area. It is
more important to locate the series termination resistor
close to the driver than the programming resistor.
相關PDF資料 |
PDF描述 |
|---|---|
| ICS93701 | DDR Phase Lock Loop Clock Driver |
| ICS93701YGT | DDR Phase Lock Loop Clock Driver |
| ICS93705 | DDR Phase Lock Loop Zero Delay Clock Buffer |
| ICS93705YF-T | DDR Phase Lock Loop Zero Delay Clock Buffer |
| ICS93712YF-PPP-T | 2 DIMM DDR Fanout Buffer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS9342AFLF | 制造商:Integrated Device Technology Inc 功能描述: |
| ICS9342YF-T | 制造商:ICS 制造商全稱:ICS 功能描述:133MHz Clock Generator and Integrated Buffer for PowerPC⑩ |
| ICS93701 | 制造商:ICS 制造商全稱:ICS 功能描述:DDR Phase Lock Loop Clock Driver |
| ICS93701YGT | 制造商:ICS 制造商全稱:ICS 功能描述:DDR Phase Lock Loop Clock Driver |
| ICS93705 | 制造商:ICS 制造商全稱:ICS 功能描述:DDR Phase Lock Loop Zero Delay Clock Buffer |
發布緊急采購，3分鐘左右您將得到回復。