參數資料
型號: ICS512
英文描述: LOCO⑩ PLL Clock Multiplier
中文描述: 本地⑩PLL時鐘乘法器
文件頁數: 4/4頁
文件大?。?/td> 46K
代理商: ICS512
ICS512
LOCO PLL Clock Multiplier
MDS 512 C
Integrated Circuit Systems, Inc. 525 Race Street San Jose CA95126(408) 295-9800tel www.icst.com
4
Revision 061900
Printed 11/13/00
While the information presented herein has been checked for both accuracy and reliability, ICS assumes no responsibility for either its use or for the infringement of any patents or
other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied. This product is intended for use in normal commercial applications.
Any other applications such as those requiring extended temperature range, high reliability, or other extraordinary environmental requirements are not recommended without
additional processing by ICS. ICS reserves the right to change any circuitry or specifications without notice. ICS does not authorize or warrant any ICS product for use in life
support devices or critical medical instruments.
Ordering Information
Part/Order Number
ICS512M
ICS512MT
ICS512MI
ICS512MIT
Marking
ICS512M
ICS512M
ICS512I
ICS512I
Package
8 pin SOIC
Temperature
0 to 70 °C
0 to 70 °C
-40 to +85 °C
-40 to +85 °C
8 pin SOIC on tape and reel
8 pin SOIC
8 pin SOIC on tape and reel
External Components / Crystal Selection
The ICS512 requires a 0.01μF decoupling capacitor to be connected between VDD and GND. It must be
connected close to the ICS512 to minimize lead inductance. No external power supply filtering is required
for this device. A 33
terminating resistor can be used next to the CLK and REF pins. The total on-chip
capacitance is approximately 15 pF, so a parallel resonant, fundamental mode crystal should be used. For
crystals with a specified load capacitance greater than 15 pF, crystal capacitors should be connected from
each of the pins X1 and X2 to Ground as shown in the Block Diagram on page 1. The value (in pF) of
these crystal caps should be = (C
L
-15)*2, where C
L
is the crystal load capacitance in pF. These external
capacitors are only required for applications where the exact frequency is critical. For a clock input,
connect to X1 and leave X2 unconnected (no capacitors on either).
Package Outline and Package Dimensions
(For current dimensional specifications, see JEDEC 95.)
LOCO is a trademark of ICS
B
D
E
H
e
A1
C
A
h x 45°
L
INDEX
AREA
1
2
8 pin SOIC
Inches
Min
0.0532
0.0040
0.0130
0.0075
0.1890
0.1497
.050 BSC
0.2284
0.0099
0.0160
Millimeters
Min
1.35
0.10
0.33
0.19
4.80
3.80
1.27 BSC
5.80
0.25
0.41
Symbol
A
A1
B
C
D
E
e
H
h
L
Max
0.0688
0.0098
0.0200
0.0098
0.1968
0.1574
Max
1.75
0.24
0.51
0.24
5.00
4.00
0.2440
0.0195
0.0500
6.20
0.50
1.27
相關PDF資料
PDF描述
ICS512M LOCO⑩ PLL Clock Multiplier
ICS512MI LOCO⑩ PLL Clock Multiplier
ICS512MIT LOCO⑩ PLL Clock Multiplier
ICS512MT LOCO⑩ PLL Clock Multiplier
ICS513 LOCO⑩ PLL Clock Generator
相關代理商/技術參數
參數描述
ICS512M 功能描述:IC PLL CLOCK MULTIPLIER 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:LOCO™ 產品變化通告:Product Discontinuation 04/May/2011 標準包裝:96 系列:- 類型:時鐘倍頻器,零延遲緩沖器 PLL:帶旁路 輸入:LVTTL 輸出:LVTTL 電路數:1 比率 - 輸入:輸出:1:8 差分 - 輸入:輸出:無/無 頻率 - 最大:133.3MHz 除法器/乘法器:是/無 電源電壓:3 V ~ 3.6 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:管件 其它名稱:23S08-5HPGG
ICS512MI 功能描述:IC PLL CLOCK MULTIPLIER 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:LOCO™ 產品變化通告:Product Discontinuation 04/May/2011 標準包裝:96 系列:- 類型:時鐘倍頻器,零延遲緩沖器 PLL:帶旁路 輸入:LVTTL 輸出:LVTTL 電路數:1 比率 - 輸入:輸出:1:8 差分 - 輸入:輸出:無/無 頻率 - 最大:133.3MHz 除法器/乘法器:是/無 電源電壓:3 V ~ 3.6 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:管件 其它名稱:23S08-5HPGG
ICS512MILF 功能描述:IC CLK MULTIPLIER PLL 8-SOIC RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:LOCO™ 標準包裝:2,000 系列:- 類型:PLL 頻率合成器 PLL:是 輸入:晶體 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:1 差分 - 輸入:輸出:無/無 頻率 - 最大:1GHz 除法器/乘法器:是/無 電源電壓:4.5 V ~ 5.5 V 工作溫度:-20°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-LSSOP(0.175",4.40mm 寬) 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:NJW1504V-TE1-NDNJW1504V-TE1TR
ICS512MILFT 功能描述:IC CLK MULTIPLIER PLL 8-SOIC RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:LOCO™ 標準包裝:2,000 系列:- 類型:PLL 頻率合成器 PLL:是 輸入:晶體 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:1 差分 - 輸入:輸出:無/無 頻率 - 最大:1GHz 除法器/乘法器:是/無 電源電壓:4.5 V ~ 5.5 V 工作溫度:-20°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-LSSOP(0.175",4.40mm 寬) 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:NJW1504V-TE1-NDNJW1504V-TE1TR
ICS512MIT 功能描述:IC PLL CLOCK MULTIPLIER 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:LOCO™ 產品變化通告:Product Discontinuation 04/May/2011 標準包裝:96 系列:- 類型:時鐘倍頻器,零延遲緩沖器 PLL:帶旁路 輸入:LVTTL 輸出:LVTTL 電路數:1 比率 - 輸入:輸出:1:8 差分 - 輸入:輸出:無/無 頻率 - 最大:133.3MHz 除法器/乘法器:是/無 電源電壓:3 V ~ 3.6 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:管件 其它名稱:23S08-5HPGG