- 您現在的位置：買賣IC網 > PDF目錄384467 > HY5DU56822CT-D (Hynix Semiconductor Inc.) 256M-P DDR SDRAM PDF資料下載
參數資料
| 型號： | HY5DU56822CT-D |
| 廠商： | Hynix Semiconductor Inc. |
| 英文描述： | 256M-P DDR SDRAM |
| 中文描述： | 256M磷DDR SDRAM內存 |
| 文件頁數： | 20/34頁 |
| 文件大?。?/td> | 248K |
| 代理商： | HY5DU56822CT-D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
Rev. 0.3 / Oct. 2003 20
HY5DU56422CT-D4/ D43
HY5DU56822CT-D4/ D43
HY5DU561622CT-D4/ D43
CAS LATENCY
The Read latency, or CAS latency, is the delay, in clock cycles, between the registration of a Read command and the
availability of the first burst of output data. The latency is 3 clocks.
If a Read command is registered at clock edge n, and the latency is m clocks, the data is available nominally coincident
with clock edge n + m.
Reserved states should not be used as unknown operation or incompatibility with future versions may result.
DLL RESET
The DLL must be enabled for normal operation. DLL enable is required during power up initialization, and upon return-
ing to normal operation after having disabled the DLL for the purpose of debug or evaluation. The DLL is automatically
disabled when entering self refresh operation and is automatically re-enabled upon exit of self refresh operation. Any
time the DLL is enabled, 200 clock cycles must occur to allow time for the internal clock to lock to the externally
applied clock before an any command can be issued.
OUTPUT DRIVER IMPEDANCE CONTROL
The normal drive strength for all outputs is specified to be SSTL_2, Class II. Hynix also supports a half strength driver
option, intended for lighter load and/or point-to-point environments. Selection of the half strength driver option will
reduce the output drive strength by 50% of that of the full strength driver. I-V curves for both the full strength driver
and the half strength driver are included in this document.
相關PDF資料 |
PDF描述 |
|---|---|
| HY5DU56822CT-D4 | 256M-P DDR SDRAM |
| HY5DU56822CT-D43 | 256M-P DDR SDRAM |
| HY5DU561622CT-D | 256M-P DDR SDRAM |
| HY5PS1G1631CFP | 1Gb DDR2 SDRAM |
| HY5PS1G1631CFP-C4 | 1Gb DDR2 SDRAM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HY5DU56822CT-D4 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:256M-P DDR SDRAM |
| HY5DU56822CT-D43 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:256M-P DDR SDRAM |
| HY5DU56822DLT | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:256Mb DDR SDRAM |
| HY5DU56822DLTP | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:256M DDR SDRAM (268,435,456-bit CMOS Double Data Rate(DDR) Synchronous DRAM) |
| HY5DU56822DLTP-H | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:256M DDR SDRAM (268,435,456-bit CMOS Double Data Rate(DDR) Synchronous DRAM) |
發布緊急采購，3分鐘左右您將得到回復。