- 您現在的位置：買賣IC網 > PDF目錄384451 > HV301 (Supertex, Inc.) Hotswap, Controllers with Circuit Breaker PDF資料下載
參數資料
| 型號： | HV301 |
| 廠商： | Supertex, Inc. |
| 英文描述： | Hotswap, Controllers with Circuit Breaker |
| 中文描述： | 熱插拔控制器與斷路器 |
| 文件頁數： | 1/21頁 |
| 文件大?。?/td> | 664K |
| 代理商： | HV301 |
HV301
HV311
08/26/02
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the
Supertex website: http://www.supertex.com. For complete liability information on all Supertex products, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.
Features
±
10V to
±
90V Operation
Built-in “normally on” turn-on clamp eliminates components
UV/OV Lock Out & Power-on-Reset(POR) for Debouncing
Sense resistor programmed circuit breaker
Programmable circuit breaker holdoff
Inrush control using either: i) servo or ii) feedback cap
Feedback to Ramp pin means no Gate Clamp needed
Application solution for input voltage step (diode “ORing”)
Programmable Auto-Retry (tens of seconds if desired)
Auto-Retry or Latched Operation
Enable through Open Drain interface to UV or OV
Low Power, <0.6mA , <0.4mA Sleep Mode
PWRGD Flag
Small SOIC-8 Package
Applications
-48V Central Office Switching
-24V Cellular and Fixed Wireless Systems
-24V PBX Systems
Line Cards
-48V Powered Ethernet for VoIP
Distributed Power Systems
Power Supply Control
+48V Storage Networks
Electronic Circuit Breaker
General Description
The Supertex HV301 and HV311 Hotswap Controllers provide
control of power supply connection during insertion of cards or
modules into live backplanes. They may be used in systems
where active control is implemented in the negative lead of
supplies ranging from
±
10V to
±
90V.
During initial power application the gate of the external pass
device is clamped low to suppress contact bounce glitches by a
“normally on” circuit which does not require initialization of the
IC. Thereafter the UV/OV supervisors and power-on-reset work
together to suppress gate turn on until mechanical bounce has
ended. The HV301/311 then control the current inrush limit to a
programmed level using one of two possible methods, i) servo
control or ii) a drain to ramp capacitor. The above methods
eliminate the need for extra hold-off or current limiting compo-
nents.
The devices also include an electronic circuit breaker,
programmed by a sense resistor.
After the load capacitance has fully charged, the HV301/311 will
transition into a low power mode, and enable the open drain
PWRGD. In low power mode the HV301/311 continues to moni-
tor the input voltage and monitor the current level. If a load fault
occurs, the electronic circuit breaker will trip, the pass
element will be turned off, and the PWRGD will return to an
(continued on Page 21)
VDD
UV
OV
VEE
SENSE
GATE
-48V
R4
12.5m
R1
487k
R2
6.81k
R3
9.76k
Q1
IRF530
Cload
+5V
HV301/
HV311
8
3
2
5
4
COM
DC/DC
PWM
CONVERTER
1
GND
PWRGD / PWRGD
ENABLE / ENABLE
6
RAMP
7
C1
10nF
C2
-48V
Notes: 1. Undervoltage Shutdown (UV) set to 35V.
2. Overvoltage Shutdown (OV) set to 65V.
3. Current Limit set to -1A.
4. CB set to 8A.
Typical Application Circuit
0.75nF
Hotswap, Controllers with Circuit Breaker
(Negative Supply Rail)
Demo Kit
Available
相關PDF資料 |
PDF描述 |
|---|---|
| HV301LG | Hotswap, Controllers with Circuit Breaker |
| HV311 | Hotswap, Controllers with Circuit Breaker |
| HV311LG | Hotswap, Controllers with Circuit Breaker |
| HV302 | Sequencing Hotswap Controllers |
| HV302DB1 | Hotswap Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HV301_05 | 制造商:SUPERTEX 制造商全稱:SUPERTEX 功能描述:Hot Swap Controller (Negative Supply Rail) |
| HV301DB2 | 功能描述:電源管理IC開發工具 HV301 Demo Brd RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| HV301LG | 功能描述:熱插拔功率分布 Active High RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| HV301LG-G | 功能描述:熱插拔功率分布 Active High RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| HV301LG-M908 | 功能描述:熱插拔功率分布 -10 to -90V Activ Hi RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。