- 您現在的位置：買賣IC網 > PDF目錄385407 > HT9315B (Holtek Semiconductor Inc.) 15-Memory Tone/Pulse Dialer PDF資料下載
參數資料
| 型號： | HT9315B |
| 廠商： | Holtek Semiconductor Inc. |
| 英文描述： | 15-Memory Tone/Pulse Dialer |
| 中文描述： | 15內存音頻/脈沖撥號器 |
| 文件頁數： | 3/27頁 |
| 文件大?。?/td> | 309K |
| 代理商： | HT9315B |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
Pin Description
Pin Name
I/O
Internal
Connection
Description
C1~C5
R1~R4
I/O
CMOS
IN/OUT
These pins form a 4 5 keyboard matrix which can perform keyboard input detection
and dialing specification setting functions. When on-hook (HKS=high) all the pins are
set high. While off-hook the column group (C1~C5) remains low and the row group
(R1~R4) is set high for key input detection.
An inexpensive single contact 4 5 keyboard can be used as an input device.
Pressingakeyconnectsasinglecolumntoasinglerow,andactuatesthesystemos-
cillator that results in a dialing signal output. If more than two keys are pressed at the
sametime,noresponseoccurs.Thekey-indebouncetimeis20ms.Refertothekey-
boardinformationforkeyboardarrangementandtothefunctionaldescriptionfordial-
ing specification selection.
X1
I
OSCILLATOR
The system oscillator consists of an inverter, a bias resistor and the necessary
load capacitor on chip. Connecting a standard 3.579545MHz crystal or ceramic
resonator to the X1 and X2 terminals can implement the oscillator function. The
oscillator is turned off in the standby mode, and is actuated whenever a keyboard
entry is detected.
X2
O
XMUTE
O
NMOS OUT
XMUTE is an NMOS open drain structure pulled to VSS during dialing signal
transmission. Otherwise, it is an open circuit. XMUTE is used to mute the speech
circuit when transmitting the dial signal.
HKS
I
CMOS IN
This pin is used to monitor the status of the hook-switch and its combination with
HFI/HDI can control the PO pin output to make or break the line.
HKS=VDD: On-hook state (PO=low). Except for HFI/HDI
(hand-free/hold-line control input), other functions are alldisabled.
HKS=VSS: Off-hookstate(PO=high).Thechipisinthestandbymodeandreadyto
receive the key input.
PO
O
CMOS OUT
This pin is a CMOS output structure which by receiving the HKS and HFO/HDO
signals, control the dialer to connect or disconnect the telephone line.
PO outputs a low to break line when HKS is high (on-hook) and HFO/HDO is low.
PO outputs a high to make line when HKS is low (off-hook) or HFO is high or HDO
is high.
During the off-hook state, this pin also outputs the dialing pulse train in pulse
mode dialing. While in the tone mode, this pin is always high.
MODE
I/O
CMOS
IN/OUT
This is a three-state input/output pin, use for dialing mode selection, either Tone
mode or Pulse mode, 10pps/20pps
MODE=VDD: Pulse mode, 10pps
MODE=OPEN: Pulse mode, 20pps
MODE=VSS: Tone mode
During the pulse mode dialing, switching this pin to the tone mode changes the
subsequent digit entry to tone mode. When the chips are in tone mode, switching
to pulse mode will also be recognized.
DTMF
O
CMOS OUT
This pin is active only when the chip transmits tone dialing signals. Otherwise, it
always outputs a low. The pin outputs tone signals to drive the external transmitter
amplifier circuit. The load resistor should not be less than 5k .
HDI
I
CMOS IN
Pull-High
This pin is a Schmitt trigger input structure. Active low. Applying a negative going
pulse to this pin can toggle the HDO output once.
An external RC network is recommended for input debouncing. The pull-high re-
sistance is 200k
typ.
HDO
O
CMOS OUT
The HDO is a CMOS output structure. Its output is toggle- controlled by a negative
transition on HDI. When HDO is toggled high, PO keeps high to hold the line. The
hold function can be released by setting HFO high or by an on/off hook operation
or by another HDI input. Refer to the functional description for the hold-line func-
tion.
HT9315 Series
Rev. 1.20
3
October 1, 2002
相關PDF資料 |
PDF描述 |
|---|---|
| HT9315BL | 15-Memory Tone/Pulse Dialer |
| HT9315C | 15-Memory Tone/Pulse Dialer |
| HT9315CL | 15-Memory Tone/Pulse Dialer |
| HT9315D | JT 55C 55#22D PIN PLUG |
| HT9315DL | 15-Memory Tone/Pulse Dialer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HT9315BI | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone/Pulse Telephone Dialer |
| HT9315BIT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone/Pulse Telephone Dialer |
| HT9315BL | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:15-Memory Tone/Pulse Dialer |
| HT9315BLT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone/Pulse Telephone Dialer |
| HT9315BT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone/Pulse Telephone Dialer |
發布緊急采購，3分鐘左右您將得到回復。