- 您現在的位置：買賣IC網 > PDF目錄370704 > HT17E11-300 (Electronic Theatre Controls, Inc.) TFT-LCD PRODUCT PDF資料下載
參數資料
| 型號： | HT17E11-300 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | TFT-LCD PRODUCT |
| 中文描述： | TFT - LCD的產品 |
| 文件頁數： | 8/22頁 |
| 文件大?。?/td> | 346K |
| 代理商： | HT17E11-300 |
PRODUCT GROUP
REV.
ISSUE DATE
TFT-LCD PRODUCT
P1
JAN. 09, ‘ 02
PAGE
SPEC. NUMBER
S864-1080
SPEC. TITLE
HT17E11-300 Preliminary Product Specification
8
OF
22
RASR 057-1
A4 (210 X 297)
Note:
1.
Viewing angle is the angle at which the contrast ratio is greater than 10. The viewing are
determined for the horizontal or 3, 9 o’ clock direction and the vertical or 6, 12 o’ clock direction
with respect to the optical axis which is normal to the LCD surface (See FIGURE 1 shown in
Appendix).
2.
Contrast measurements shall be made at viewing angle of
θ
= 0
°
and at the center of the LCD
surface. Luminance shall be measured with all pixels in the view field set first to white, then to
the dark (black) state. (See FIGURE 1 shown in Appendix) Luminance Contrast Ratio (CR) is
defined mathematically.
Luminance when displaying a white raster
Luminance when displaying a black raster
CR =
3.
Center Luminance of white is defined as the LCD surface. Luminance shall be measured with
all pixels in the view field set first to white. This measurement shall be taken at the locations
shown in FIGURE 2 for a total of the measurements per display.
4.
The White luminance uniformity on LCD surface is then expressed as :
Luminance of five points / Minimum Luminance of five points (See FIGURE 2 shown in
Appendix).
5.
The color chromaticity coordinates specified in Table 4. shall be calculated from the spectral
data measured with all pixels first in red, green, blue and white. Measurements shall be made at
the center of the panel.
6.
The electro-optical response time measurements shall be made as FIGURE 3 shown in
Appendix by switching the “data” input signal ON and OFF. The times needed for the
luminance to change from 10% to 90% is Td, and 90% to 10% is Tr.
7.
Cross-Talk of one area of the LCD surface by another shall be measured by comparing the
luminance (Y
A
) of a 25mm diameter area, with all display pixels set to a gray level, to the
luminance (Y
B
) of that same area when any adjacent area is driven dark. (See FIGURE 4
shown in Appendix).
Y = Maximum
相關PDF資料 |
PDF描述 |
|---|---|
| HT21PI25 | Microcontroller |
| GC21PC25 | Microcontroller |
| GC21PI25 | Microcontroller |
| HT21PC25 | Microcontroller |
| HT23C040H | CMOS 512K?8-Bit High Speed Mask ROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HT17G | 功能描述:整流器 1.0 Amp 800 Volt 30 Amp IFSM RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| HT17G R0 | 制造商:SKMI/Taiwan 功能描述:Diode Switching 800V 1A 2-Pin TS-1 T/R |
| HT18 | 功能描述:整流器 1.0 Amp 1000 Volt 30 Amp IFSM RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| HT18 R0 | 制造商:SKMI/Taiwan 功能描述:Diode Switching 1KV 1A 2-Pin TS-1 T/R |
| HT18_07 | 制造商:SUPERTEX 制造商全稱:SUPERTEX 功能描述:Electronic Telephone Line Switch |
發布緊急采購，3分鐘左右您將得到回復。