參數資料
型號： HIP6301VCB-T
廠商： INTERSIL CORP
元件分類： 穩壓器
英文描述： Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
中文描述： SWITCHING CONTROLLER, 1500 kHz SWITCHING FREQ-MAX, PDSO20
封裝： PLASTIC, MS-013AC, SOIC-20
文件頁數： 14/20頁
文件大小： 518K
代理商： HIP6301VCB-T
14
FN9034.2
December 27, 2004
current creates a voltage drop across R
IN
. This drop
increases the apparent V
CORE
voltage with increasing load
current, causing the system to decrease V
CORE
to maintain
balance at the FB pin. This is the desired “droop” voltage
used to maintain V
CORE
within limits under transient
conditions.
With a high dv/dt load transient, typical of high performance
microprocessors, the largest deviations in output voltage
occur at the leading and trailing edges of the load transient.
In order to fully utilize the output-voltage tolerance range, the
output voltage is positioned in the upper half of the range
when the output is unloaded and in the lower half of the
range when the controller is under full load. This droop
compensation allows larger transient voltage deviations and
thus reduces the size and cost of the output filter
components.
R
IN
should be selected to give the desired “droop” voltage at
the normal full load current 50
μ
A applied through the R
ISEN
resistor (or at a different full load current if adjusted as under
Overcurrent, Selecting R
ISEN
above).
R
IN
= Vdroop / 50
μ
A
For a Vdroop of 80mV, R
IN
= 1.6k
The AC feedback components, R
FB
and Cc, are scaled in
relation to R
IN
.
Current Balancing
The detected currents are also used to balance the phase
currents.
Each phase’s current is compared to the average of all
phase currents, and the difference is used to create an offset
in that phase’s PWM comparator. The offset is in a direction
to reduce the imbalance.
The balancing circuit can not make up for a difference in
r
DS(ON)
between synchronous rectifiers. If a FET has a
higher r
DS(ON)
, the current through that phase will be
reduced.
Figures 10 and 11 show the inductor current of a two phase
system without and with current balancing.
Inductor Current
The inductor current in each phase of a multi-phase buck
converter has two components. There is a current equal to
the load current divided by the number of phases (I
LT
/ n),
and a sawtooth current, (i
PK-PK
) resulting from switching.
The sawtooth component is dependent on the size of the
inductors, the switching frequency of each phase, and the
values of the input and output voltage. Ignoring secondary
effects, such as series resistance, the peak to peak value of
the sawtooth current can be described by:
Where: V
CORE
= DC value of the output or V
ID
voltage
V
IN
= DC value of the input or supply voltage
L = value of the inductor
F
SW
= switching frequency
Example: For V
CORE
= 1.6V,
V
IN
= 12V,
L = 1.3
μ
H,
F
SW
= 250kHz,
Then i
PK-PK
= 4.3A
The inductor, or load current, flows alternately from V
IN
through Q1 and from ground through Q2. The controller
samples the on-state voltage drop across each Q2 transistor
to indicate the inductor current in that phase. The voltage
drop is sampled 1/3 of a switching period, 1/F
SW
, after Q1 is
turned OFF and Q2 is turned on. Because of the sawtooth
current component, the sampled current is different from the
average current per phase. Neglecting secondary effects,
i
PK
PK
–
V
V
L
SW
(
)
V
2CORE
IN
–
----------------------------------------------------------------
=
0
5
10
15
20
25
A
FIGURE 10. TWO CHANNEL MULTIPHASE SYSTEM
WITH CURRENT BALANCING DISABLED
0
5
10
15
20
25
A
FIGURE 11. TWO CHANNEL MULTIPHASE SYSTEM WITH
CURRENT BALANCING ENABLED
HIP6301V, HIP6302V
相關PDF資料
PDF描述
HIP6301VCBZ Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6311A 150000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN
HIP6311ACB Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6311ACBZ Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6311ACBZ-T Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
相關代理商/技術參數
參數描述
HIP6301VCB-TS2490 制造商:Intersil Corporation 功能描述:
HIP6301VCBZ 功能描述:電流型 PWM 控制器 MULTI-PHS CNTRLR VID ON THE FLYINTEL VID RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
HIP6301VCBZA 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6301VCBZA-T 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6301VCBZ-T 功能描述:電流型 PWM 控制器 MULTI-PHS CNTRLR VID ON THE FLYINTEL VID RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*