- 您現在的位置：買賣IC網 > PDF目錄384422 > HIP6201 (Intersil Corporation) Transient Voltage Regulator(瞬變電壓穩壓器) PDF資料下載
參數資料
| 型號： | HIP6201 |
| 廠商： | Intersil Corporation |
| 英文描述： | Transient Voltage Regulator(瞬變電壓穩壓器) |
| 中文描述： | 瞬態電壓調節器（瞬變電壓穩壓器） |
| 文件頁數： | 3/9頁 |
| 文件大?。?/td> | 87K |
| 代理商： | HIP6201 |
2-443
Functional Pin Description
P
VCC
(Pin 1)
P
VCC
is the power source for the npn transistor output
device. P
VCC
is connected internally to V
CC
through a
resistor. Bulk capacitance should be placed between this pin
and PGND to minimize voltage deviations.
PGND (Pin 2)
PGND is power ground for the N-Channel MOSFET output
device. Tie this pin to the ground plane of the circuit board.
GND (Pin 3)
GND is signal ground for the IC. Tie this pin to the ground
plane of the circuit board.
V
CC
(Pin 4)
V
CC
provides bias power to the chip. It should be tied to
system 5V. Provide local decoupling to this pin.
CAP (Pin 5)
Connect a capacitor to GND to set the internal amplifiers’
on-time response to a rapid voltage change at the SNS pin.
SNS (Pin 6)
SNS is the remote sense of the output voltage to be
regulated. If the output voltage increases rapidly by greater
than 1.5%, the lower amplifier responds by turning on the N-
Channel MOSFET to sink current through the OUT pin to
PGND. If the output voltage decreases rapidly by greater
than 1%, the upper amplifier responds by turning on the npn
transistor to source current from P
VCC
to OUT.
OUT (Pin 7)
This pin is the output pin of the IC. Tie this pin directly to the
voltage to be regulated.
EN/OT or EN (Pin 8)
This pin is the only differentiation between the HIP6200 and
the HIP6201.
On the HIP6200, this pin is multiplexed. It is chip enable and
also an overtemperature indicator. When this pin is low, the
chip is disabled. If an overtemperature occurs, this pin will be
pulled low internally. Tie EN/OT to a pull-up resistor and
drive with an open collector signal.
On the HIP6201, this pin is chip enable only. Pulling it low
disables the IC. EN should be driven with a logic signal.
HIP6200, HIP6201
相關PDF資料 |
PDF描述 |
|---|---|
| HIP6200CB | Transient Voltage Regulator DeCAPitator⑩ |
| HIP6201CB | Transient Voltage Regulator DeCAPitator⑩ |
| HIP6301CBZ | Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller |
| HIP6301CBZA-T | Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller |
| HIP6301CBZ-T | Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HIP6201CB | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| HIP6201CB WAF | 制造商:Harris Corporation 功能描述: |
| HIP6211 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Dual Low Noise LDO in 3mm】3mm MLF⑩ |
| HIP6211-15UZ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Dual Low Noise LDO in 3mm】3mm MLF⑩ |
| HIP6211-15VZ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Dual Low Noise LDO in 3mm】3mm MLF⑩ |
發布緊急采購，3分鐘左右您將得到回復。