- 您現在的位置：買賣IC網 > PDF目錄367128 > HFBR1412K Low Cost, Miniature Fiber Optic Components with ST, SMA, SC and FC Ports PDF資料下載
參數資料
| 型號： | HFBR1412K |
| 英文描述： | Low Cost, Miniature Fiber Optic Components with ST, SMA, SC and FC Ports |
| 中文描述： | 低成本，微型光纖器件與ST，形狀記憶合金，SC和FC端口 |
| 文件頁數： | 22/31頁 |
| 文件大?。?/td> | 700K |
| 代理商： | HFBR1412K |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
67
HFBR-24X6 Low-Cost
125 MHz Receiver
Description
The HFBR-24X6 fiber optic
receiver is designed to operate
with the Hewlett-Packard HFBR-
14XX fiber optic transmitters and
50/125
μ
m, 62.5/125
μ
m, 100/
140
μ
m and 200
μ
m HCS
fiber
optic cable. Consistent coupling
into the receiver is assured by the
lensed optical system (Figure 1).
Response does not vary with fiber
size for core diameters of 100
μ
m
or less.
The receiver output is an analog
signal which allows follow-on
circuitry to be optimized for a
variety of distance/data rate
requirements. Low-cost external
components can be used to convert
the analog output to logic
compatible signal levels for various
data formats and data rates up to
175 MBd. This distance/data rate
tradeoff results in increased optical
power budget at lower data rates
which can be used for additional
distance or splices.
The HFBR-24X6 receiver contains
a PIN photodiode and low noise
transimpedance pre-amplifier
integrated circuit. The HFBR-24X6
receives an optical signal and
converts it to an analog voltage.
The output is a buffered emitter-
follower. Because the signal
amplitude from the HFBR-24X6
receiver is much larger than from a
simple PIN photodiode, it is less
susceptible to EMI, especially at
high signaling rates. For very noisy
environments, the conductive or
metal port option is recommended.
A receiver dynamic range of 23 dB
over temperature is achievable
(assuming 10
-9
BER).
The frequency response is typically
dc to 125 MHz. Although the
HFBR-24X6 is an analog receiver,
it is compatible with digital
systems. Please refer to
Application Bulletin 78 for simple
and inexpensive circuits that
operate at 155 MBd or higher.
The recommended ac coupled
receiver circuit is shown in Figure
12. It is essential that a 10 ohm
resistor be connected between pin
6 and the power supply, and a 0.1
μ
F ceramic bypass capacitor be
connected between the power
supply and ground. In addition, pin
6 should be filtered to protect the
Figure 11. Simplified Schematic Diagram.
Housed Product
Unhoused Product
receiver from noisy host systems.
Refer to AN 1038, 1065, or AB 78
for details.
CAUTION: The small junction sizes inherent to the design of these components increase the components’
susceptibility to damage from electrostatic discharge (ESD). It is advised that normal static precautions be
taken in handling and assembly of these components to prevent damage and/or degradation which may be
induced by ESD.
PIN FUNCTION
1
2*
3
4*
V
EE
SIGNAL
V
EE
V
CC
8
1
3
5
6
2
4
7
PIN NO. 1
INDICATOR
BOTTOM VIEW
6
2
3, 7
V
CC
ANALOG
SIGNAL
V
EE
PIN
1
2
3*
4
5
6
7*
8
FUNCTION
N.C.
SIGNAL
V
N.C.
N.C.
V
V
N.C.
* PINS 3 AND 7 ARE ELECTRICALLY
CONNECTED TO THE HEADER.
PINS 1, 4, 5, AND 8 ARE ISOLATED FROM
THE INTERNAL CIRCUITRY, BUT ARE
ELECTRICALLY CONNECTED TO EACH OTHER.
CC
BIAS & FILTER
CIRCUITS
V
CC
V
OUT
V
EE
6
2
3, 7
POSITIVE
SUPPLY
ANALOG
SIGNAL
NEGATIVE
SUPPLY
5.0
mA
300 pF
相關PDF資料 |
PDF描述 |
|---|---|
| HFBR1406HA | Circular Connector; MIL SPEC:MIL-C-26482, Series I, Crimp; Body Material:Aluminum; Series:PT06; No. of Contacts:16; Connector Shell Size:20; Connecting Termination:Crimp; Circular Shell Style:Straight Plug; Body Style:Straight |
| HFBR2406HA | Circular Connector; No. of Contacts:16; Series:; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:20; Circular Contact Gender:Pin; Circular Shell Style:Straight Plug; Insert Arrangement:20-16 |
| HFBR1426HA | Low Cost, Miniature Fiber Optic Components with ST, SMA, SC and FC Ports |
| HFBR1426HB | CRYSTAL 4.9152 MHZ SMT 18PF |
| HFBR2426HB | Low Cost, Miniature Fiber Optic Components with ST, SMA, SC and FC Ports |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HFBR1412M | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:Low Cost, Miniature Fiber Optic Components with ST, SMA, SC and FC Ports |
| HFBR-1412M | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:Components is Designed to Provide cost effective, High performance fiber optic communication links |
| HFBR-1412-MT | 制造商:Rochester Electronics LLC 功能描述: 制造商:Avago Technologies 功能描述: |
| HFBR-1412PTZ | 制造商:Avago Technologies 功能描述:LOW COST STD PWR TX FO STT ESD+ - Bulk 制造商:Avago Technologies 功能描述:XMITTER FIBER OPTIC 制造商:Avago Technologies 功能描述:Fiber Optic Transmitters, Receivers, Transceivers LOW COST STD PWR TX FO STT ESD+ 制造商:Avago Technologies 功能描述:Low Cost Std Pwr Tx FO STT ESD+ |
| HFBR-1412PZ | 制造商:Avago Technologies 功能描述:LOW COST STD PWR TX FO ST ESD+ - Bulk 制造商:Avago Technologies 功能描述:XMITTER FIBER OPTIC 制造商:Avago Technologies 功能描述:Fiber Optic Transmitters, Receivers, Transceivers LOW COST STD PWR TX FO ST ESD+ |
發布緊急采購，3分鐘左右您將得到回復。