
HB28C048/032/016A6
64
Power on Reset Characteristics
All card status are reset automatically when V
CC
voltage goes over about 2.3 V.
Parameter
Symbol
Min
Typ
Max
Unit
Test conditions
-CE setup time
tsu(VCC)
100
—
—
ms
VCC rising up time
tpr
0.1
—
100
ms
Power on Reset Timing
t
pr
t
su(
v
cc)
V
cc
-CE1, -CE2
Attention for Card Use
In the reset or power off, all register informations are cleared.
All card status are cleared automatically when V
CC
voltage turns below about 2.5V.
Notice that the card insertion/removal should not be executed during host is active, if the card is used in
True IDE mode.
After the card hard reset, soft reset, or power on reset, ATA reset, command applied the card cannot
access during +RDY/-BSY pin is "low" level. Flash card can’t be operated in this case.
Card removal or power off should not be done during internal operations. When the removal or power off
occurred during internal operation, there is the possibility that data are lost.
Before the card insertion V
CC
can not be supplied to the card. After confirmation that -CD1, -CD2 pins are
inserted, supply V
CC
to the card.
-OE must be kept at the V
CC
level during power on reset in memory card mode and I/O card mode. -OE
must be kept constantly at the GND level in True IDE mode.