- 您現在的位置：買賣IC網 > PDF目錄370292 > FXC7000-48-S Distributed Power Front-End PDF資料下載
參數資料
| 型號： | FXC7000-48-S |
| 英文描述： | Distributed Power Front-End |
| 中文描述： | 分布式電源前端 |
| 文件頁數： | 2/4頁 |
| 文件大小： | 132K |
| 代理商： | FXC7000-48-S |
FXC7000 AC-DC Series Data Sheet
AUG 18, 2006 revised to JAN 09, 2007
Page 2 of 4
www.power-one.com
Output Specifications
PARAMETER
Output Voltage
Adjustment Range
Output Power
Output Current
Efficiency
Regulation
DESCRIPTION/CONDITIONS
An additional 1.0 Volt is provided to the output terminals to provide for
load lead losses.
Continuous duty rating.
Continuous duty rating.
Full rated load (208Vac).
Load, Maximum deviation with 0 to 100% load change:
MIN
45.6
NOM
48
MAX
50.4
UNITS
V
7000
145
Watts
A
%
88
91
With Remote Sense connected:
With Remote Sense not connected:
Utilizing Droop Current Share:
0.2
0.75
2.0
0.2
%
Line, Under all specified operating conditions.
Measured at mating connector w/ 0.01μF + 10μF Tant.
Ripple & Noise
20 MHz BW:
100 MHz BW:
1
2
0
% p-p
Overshoot / Undershoot
Minimum Loads
Transient Response
Output voltage overshoot/undershoot at turn-on.
Minimum loading required to maintain regulation.
Maximum recovery time, to within 1% of initial set
point due to a 25% load change, 1A/μS.
Time required for initial output voltage stabilization after power-up.
Time required for output voltage to rise from 10% to 90%.
%
A
μs
%
s
ms
0
Time:
800
3.2
3
100
Deviation:
Turn-On Delay
Turn-on Rise Time
Interface Signals and Internal Protection
PARAMETER
(NOTE 1,2)
AC Power Fail Warning
Auxiliary Power
DESCRIPTION/CONDITIONS
Warning provided prior to Vout dropping 5% after loss of AC input.
Output voltage - diode isolated. Inclusive of line, load, and initial tolerances.
Output current.
Monitor output current over a compliance range of 0~10V.
MIN
4
11.6
NOM
MAX
UNITS
ms
V
mA
12.0
12.4
500
Current Monitor
Normal output:
Total error current:
0.10
mA/A
mA
0.5
0.5
5
10
0.10
Current Share
Static sharing deviation as a percent of full-load rating
for loads >10%.
Maximum signal resistance in high input voltage range selection.
Warning provided prior to protective reduction in current limit.
Voltage required to enable supply (0.5 mA sink).
(NOTE 3)
Voltage required to enable supply (6 mA sink).
(NOTE 3)
Straight line current limit (above approx. 5V Vout).
Signal level on overload.
Occurs on overload when Vout is below approx. 5V.
May operate in burst-mode.
Deviation from adjusted Vout that is considered as a fault.
Output voltage swing available through Margin pin (analog).
Time between fault warning and shutdown.
Latching shutdown.
Latch style overvoltage protection.
Resistance to logic ground upon insertion of supply.
Maximum load lead loss compensation (round trip).
1) All logic outputs listed below feature a standard active pull-down output with 0.4V max at 40 mA sink capability, and a 100k pull-up to 5V.
2) In addition to those listed below, signals and front-panel LEDs are provided to indicate: overtemperature/fan fault, AC phase
imbalance, output good, interlock open, and supply inhibited. The FXP also provides 4 LED’s indicating output loading.
3)
Both signals must be pulled to logic ground for the unit to operate.
Enables are 100% redundant internally for applications where redundant inhibit is desirable.
Contact factory for additional design details.
Active:
Passive:
%
Input Range Select Status
Loss of Phase Warning
Output Inhibit
Output Interlock
Output Overload Protection
Output Overload Warning
Output Short Circuit Protection
500
ms
V
V
A
V
A
1.0
1.0
156
149
2.2
25
Iavg:
90
Output Voltage Fault Signal
Output Voltage Margin
Overtemperature/
Fan Failure Warning
Overvoltage Protection
Power Supply Present Signal
Remote Sense
NOTES:
±3
±4.8
100
±4
±5.0
±5
±5.2
%
%
ms
55.2
57.6
1000
60.0
V
1.0
V
相關PDF資料 |
PDF描述 |
|---|---|
| FXLDM-TTL-60T | Delay Line |
| FXLDM-TTL-700F | Delay Line |
| FXLDM-TTL-700G | Delay Line |
| FXLDM-TTL-700J | Delay Line |
| FXLDM-TTL-700T | Delay Line |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FXC7000-48-S134G | 制造商:Power-One 功能描述: |
| FXC751 | 制造商:EDSYN 功能描述: |
| FXC9C9-06 | 制造商:XP Power 功能描述:PSU 1000W 48V |
| FXC9C9-06 | 制造商:XP Power 功能描述:PSU 1000W 48V |
| FX-CH | 功能描述:BANK SELECT UNIT FOR NPN SENSORS 制造商:panasonic industrial automation sales 系列:- 零件狀態:有效 配件類型:* 配套使用產品/相關產品:* 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。