參數資料
型號: FT4232HL-TRAY
廠商: FTDI, Future Technology Devices International Ltd
文件頁數: 1/45頁
文件大?。?/td> 0K
描述: IC USB HS QUAD UART/SYNC 64-LQFP
標準包裝: 160
系列: USBmadeEZ-FIFO
特點: USB 至 UART 和(或)SPI、I2C、JTAG
通道數: 4,QUART
FIFO's: 2048 字節
規程: RS232,RS422,RS485
電源電壓: 3 V ~ 3.6 V
帶自動流量控制功能:
帶調制解調器控制功能:
帶CMOS:
安裝類型: 表面貼裝
封裝/外殼: 64-LQFP
供應商設備封裝: 64-LQFP(10x10)
包裝: 托盤
配用: 768-1031-ND - MOD USB HS FT4232H EVAL
其它名稱: FT4232HL - TRAY
Copyright 2010 Future Technology Devices International Limited
1
Document No.: FT_000060
FT4232H QUAD HIGH SPEED USB TO MULTIPURPOSE UART/MPSSE IC
Datasheet Version 2.2
Clearance No.: FTDI#78
Future Technology
Devices International Ltd
FT4232H Quad High Speed
USB to Multipurpose
UART/MPSSE IC
The FT4232H is FTDI’s 5th generation of
USB devices. The FT4232H is a USB 2.0
High Speed (480Mb/s) to UART/MPSSE
ICs. The device features 4 UARTs. Two of
these have an option to independently
configure an MPSSE engine. This allows
the FT4232H to operate as two UART/Bit-
Bang ports plus two MPSSE engines used
to emulate JTAG, SPI, I2C, Bit-bang or
other synchronous serial modes.
The
FT4232H has the following advanced
features:
Single chip USB to quad serial ports with a
variety of configurations.
Entire USB protocol handled on the chip. No
USB specific firmware programming required.
USB 2.0 High Speed (480Mbits/Second) and
Full Speed (12Mbits/Second) compatible.
Two Multi-Protocol Synchronous Serial Engine
(MPSSE) on channel A and channel B, to
simplify synchronous serial protocol (USB to
JTAG, I2C, SPI or bit-bang) design.
Independent Baud rate generators.
RS232/RS422/RS485 UART Transfer Data Rate
up to 12Mbaud. (RS232 Data Rate limited by
external level shifter).
FTDI’s royalty-free Virtual Com Port (VCP) and
Direct
(D2XX)
drivers
eliminate
the
requirement for USB driver development in
most cases.
Optional traffic TX/RX indicators can be added
with LEDs and an external 74HC595 shift
register.
Adjustable receive buffer timeout.
Support
for
USB
suspend
and
resume
conditions via PWREN#, SUSPEND# and RI#
pins.
Highly integrated design includes +1.8V LDO
regulator for VCORE, integrated POR function
and on chip clock multiplier PLL (12MHz –
480MHz).
FTDI FT232B style, asynchronous serial UART
interface option with full hardware handshaking
and modem interface signals.
Fully assisted hardware or X-On / X-Off
software handshaking.
UART Interface supports 7/8 bit data, 1/2 stop
bits, and Odd/Even/Mark/Space/No Parity.
Auto-transmit enable control for RS485 serial
applications using TXDEN pin.
Operational
configuration
mode
and
USB
Description strings configurable in external
EEPROM over the USB interface.
Low operating and USB suspend current.
Configurable I/O drive strength (4,8,12 or
16mA) and slew rate.
Supports bus powered, self powered and high-
power bus powered USB configurations.
UHCI/OHCI/EHCI host controller compatible.
USB Bulk data transfer mode (512 byte packets
in High Speed mode).
Dedicated Windows DLLs available for USB to
JTAG, USB to SPI, and USB to I2C applications.
+1.8V (chip core) and +3.3V I/O interfacing
(+5V Tolerant).
Extended -40°C to 85°C industrial operating
temperature range.
Compact 64-LD Lead Free LQFP or QFN
package
+3.3V single supply operating voltage range.
ESD protection for FT4232H IO’s:
Human Body Model (HBM) ±2kV,
Machine Mode (MM) ±200V,
Charge Device Model (CDM) ±500V,
Latch-up free.
Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced in any material or
electronic form without the prior written consent of the copyright holder. This product and its documentation are supplied on an as-is basis and no warranty as
to their suitability for any particular purpose is either made or implied. Future Technology Devices International Ltd will not accept any claim for damages
howsoever arising as a result of use or failure of this product. Your statutory rights are not affected. This product or any variant of it is not intended for use in
any medical appliance, device or system in which the failure of the product might reasonably be expected to result in personal injury. This document provides
preliminary information that may be subject to change without notice. No freedom to use patents or other intellectual property rights is implied by the
publication of this document. Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park, Glasgow G41 1HH United
Kingdom. Scotland Registered Company Number: SC136640
相關PDF資料
PDF描述
MS27484T12B98PA CONN PLUG 10POS STRAIGHT W/PINS
SC16C654DBIB64,157 IC QUAD UART 64BYTE 64LQFP
VI-B6D-IY CONVERTER MOD DC/DC 85V 50W
SCC2692AE1B44,528 IC UART DUAL W/FIFO 44PLCC
SC16C654BIEC,557 IC QUAD UART 64BYTE 64LFBGA
相關代理商/技術參數
參數描述
FT4232HMINIMODULE 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB to serial/FIFO development module 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB Hi-Speed FT4232H Evaluation Module
FT4232H-MINI-MODULE 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC,FT4323H EVALUATION MODULE;USB HI-SPEED
FT4232HQ 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB Hi-Speed to Quad Channel Serial UART/JTAG/SPI/I2C IC - QFN-64
FT4232HQ_MINI_MODULE 功能描述:界面開發工具 USB Hi-Speed FT4323H Evaluation Module RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
FT4232HQ-4000 制造商:FTDI 制造商全稱:FTDI 功能描述:QUAD HIGH SPEED USB TO MULTIPURPOSE UART/MPSSE IC