- 您現在的位置：買賣IC網 > PDF目錄11800 > FT245RQ-REEL (FTDI, Future Technology Devices International Ltd)IC USB TO PARALLEL FIFO 32-QFN PDF資料下載
參數資料
| 型號： | FT245RQ-REEL |
| 廠商： | FTDI, Future Technology Devices International Ltd |
| 文件頁數： | 15/37頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC USB TO PARALLEL FIFO 32-QFN |
| 產品培訓模塊： | USB Introduction |
| 標準包裝： | 1 |
| 應用： | USB 至 FIFO 控制器 |
| 接口： | USB，FIFO，（同步/異步） |
| 電源電壓： | 1.8 V ~ 5.25 V |
| 封裝/外殼： | 32-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 32-QFN 裸露焊盤（5x5） |
| 包裝： | 標準包裝 |
| 安裝類型： | 表面貼裝 |
| 產品目錄頁面： | 634 (CN2011-ZH PDF) |
| 配用： | 768-1020-ND - MOD USB PARALLEL FIFO DEV FT245R |
| 其它名稱： | 768-1012-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Copyright 2010 Future Technology Devices International Limited
22
Document No.: FT_000052
FT245R USB FIFO IC Datasheet Version 2.12
Clearance No.: FTDI# 39
7 USB Power Configurations
The following sections illustrate possible USB power configurations for the FT245R. The illustrations have
omitted pin numbers for ease of understanding since the pins differ between the FT245RL and FT245RQ
package options.
All USB power configurations illustrated apply to both package options for the FT245R device. Please refer
to Section 3 for the package option pin-out and signal descriptions.
7.1 USB Bus Powered Configuration
FT245R
GND
100nF
VCC
USBDM
USBDP
VCCIO
NC
RESET#
NC
OSCI
OSCO
3V3OUT
A
G
N
D
G
N
D
G
N
D
G
N
D
T
E
S
T
Vcc
1
2
3
4
GND
SHIELD
GND
VCC
100nF
4.7uF
+
5
10nF
Ferrite
Bead
D0
D1
D2
D3
D4
D5
D6
D7
RXF#
TXE#
RD#
WR
PWREN#
Vcc
10K
Figure 7.1 Bus Powered Configuration
Figure 7.1 illustrates the FT245R in a typical USB bus powered design configuration. A USB bus powered
device gets its power from the USB bus. Basic rules for USB bus power devices are as follows –
i)
On plug-in to USB, the device should draw no more current than 100mA.
ii)
In USB Suspend mode the device should draw no more than 2.5mA.
iii)
A bus powered high power USB device (one that draws more than 100mA) should use the
PWREN# to keep the current below 100mA on plug-in and 2.5mA on USB suspend.
iv)
A device that consumes more than 100mA cannot be plugged into a USB bus powered hub.
v)
No device can draw more than 500mA from the USB bus.
The power descriptors in the internal EEPROM of the FT245R should be programmed to match the current
drawn by the device.
A ferrite bead is connected in series with the USB power supply to reduce EMI noise from the FT245R and
associated circuitry being radiated down the USB cable to the USB host. The value of the Ferrite Bead
depends on the total current drawn by the application. A suitable range of Ferrite Beads is available from
Steward (www.steward.com), for example Steward Part # MI0805K400R-10.
Note: If using PWREN#, the pin should be pulled to VCCIO using a 10kΩ resistor.
相關PDF資料 |
PDF描述 |
|---|---|
| V48A12E500BG2 | CONVERTER MOD DC/DC 12V 500W |
| V48A12E500BF3 | CONVERTER MOD DC/DC 12V 500W |
| V48A12E500BF2 | CONVERTER MOD DC/DC 12V 500W |
| V48A12E500BF | CONVERTER MOD DC/DC 12V 500W |
| V48A12E500BL2 | CONVERTER MOD DC/DC 12V 500W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT245RQ-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:Single Chip USB Tray |
| FT24B3 031175 | 制造商:Comair Rotron 功能描述:FAN 120X120X25MM 24VDC |
| FT24B3-E2 | 制造商:Comair Rotron 功能描述:FAN FLIGHT II 120X120X25MM 24V |
| FT24B3-E2 | 制造商:Comair Rotron 功能描述:FAN FLIGHT II 120X120X25 24V |
| FT24C02A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Two-Wire Serial EEPROM |
發(fā)布緊急采購，3分鐘左右您將得到回復。