- 您現在的位置：買賣IC網 > PDF目錄1922 > FT232RL-REEL (FTDI, Future Technology Devices International Ltd)IC USB FS SERIAL UART 28-SSOP PDF資料下載
參數資料
| 型號： | FT232RL-REEL |
| 廠商： | FTDI, Future Technology Devices International Ltd |
| 文件頁數： | 19/43頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC USB FS SERIAL UART 28-SSOP |
| 產品培訓模塊： | USB Introduction USB-UART Interface Solutions |
| 標準包裝： | 1 |
| 系列： | USBmadeEZ-UART |
| 特點： | USB 至 UART |
| 通道數： | 1，UART |
| FIFO's： | 256 字節 |
| 規程： | RS232，RS422，RS485 |
| 電源電壓： | 3.3 V ~ 5.25 V |
| 帶自動流量控制功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 634 (CN2011-ZH PDF) |
| 配用： | 768-1023-ND - MOD USB RS232 DEV/EVAL FT232RL 768-1022-ND - MOD USB UART MINI B DEV FT232R 768-1021-ND - MOD USB UART MINI DEV FT232R 768-1019-ND - MOD USB UART DEV FT232R |
| 其它名稱： | 768-1007-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
Copyright 2010 Future Technology Devices International Limited
26
Document No.: FT_000053
FT232R USB UART IC Datasheet Version 2.10
Clearance No.: FTDI# 38
6.4 USB Bus Powered with Selectable External Logic Supply
FT232R
A
G
N
D
G
N
D
G
N
D
G
N
D
T
E
S
T
100nF
3V3OUT
VCCIO
NC
RESET#
NC
10nF
TXD
RXD
RTS#
CTS#
DTR#
DSR#
DCD#
RI#
CBUS0
CBUS3
CBUS2
CBUS1
USBDP
USBDM
VCC
1
2
3
4
5
OSCI
OSCO
CBUS4
Ferrite
Bead
+
SHIELD
GND
3.3V or 5V
Supply to
External Logic
100nF
+
100nF
Vcc
4.7uF
GND
1
Jumper
SLEEP#
PWREN#
2
3
Vcc
VCCIO
10K
VCCIO
Figure 6.4 USB Bus Powered with +3.3V or +5V External Logic Power Supply
Figure 6.4 illustrates a USB bus power application with selectable external logic supply. The external logic
can be selected between +3.3V and +5V using the jumper switch. This jumper is used to allow the
FT232R to be interfaced with a +3.3V or +5V logic devices. The VCCIO pin is either supplied with +5V
from the USB bus (jumper pins1 and 2 connected), or from the +3.3V output from the FT232R 3V3OUT
pin (jumper pins 2 and 3 connected). The supply to VCCIO is also used to supply external logic.
With bus powered applications, the following should be noted:
i)
To comply with the 2.5mA current supply limit during USB suspend mode, PWREN# or
SLEEP# signals should be used to power down external logic in this mode. If this is not
possible, use the configuration shown in Section 6.3.
ii)
The maximum current sourced from the USB bus during normal operation should not exceed
100mA, otherwise a bus powered design with power switching (Section 6.3) should be used.
Another possible configuration could use a discrete low dropout (LDO) regulator which is supplied by the
5V on the USB bus to supply between +1.8V and +2.8V to the VCCIO pin and to the external logic. In
this case VCC would be supplied with the +5V from the USB bus and the VCCIO would be supplied from
the output of the LDO regulator. This results in the FT232R I/O pins driving out at between +1.8V and
+2.8V logic levels.
For a USB bus powered application, it is important to consider the following when selecting the regulator:
i)
The regulator must be capable of sustaining its output voltage with an input voltage of
+4.35V. An Low Drop Out (LDO) regulator should be selected.
ii)
The quiescent current of the regulator must be low enough to meet the total current
requirement of <= 2.5mA during USB suspend mode.
A suitable series of LDO regulators that meets these requirements is the MicroChip/Telcom
(www.microchip.com) TC55 series of devices. These devices can supply up to 250mA current and have a
quiescent current of under 1μA.
相關PDF資料 |
PDF描述 |
|---|---|
| FT245BL-REEL | IC USB FS PARALLEL FIFO 32-LQFP |
| FT245RL-REEL | IC USB TO PARALLEL FIFO 28-SSOP |
| FT4232HQ-REEL | IC USB HS QUAD UART/SYNC 64-QFN |
| FUSB1500MHX | IC USB 2.0 TRANSCEIVER 16-MLP |
| FUSB2805MLX | TXRX USB2.0 HS OTG ULPI 32MLP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT232RL-TUBE | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB-to-UART 1-CH 256Byte FIFO 5V 28-Pin SSOP Tube 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB FS SERIAL UART 28-SSOP |
| FT232RQ | 制造商:Future Technology Devices International (FTDI Chip) 功能描述: 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB-to-UART 1-CH 256Byte FIFO 5V 32-Pin QFN EP 制造商:FTDI 功能描述: 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB TO UART SMD QFN-32 232 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO UART, SMD, QFN-32, 232 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB UART INTERFACE, 32-QFN, USB Type:USB UART, USB Version:-, Supply Voltage Min:3.3V, Supply Voltage Max:5.25V, Digital IC Case Style:QFN, No. of Pins:32, No. of Ports:1, Operating Temperature Min:-40C, MSL:-, Bandwidth:48MHz , RoHS Compliant: Yes 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO UART, SMD, QFN-32, 232, Bridge Type:USB to UART, Supply Voltage Min:1 |
| FT232RQ-6000 | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB UART IC - Single chip USB to asynchronous serial data transfer interface |
| FT232RQ-REEL | 功能描述:USB 接口集成電路 USB to Serial UART Enhanced IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| FT232RQ-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。