參數資料
型號: FT2232HL-REEL
廠商: FTDI, Future Technology Devices International Ltd
文件頁數: 27/67頁
文件大小: 0K
描述: IC USB HS DUAL UART/FIFO 64-LQFP
標準包裝: 1
系列: USBmadeEZ-FIFO,F(xiàn)T-X,X-Chip
特點: USB 至 UART 和(或)FIFO、SPI、I2C、JTAG
通道數: 2,DUART
FIFO's: 4096 字節
規程: RS232,RS422,RS485
電源電壓: 3 V ~ 3.6 V
帶并行端口:
帶自動流量控制功能:
帶調制解調器控制功能:
帶CMOS:
安裝類型: 表面貼裝
封裝/外殼: 64-LQFP
供應商設備封裝: 64-LQFP
包裝: 標準包裝
產品目錄頁面: 634 (CN2011-ZH PDF)
其它名稱: 768-1024-6
Copyright 2012 Future Technology Devices International Limited
33
Document No.: FT_000061
FT2232H DUAL HIGH SPEED USB TO MULTIPURPOSE UART/FIFO IC
Version 2.21
Clearance No.: FTDI#77
4.7 MCU Host Bus Emulation Mode
MCU host bus emulation mode uses both of the FT2232Hs A and B channel interfaces to make the chip
emulate a standard 8048/8051 MCU host bus. This allows peripheral devices for these MCU families to be
directly connected to USB via the FT2232H.
The lower 8 bits (AD7 to AD0) is a multiplexed Address / Data bus. A15 to A8 provide upper (extended)
addresses. There are 4 basic operations:-
1) Read (does not change A15 to A8)
2) Read Extended (changes A15 to A8)
3) Write (does not change A15 to A8)
4) Write Extended (changes A15 to A8)
MCU Host Bus Emulation mode is enabled using Set Bit Bang Mode driver command. A hex value of 8 will
enable it, and a hex value of 0 will reset the device. The FT2232H operates in the same way as the
FT2232D. See application note AN2232-02, “Bit Mode Functions for the FT2232D” for more details
and examples.
The MCU Host Bus Emulation Mode command set is fully described in application note AN_108 –
“Command Processor For MPSSE and MCU Host Bus Emulation Modes”.
When MCU Host Bus Emulation mode is enabled the IO signal lines on both channels work together and
the pins are configured as described in Table 3.11. The following sections give some details of the read
and write cycle waveforms and timings. The CLKOUT output clock can operate up to 60MHz.
In Host Bus Emulation mode the clock divisor has no effect. The clock divisor is used for serial data and is
a different part of the MPSSE block. In host bus emulation the 60MHz clock is always output and doesnt
change with any commands.
相關PDF資料
PDF描述
ATMEGA168P-20AUR MCU AVR 16K FLASH 20MHZ 32-TQFP
SC16IS750IPW,112 IC UART I2C/SPI 24-TSSOP
ATMEGA168PV-10MUR MCU AVR 16KB FLASH 10MHZ 32QFN
FT232BQ-REEL IC NEW DESIGNS REFER TO FT232RQ
ATMEGA168P-20MUR MCU AVR 16K FLASH 20MHZ 32-QFN
相關代理商/技術參數
參數描述
FT2232HL-TRAY 功能描述:USB 接口集成電路 USB HS to Dual UART/ FIFO/SPI/JTAG/I2C RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
FT2232HMINIMODULE 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB Hi-Speed FT2232H Evaluation Module 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB to serial/FIFO development module
FT2232H-MINI-MODULE 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC,EVALUATION MODULE;FT2232H;USB HI-SPEED
FT2232HQ 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB Hi-Speed to Dual Channel Serial UART/FIFO/JTAG/SPI/I2C IC - QFN-64
FT2232HQ_MINI_ MODULE 功能描述:界面開發工具 USB Hi-Speed FT2232H Evaluation Module RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V