參數資料
型號: FA5304AP
廠商: FUJI ELECTRIC CO LTD
元件分類: 穩壓器
英文描述: Bipolar IC For Switching Power Supply Control
中文描述: 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDIP8
封裝: DIP-8
文件頁數: 10/17頁
文件大?。?/td> 280K
代理商: FA5304AP
FA5304AP(S)/FA5305AP(S)
10
I
Design advice
1. Startup circuit
It is necessary to start-up IC that the voltage inclination of VCC
terminal “dVcc/dt” satisfies the following equation(4).
dVcc/dt(V/s)>1.8/(Cs(
μ
F)).................................(4)
Cs : capacitor connected between CS terminal and GND
Note that equation (4) must be satisfied in any condition. Also,
it is necessary to keep “l(fā)atch mode” for overload protection or
overvoltage protection that the current supplied to VCC
terminal through startup resistor satisfies the following
equation(5).
Icc(Lat)>0.4mA for Vcc
Icc(Lat): Cutoff-state(=Latch mode) supply current
9.2V.......................(5)
The detail is explained as follows.
(1) Startup circuit connected to AC line directly
Fig. 20 shows a typical startup circuit that a startup resistor Rc
is connected to AC line directly. The period from power-on to
startup is determined by Rc, R
D
and C
A
. Rc, R
D
and C
A
must
be designed to satisfy the following equations.
dVcc/dt(V/s)=
(1/C
A
) {(V
AVE
–Vccon )/R
C
–Vccon/R
D
–Iccst} >
1.8/(Cs(
μ
F)).....................................................(6)
Rc(k
)< (V
AVE
–9.2(V))/{0.4 (mA) + (9.2(V)/R
D
(k
) } ...........(7)
V
AVE
= Vac
E
2/
π
: Average voltage applied to AC line side of Rc
Vac:
AC input effective voltage
Vccon: ON threshold of UVLO, 16.5V(max.)
Iccst:
Standby current, 0.15 mA(max.)
In this method, Vcc voltage includes ripple voltage influenced
by AC voltage. Therefore, enough dVcc/dt required by
equation (6) tend to be achieved easily when Vcc reaches to
Vccon even if Vcc goes up very slowly.
After power-off, Vcc does not rise up because a voltage
applied from bias winding to VCC terminal decreases and the
current flowing R
C
becomes zero, therefore, re-startup does
not occur after Vcc falls down below OFF threshold of UVLO
until next power-on.
Fig. 20 Startup circuit example(1)
相關PDF資料
PDF描述
FA5304APS Bipolar IC For Switching Power Supply Control
FA5305AP Bipolar IC For Switching Power Supply Control
FA5305APS Bipolar IC For Switching Power Supply Control
FA5314P Bipolar IC For Switching Power Supply Control
FA5310 CAPACITOR,SMD 603,100PF,50V,5%
相關代理商/技術參數
參數描述
FA5304APS 制造商:FUJI 制造商全稱:Fuji Electric 功能描述:Bipolar IC For Switching Power Supply Control
FA5304AS 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC
FA5305 制造商:DigitHead Inc 功能描述:CUSTOM 48" S.O. CORD 18 AWG 2 CONDUCTOR WITH TYCO CONNECTOR P/N 350547-1 AND P/N
FA5305AP 制造商:FUJI 制造商全稱:Fuji Electric 功能描述:Bipolar IC For Switching Power Supply Control
FA5305APS 制造商:FUJI 制造商全稱:Fuji Electric 功能描述:Bipolar IC For Switching Power Supply Control