- 您現在的位置：買賣IC網 > PDF目錄16582 > EVAL-AD9832SDZ (Analog Devices Inc)BOARD EVAL FOR AD9832 PDF資料下載
參數資料
| 型號： | EVAL-AD9832SDZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR AD9832 |
| 標準包裝： | 1 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD9832
Data Sheet
Rev. E | Page 16 of 28
Table 11. Writing to the AD9832 Data Registers
D15
D14
D13
D12
D11
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
C3
C2
C1
C0
A3
A2
A1
A0
MSB
LSB
1
X = don’t care.
Table 12. Setting SYNC and SELSRC
D15
D14
D13
D12
D11
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
1
0
SYNC
SELSRC
1
X = don’t care.
Table 13. Power-Down, Resetting and Clearing the AD9832
D15
D14
D13
D12
D11
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
1
SLEEP
RESET
CLR
1
X = don’t care.
LATENCY
Associated with each operation is a latency. When inputs
FSELECT/PSEL change value, there is a pipeline delay before
control is transferred to the selected register; there is a pipeline
delay before the analog output is controlled by the selected
register. When times t11 and t11A are met, PSEL0, PSEL1, and
FSELECT have latencies of six MCLK cycles when SYNC = 0.
When SYNC = 1, the latency is increased to 8 MCLK cycles.
When times t11 and t11A are not met, the latency can increase by
one MCLK cycle. Similarly, there is a latency associated with
each write operation. If a selected frequency/phase register is
loaded with a new word, there is a delay of 6 to 7 MCLK cycles
before the analog output will change (there is an uncertainty of
one MCLK cycle regarding the MCLK rising edge at which the
data is loaded into the destination register). When SYNC = 1,
the latency is 8 or 9 MCLK cycles.
FLOWCHARTS
The flowchart in Figure 24 shows the operating routine for the
AD9832. When the AD9832 is powered up, the part should be
reset, which resets the phase accumulator to zero so that the
analog output is at full scale. To avoid spurious DAC outputs
while the AD9832 is being initialized, the RESET bit should be
set to 1 until the part is ready to begin generating an output.
Taking CLR high sets SYNC and SELSRC to 0 so that the
FSELECT/PSELx pins are used to select the frequency/phase
registers, and the synchronization circuitry is bypassed. A write
operation is needed to the SYNC/SELSRC register to enable the
synchronization circuitry or to change control to the FSELECT/
PSEL bits. RESET does not reset the phase and frequency registers.
These registers will contain invalid data and, therefore, should
be set to a known value by the user. The RESET bit is then set to 0
to begin generating an output. A signal will appear at the DAC
output 6 MCLK cycles after RESET is set to 0.
The analog output is fMCLK/232 × FREG, where FREG is the value
loaded into the selected frequency register. This signal is phase
shifted by the amount specified in the selected phase register
(2π/4096 × PHASEx REG, where PHASEx REG is the value
contained in the selected phase register).
Control of the frequency/phase registers can be interchanged
from the pins to the bits.
相關PDF資料 |
PDF描述 |
|---|---|
| RCM24DRPI | CONN EDGECARD 48POS DIP .156 SLD |
| RBM18DRMS | CONN EDGECARD 36POS .156 WW |
| RMM08DRKN | CONN EDGECARD 16POS DIP .156 SLD |
| CI100505-47NJ | INDUCTOR MULTI LAYER CHIP 47NH |
| RMM08DRKH | CONN EDGECARD 16POS DIP .156 SLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-AD9833EB | 制造商:AD 制造商全稱:Analog Devices 功能描述:+2.5 V to +5.5 V, 25 MHz Low Power CMOS Complete DDS |
| EVAL-AD9833EBZ | 制造商:Analog Devices 功能描述:Evaluation Board For IC Programmable Waveform Generator 制造商:Analog Devices 功能描述:PROGRAMMABLE WAVEFORM GENERATOR - Bulk |
| EVAL-AD9833SDZ | 功能描述:BOARD EVAL FOR AD9833 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:數字電位器 嵌入式:- 已用 IC / 零件:AD5258 主要屬性:- 次要屬性:- 已供物品:板 相關產品:AD5258BRMZ1-ND - IC POT DGTL I2C1K 64P 10MSOPAD5258BRMZ10-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ100-ND - IC POT DGTL I2C 100K 64P 10MSOPAD5258BRMZ50-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ1-R7-ND - IC POT DGTL I2C 1K 64P 10MSOPAD5258BRMZ10-R7-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ50-R7-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ100-R7-ND - IC POT DGTL I2C 100K 64P 10MSOP |
| EVAL-AD9834EB | 制造商:Analog Devices 功能描述:EVALUATION BOARD I.C. - Bulk |
| EVAL-AD9834EBZ | 制造商:Analog Devices 功能描述:Evaluation Kit For 20 MW Power, 2.3 V To 5.5 V, 75 MHz Complete DDS 制造商:Analog Devices 功能描述:EVAL KIT FOR 20 MW PWR, 2.3V TO 5.5 V, 75 MHZ COMPLETE DDS - Bulk |
發布緊急采購，3分鐘左右您將得到回復。