- 您現在的位置：買賣IC網 > PDF目錄5258 > EL5611IREZ-T7 (Intersil)IC AMP 6-CHAN R-R 60MHZ 24HTSSOP PDF資料下載
參數資料
| 型號： | EL5611IREZ-T7 |
| 廠商： | Intersil |
| 文件頁數： | 3/12頁 |
| 文件大小： | 0K |
| 描述： | IC AMP 6-CHAN R-R 60MHZ 24HTSSOP |
| 標準包裝： | 1,000 |
| 放大器類型： | 通用 |
| 電路數： | 6 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 75 V/µs |
| 增益帶寬積： | 32MHz |
| -3db帶寬： | 60MHz |
| 電流 - 輸入偏壓： | 2nA |
| 電壓 - 輸入偏移： | 3000µV |
| 電流 - 電源： | 2.5mA |
| 電流 - 輸出 / 通道： | 65mA |
| 電壓 - 電源，單路/雙路(±)： | 4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm）裸露焊盤 |
| 供應商設備封裝： | 24-HTSSOP |
| 包裝： | 帶卷 (TR) |
11
FN7355.1
August 3, 2005
Applications Information
Product Description
The EL5611 and EL5811 voltage feedback amplifiers are
fabricated using a high voltage CMOS process. They exhibit
rail-to-rail input and output capability, are unity gain stable
and have low power consumption (2.5mA per amplifier).
These features make the EL5611, and EL5811 ideal for a
wide range of general-purpose applications. Connected in
voltage follower mode and driving a load of 1k
, the EL5611
and EL5811 have a -3dB bandwidth of 60MHz while
maintaining a 75V/s slew rate. The EL5611 a six channel
amplifier, and the EL5811 an 8 channel amplifier.
Operating Voltage, Input, and Output
The EL5611and EL5811 are specified with a single nominal
supply voltage from 5V to 15V or a split supply with its total
range from 5V to 15V. Correct operation is guaranteed for a
supply range of 4.5V to 16.5V. Most EL5611 and EL5811
specifications are stable over both the full supply range and
operating temperatures of -40°C to +85°C. Parameter
variations with operating voltage and/or temperature are
shown in the typical performance curves.
The input common-mode voltage range of the EL5611 and
EL5811 extends 500mV beyond the supply rails. The output
swings of the EL5611 and EL5811 typically extend to within
100mV of positive and negative supply rails with load
currents of 5mA. Decreasing load currents will extend the
output voltage range even closer to the supply rails. Figure
27 shows the input and output waveforms for the device in
the unity-gain configuration. Operation is from ±5V supply
with a 1k
load connected to GND. The input is a 10VP-P
sinusoid. The output voltage is approximately 9.8VP-P.
Short Circuit Current Limit
The EL5611 and EL5811 will limit the short circuit current to
±180mA if the output is directly shorted to the positive or the
negative supply. If an output is shorted indefinitely, the power
dissipation could easily increase such that the device may
be damaged. Maximum reliability is maintained if the output
continuous current never exceeds ±65mA. This limit is set by
the design of the internal metal interconnects.
Output Phase Reversal
The EL5611 and EL5811 are immune to phase reversal as
long as the input voltage is limited from VS- -0.5V to VS+
+0.5V. Figure 28 shows a photo of the output of the device
with the input voltage driven beyond the supply rails.
Although the device's output will not change phase, the
input's overvoltage should be avoided. If an input voltage
exceeds supply voltage by more than 0.6V, electrostatic
protection diodes placed in the input stage of the device
begin to conduct and overvoltage damage could occur.
Power Dissipation
With the high-output drive capability of the EL5611 and
EL5811 amplifiers, it is possible to exceed the 125°C
'absolute-maximum junction temperature' under certain load
current conditions. Therefore, it is important to calculate the
maximum junction temperature for the application to
determine if load conditions need to be modified for the
amplifier to remain in the safe operating area.
The maximum power dissipation allowed in a package is
determined according to:
where:
TJMAX = Maximum junction temperature
TAMAX = Maximum ambient temperature
ΘJA = Thermal resistance of the package
PDMAX = Maximum power dissipation in the package
The maximum power dissipation actually produced by an IC
is the total quiescent supply current times the total power
supply voltage, plus the power in the IC due to the loads, or:
OUT
P
UT
IN
PUT
5V
10s
VS = ±5V, TA = 25°C, AV = 1, VIN = 10VP-P
FIGURE 27. OPERATION WITH RAIL-TO-RAIL INPUT AND
OUTPUT
1V
10s
VS = ±2.5V, TA = 25°C, AV = 1, VIN = 6VP-P
FIGURE 28. OPERATION WITH BEYOND-THE-RAILS INPUT
PDMAX
TJMAX TAMAX
–
Θ
JA
---------------------------------------------
=
PDMAX
ΣiV
[
S
ISMAX V
(
S+VOUTi )
ILOADi
×
–
+
×]
=
EL5611, EL5811
相關PDF資料 |
PDF描述 |
|---|---|
| PPTC332LJBN-RC | CONN FEMALE 66POS DL .1" R/A TIN |
| EL5611IREZ-T13 | IC AMP 6-CHAN R-R 60MHZ 24HTSSOP |
| NPPC232KFMS-RC | CONN FMALE 46POS DL .1" GOLD SMD |
| 0741621410 | CONN RCPT R/A 10POS 2.54MM GOLD |
| TA45-ABDBP130C0-AZM01 | CIRCUIT BRKR ROCKER 13A 2POLE QC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL561R | 制造商:TTi-Thurlby Thandar Instruments 功能描述:Bulk 制造商:Aim & Thurlby Thandar Instruments 功能描述:PSU 56V 1A 制造商:Aim & Thurlby Thandar Instruments 功能描述:PSU, 56V 1A |
| EL5623 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Multi-Channel Buffer |
| EL5623IRZ | 功能描述:IC BUFFER MULTI CHANNEL 16-TSSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| EL5623IRZ-T13 | 功能描述:IC BUFFER 6XGAMMA 16-TSSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| EL5623IRZ-T7 | 功能描述:IC BUFFER 6XGAMMA 16-TSSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。